Philips S3000 Series User manual

S3000 Series

2
1
3
9
12
13
11
5 6
4
7
10
8

empty page before TOC

English 6
Deutsch 27

English
Contents
General description (Fig. 1)_______________________________________ 6
Introduction_______________________________________________________ 7
Important safety information_____________________________________ 7
The display________________________________________________________ 10
Charging___________________________________________________________ 12
Using the appliance______________________________________________ 13
Shaving____________________________________________________________ 14
Trimming__________________________________________________________ 16
Cleaning and maintenance_______________________________________ 17
Replacement______________________________________________________ 21
Storage____________________________________________________________ 22
Ordering accessories_____________________________________________ 22
Recycling__________________________________________________________ 23
Removing the rechargeable shaver battery_____________________ 23
Warranty and support____________________________________________ 25
General description (Fig. 1)
1 Protection cap
2 Shaving unit
3 Shaving unit release button
4 On/off button
5 1-Level battery status indicator (S3133,
S3134only)
6 3-Level battery status indicator (S3233, S3332,
S3333 only)
7 Socket for small plug
8 Charging stand (S3332, S3333 only)
9 Pop-up trimmer
10 Trimmer release slide
11 Supply unit
12 Small plug
13 Storage pouch (S3232, S3332, S3333 only)
6English

Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
Important safety information
Read this important information carefully before
you use the appliance and save it for future
reference.
Danger
- Keep the supply unit dry.
Warning
- To charge the battery, only use the
detachable supply unit (type HQ8505)
provided with the appliance.
- The supply unit contains a transformer. Do
not cut off the supply unit to replace it with
another plug, as this causes a hazardous
situation.
7
English

- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not play
with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
- Always unplug the shaver before you clean
it under the tap.
- Always check the appliance before you use
it. Do not use the appliance if it is damaged,
as this may cause injury. Always replace a
damaged part with one of the original type.
- Do not open the appliance to replace the
rechargeable battery.
Caution
- This appliance contains batteries that are
non-replaceable.
8English

- Never immerse the charging
stand in water and do not rinse
it under the tap.
- Never use water hotter than
60°C to rinse the shaver.
- Only use this appliance for its
intended purpose as shown in
the user manual.
- For hygienic reasons, the
appliance should only be used
by one person.
- Never use compressed air,
scouring pads, abrasive
cleaning agents or aggressive
liquids such as petrol or
acetone to clean the appliance.
- Water may drip from the socket
at the bottom of the shaver
when you rinse it. This is normal
and not dangerous because all
electronics are enclosed in a
sealed power unit inside the
shaver.
9
English

- Do not use the supply unit in or
near wall sockets that contain
an electric air freshener to
prevent irreparable damage to
the supply unit.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
- This shaver is waterproof. It is suitable for use in
the bath or shower and for cleaning under the
tap. For safety reasons, the shaver can
therefore only be used without cord.
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
The display
S3133, S3134
Battery fully charged
When the battery is fully charged, the charging
light lights up white continuously.
Note: After approx. 30 minutes, the charging light
goes out to save energy.
10 English

Battery low
=
When the battery is almost empty, the charging
light flashes orange.
When you switch off the appliance, the charging
light continues to flash orange for a few seconds.
Charging
When the shaver is charging, the charging light
flashes white.
S3232, S3332, S3333
Battery fully charged
When the battery is fully charged, all charging
lights light up white continuously.
Note: After approx. 30 minutes, the charging lights
go out to save energy.
Battery low
=
When the battery is almost empty, the bottom
charging light flashes orange.
When you switch off the appliance, the bottom
charging light continues to flash orange for a few
seconds.
11
English

Charging
When the shaver is charging, first the bottom light
of the battery charge indicator flashes, then the
second light, and so on until the shaver is fully
charged.
When the appliance is charging, first the bottom
light flashes, then the middle light, and so on until
the appliance is fully charged.
Charging
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty.
Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 60 minutes.
This shaver is suitable for use in the bath or
shower. For safety reasons, it is therefore
not possible to use the shaver while it is
connected to the power outlet for charging.
Note: Depending on your shaving/styling behavior
and beard type, the operating time may vary over
time.
Charging with the supply unit
1Put the small plug in the appliance.
2Put the supply unit in the wall socket.
- The charging light shows the charging status of
the appliance.
12 English

3After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Charging with charging stand (S3332, S3333 only)
1Connect the small plug of the cord into the
charging stand. Connect the supply unit into
any 100V to 240V outlet. Use only the power
cord provided.
2Place the shaver in the stand in an upright
position making sure charging contacts in the
bottom of stand fit into recess in bottom of the
shaver.
- The display on the shaver will indicate the
shaver is charging.
3After charging, remove the shaver from the
stand by lifting straight up. Do not tilt the
shaver.
Quick charge
When you start charging the empty battery, the
charging light flashes white quickly. After approx. 5
minutes the charging light flashes white slowly. The
shaver now contains enough energy for a
5-minute shave.
Using the appliance
Note: This appliance is waterproof. It is suitable for
use in the bath or shower and for cleaning under
the tap. For safety reasons, this appliance can
therefore only be used without cord.
13
English

