Philips S3540 User manual

S3540, S3530, SS3520, S3510, S3130, S3120, S3110
Questo manuale d’istruzione è fornito da trovaprezzi.it. Scopri tutte le offerte per Philips Shaver Series 3000
S3110/06 o cerca il tuo prodotto tra le migliori offerte di Cura della Persona

1
7
8
9
2
3
4
5
6
11
10

empty page before TOC

English 6
Dansk 24
Deutsch 40
Español 61
Français 79
Italiano 100
Nederlands 121
Norsk 140
Português 156
Suomi 173
Svenska 189
Türkçe 205
Ελληνικα 221

English
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
1 Click-on stubble cap (S3520, S3510 only)
2 Shaving unit
3 Shaving unit release button
4 On/off button
5 Shaving head symbol
6 Charging light
7 Protection cap
8 Trimmer (S3540, S3530, S3520, S3510 only)
9 Trimmer release slidez (S3540, S3530, S3520,
S3510 only)
10 Supply unit (adapter, type HQ8505)
11 Small plug
Important safety information
Read this important information carefully before
you use the appliance and its accessories and save
it for future reference. The accessories supplied
may vary for different products.
Danger
- Keep the supply unit dry.
6English

Warning
- To charge the battery, only use the
detachable supply unit (type HQ8505)
provided with the appliance.
- The supply unit contains a transformer. Do
not cut off the supply unit to replace it with
another plug, as this causes a hazardous
situation.
- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not play
with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
- Always unplug the shaver before you clean
it under the tap.
- Always check the appliance before you use
it. Do not use the appliance if it is damaged,
as this may cause injury. Always replace a
damaged part with one of the original type.
7
English

- Do not open the appliance to replace the
rechargeable battery.
Caution
- Never immerse the cleaning
system or the charging stand in
water and do not rinse it under
the tap.
- Never immerse the shaver in
water. Do not use the shaver in
the bath or in the shower.
- Never use water hotter than
60°C to rinse the shaver.
- Only use this appliance for its
intended purpose as shown in
the user manual.
- For hygienic reasons, the
appliance should only be used
by one person.
- Never use compressed air,
scouring pads, abrasive
cleaning agents or aggressive
liquids such as petrol or
acetone to clean the appliance.
8English

- If your shaver comes with a
cleaning system, always use the
original Philips cleaning fluid
(cartridge or bottle, depending
on the type of cleaning system).
- Always place the cleaning
system on a stable, level and
horizontal surface to prevent
leakage.
- If your cleaning system uses a
cleaning cartridge, always make
sure the cartridge compartment
is closed before you use the
cleaning system to clean or
charge the shaver.
- When the cleaning system is
ready for use, do not move it to
prevent leakage of cleaning
fluid.
9
English

- Water may drip from the socket
at the bottom of the shaver
when you rinse it. This is normal
and not dangerous because all
electronics are enclosed in a
sealed power unit inside the
shaver.
- Do not use the supply unit in or
near wall sockets that contain
an electric air freshener to
prevent irreparable damage to
the supply unit.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
- This shaver can be safely cleaned under the
tap.
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Charging
It takes approx. 1 hour (S3540, S3530, S3520,
S3510) or 8 hours (S3130, S3120, S3110) to fully
charge the appliance. When you charge the
appliance for the first time or after a long period of
10 English

disuse, let it charge until the charging light lights up
continuously. A fully charged appliance provides
up to 50 minutes (S3540, S3530, S3520, S3510) or
45 minutes (S3130, S3120, S3110) of shaving time.
The shaving time may be less than 50 or 45
minutes as a result of your shaving behavior, your
cleaning habits or your beard type.
Charging with the adapter
1
2
1Put the small plug in the appliance.
2Put the supply unit in the wall socket.
- The charging light shows the charging status of
the appliance (see section ‘Charge indications’
in this chapter).
3After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Charge indications
Battery low
- When the battery is almost empty (when there
are only 5 or fewer shaving minutes left), the
charging light starts to flash orange.
- When you switch off the appliance, the charging
light continues to flash orange for a few
seconds.
Quick charging
When you start charging the empty battery, the
charging light alternately flashes orange and green.
After approx. 3 minutes the charging light starts
flashing green only. The appliance now contains
enough energy for a 5-minute shave.
11
English

Charging
- When the appliance is charging, the charging
light flashes green.
Battery fully charged
- When the battery is fully charged, the charging
light lights up green continuously.
Note: After approx. 30 minutes, the charging light
goes out to save energy.
Using the appliance
Note: This appliance can be used without cord or
when it is connected to the wall socket.
Shaving tips and tricks
- Make circular movements during use. Circular
movements provide better shaving results than
straight movements.
- Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
Switching the appliance on and off
1To switch on the appliance, press the on/off
button once.
2To switch off the appliance, press the on/off
button once.
Shaving
1Switch on the appliance.
12 English