This symbol indicates that the shaver can be used
in the bath or shower.
Shaving tips and tricks
- Make circular movements during use. Circular
movements provide better shaving results than
straight movements.
- Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
Switching the appliance on and off
To switch the appliance on or off, press the on/off
button once.
Shaving
Dry shaving
Note: For the best results on skin comfort, pre-
trim your beard if you have not shaved for 3
days or longer.
1Switch on the appliance.
14 English

2Move the shaving heads over your skin in
circular movements to catch all hairs growing in
different directions.
3Stretch your skin with your free hand so the
blades can lift and cut hair. Gently press the
shaver onto you skin so the floating heads can
follow the contours of your face.
Note: Do not press too hard as too much
pressure can cause shaving heads to pinch the
skin.
4Switch off and clean the appliance after each
use.
5Put the protective cap on the appliance to
protect the shaving heads during storage and
travel.
Wet shaving
For a more comfortable shave, you can also use
this appliance on a wet face with shaving foam or
shaving gel.
1Apply some water to your skin.
2Apply shaving foam or gel to your skin.
15
English

3Rinse the shaving unit under the tap to ensure
that it glides smoothly over your skin.
4Switch on the appliance.
5Move the shaving heads over your skin in
circular movements to catch all hairs growing in
different directions. Make sure each shaving
head is fully in contact with the skin. Exert
gentle pressure for a close, comfortable shave.
Note: Do not press too hard, this can cause skin
irritation.
Note: Rinse the shaving unit regularly to ensure
that it continues to glide smoothly over your
skin.
6Switch off and clean the appliance after each
use.
7Dry your face.
Note: Make sure that you rinse all foam or
shaving gel off the appliance with warm water.
8Put the protective cap on the appliance to
protect the shaving heads during storage and
travel.
Trimming
You can use the trimmer to groom your sideburns
and moustache.
1Push the trimmer release slide downwards to
open the trimmer.
2Switch on the appliance.
16 English

3Hold the trimmer perpendicular to the skin and
move the appliance downwards while you exert
gentle pressure.
4Switch off and clean the trimmer after each use.
5Close the pop-up trimmer (‘click’).
Cleaning and maintenance
Cleaning the shaver
Caution: Never use compressed air, scouring
pads, abrasive cleaning agents or aggressive
liquids such as petrol or acetone to clean the
appliance.
Clean the shaver after every use for optimal
performance (see 'Cleaning and maintenance').
Caution: While rinsing the shaving heads, water
may drip out of the base of the appliance. This is
a normal occurrence. Internal electric parts are in
a waterproof compartment so the appliance will
be protected against water damage.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Press the release button to open the shaving
unit.
3Rinse the shaving unit and hair chamber with
lukewarm water.
17
English

4Rinse the outside of the shaving unit with
lukewarm water.
Never dry the shaving unit with a towel or
tissue, as this may damage the shaving heads.
5Carefully shake off excess water and let air dry
completely.
6Close the shaving unit.
Cleaning the pop-up trimmer
Clean the pop-up trimmer after each use.
Never dry the trimmer teeth with a towel or
tissue, as this may damage the trimmer teeth.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Push the trimmer release slide downwards to
open the trimmer.
3Switch on the appliance and rinse the pop-up
trimmer with warm water.
4After cleaning, switch off the appliance.
5Carefully shake off excess water and let the
pop-up trimmer air dry.
6Close the pop-up trimmer (‘click’).
Tip: For optimal performance, lubricate the teeth
of the pop-up trimmer with a drop of mineral oil
every six months (oil not included).
18 English

Thorough cleaning
Clean the shaving heads thoroughly once a month
for optimal performance.
1Switch off the appliance and make sure it is
disconnected from the wall socket.
2Press the release button to open the shaving
unit. Pull the shaving unit off the appliance.
2
1
3Turn the lock anticlockwise (1) and remove the
retaining frame (2). Place it aside in a safe place.
4Remove and clean one shaving head at a time.
Each shaving head consists of a cutter and a
guard.
Note: Do not clean more than one cutter and
guard at a time, since they are all matching sets.
If you accidentally mix up the cutters and
guards, it may take several weeks before
optimal shaving performance is restored.
5Remove the cutter from the shaving guard and
clean both parts under the tap.
19
English

6Put the cutter back into the guard.
7Put the shaving heads back into the shaving
unit.
1
2
8Put the retaining frame back into the shaving
unit (1) and turn the lock clockwise (2).
9Insert the hinge of the shaving unit into the slot
in the top of the shaver. Then close the shaving
unit.
Note: If the shaving unit does not close
smoothly, check if you have inserted the
shaving heads properly and if the retaining
frame is locked.
20 English