2Move the shaving heads over your skin in
circular movements.
3After shaving, switch off the appliance.
4Clean the appliance (see chapter ‘Cleaning and
maintenance’).
Trimming (S3540, S3530, S3520, S3510 only)
You can use the trimmer to groom your sideburns
and moustache.
1Push the trimmer release slide downwards to
open the trimmer.
2Switch on the appliance.
- You can now start trimming.
3After trimming, switch off the appliance.
4Clean the trimmer (see chapter ‘Cleaning and
maintenance’).
5Close the trimmer (‘click’).
Trimming with click-on stubble cap (S3520, S3510 only)
You can use the click-on stubble cap to trim your
beard to a length of a 3 day beard or to maintain a
1mm stubble look.
- For best trimming results with the click-on
stubble cap, hair and skin should be dry.
- The maximum beard length for using the click-on
13
English

stubble cap is a 7 day beard.
- The click-on stubble cap is for trimming above
the neck line only.
1Place the click-on stubble cap on the
appliance.
2To switch on the appliance, press the on/off
button once.
3Gently press the appliance to your skin. Make
both straight and circular movements to
achieve the best result.
4To switch off the appliance, press the on/off
button once.
5Pull off the stubble cap from the appliance.
6Clean the appliance and the click-on stubble
cap after each use.
Cleaning and maintenance
Danger: Remove the detachable cord
from the handheld part before cleaning
this part in water.
Caution: Never use compressed air, scouring
pads, abrasive cleaning agents or aggressive
14 English

liquids such as petrol or acetone to clean the
appliance.
- Clean the appliance after every shave for
optimal shaving performance.
- Regular cleaning guarantees better shaving
performance.
- Be careful with hot water. Always check if the
water is not too hot, to prevent your hands from
getting burnt.
Note: Water may leak from the socket at the
bottom of the appliance when you rinse it. This is
normal and not dangerous because all electronics
are enclosed in a sealed power unit inside the
shaver.
Cleaning the shaving unit under the tap
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Press the release button to open the shaving
unit. Rinse the inside of the shaving unit and
the hair chamber under a hot tap for 30
seconds.
- Rinse the outside of the shaving unit.
3Close the shaving unit and shake off excess
water.
Caution: Be careful not to hit the shaving unit
against anything while you shake off excess
water.
Caution: Never dry the shaving unit and the hair
chamber with a towel or tissue, as this may
damage the shaving unit.
4Open the shaving unit again and leave it open
to let the appliance dry completely.
15
English

Thorough cleaning
Clean the shaving heads thoroughly once a month
for optimal performance.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Press the release button to open the shaving
unit. Pull the shaving unit off the appliance.
2
1
3Turn the lock anticlockwise and remove the
retaining frame.
4Remove and clean one shaving head at a time.
Each shaving head consists of a cutter and a
guard.
Note: Do not clean more than one cutter and
guard at a time, since they are all matching sets.
If you accidentally mix up the cutters and
guards, it may take several weeks before
optimal shaving performance is restored.
- Remove the cutter from the shaving guard and
clean both parts under the tap.
16 English

5Put the cutter back into the guard.
6Put the shaving heads back into the shaving
unit.
Note: Make sure that the projections of the
shaving heads fit exactly into the recesses of
the shaving head holder.
1
2
7Put the retaining frame back into the shaving
unit and turn the lock clockwise.
8Insert the lug of the shaving unit into the slot in
the top of the appliance. Then close the shaving
unit ('click').
Note: If the shaving unit does not close
smoothly, check if you have inserted the
shaving heads properly and if the retaining
frame is locked.
Cleaning the trimmer under the tap (S3520, S3510
only)
Clean the trimmer every time you have used it.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
17
English

2Push the trimmer release slide downwards to
open the trimmer.
3Switch on the appliance and clean the trimmer
under the tap.
4Switch off the appliance and leave the trimmer
open to let it dry.
5Close the trimmer (‘click’).
Tip: For optimal trimming performance, lubricate
the trimmer teeth with a drop of sewing machine
oil every six months.
Cleaning the click-on stubble cap (S3520, S3510 only)
Clean the click-on stubble cap after every trim for
optimal performance.
Be careful with hot water. Always check if the
water is not too hot, to prevent burning your
hands.
Never dry the stubble cap with a towel or tissue,
as this may damage the stubble cap.
1Remove the stubble cap from the appliance.
18 English

2Rinse the stubble cap under a warm tap.
3Carefully shake off excess water and let the
stubble cap air dry.
Storage
Note: We advise you to let the appliance dry
before you put the protection cap on it.
Put the protection cap on the appliance to prevent
damage.
Replacement
2yrs
For maximum shaving performance, we advise you
to replace the shaving heads every two years.
Replace damaged shaving heads immediately.
Always replace the shaving heads with original
Philips shaving heads' (see 'Ordering accessories').
Replacement reminder
The shaving unit symbol will light up to indicate
that the shaving heads need to be replaced.
19
English

1The shaving unit symbol lights up orange
continuously.
2Switch off the appliance and make sure it is
disconnected from the wall socket.
3Press the release button to open the shaving
unit. Pull the shaving unit off the appliance.
2
1
4Turn the lock anticlockwise and remove the
retaining frame.
5Remove the shaving heads from the shaving
unit and throw them away.
6Place new shaving heads in the shaving unit.
Note: Make sure that the projections of the
shaving heads fit exactly into the recesses of
the shaving head holder.
1
2
7Put the retaining frame back into the shaving
unit and turn the lock clockwise.
20 English