Philips HP6481 User manual

HP6481

2

3
A
F
H
I
K
G
B
C
D
E
J
1

4

HP6481
ENGLISH 6
DANSK 15
DEUTSCH 24
SUOMI 34
FRANÇAIS 42
ITALIANO 51
NEDERLANDS 60
NORSK 69
SVENSKA 77

6
Introduction
Congratulations on your purchase and welcome to Philips! To fully benet
from the support that Philips offers, register your product at www.philips.
com/welcome.
With your new Satinelle ICE you can remove unwanted hairs quickly,
easily and effectively.The combination of the ceramic epilating system, the
cooling glove and the massaging system constitutes a revolution in
epilation.Thanks to the natural numbing effect of ice and massaging, the
Satinelle ICE makes epilation more comfortable and less painful than ever.
The result is a silky-smooth skin and a hair growth reduction of up to
50%, assuming you use the appliance regularly (every 4 weeks).
The rapidly rotating epilating discs catch even the shortest hairs (down to
0.5 millimetre) and pull them out by the roots.As a result, your skin stays
smooth for up to four weeks and regrowth is soft and downy.
General description (Fig. 1)
AMassaging element
BEpilating head
CRelease button
DOn/off slide
ESocket for small plug
FCleaning brush
GAdapter
HCooling glove
IIce gel pad
JPeeling glove
KLuxury storage bag
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
Danger
Keep the appliance and the adapter dry.-
ENGLISH

Warning
Check if the voltage indicated on the adapter corresponds to the
local mains voltage before you connect the appliance.
Only use the appliance in combination with the adapter supplied.
Do not use the appliance if the adapter or the appliance itself is
damaged.
If the adapter is damaged, always have it replaced with one of the
original type in order to avoid a hazard.
The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
Caution
Do not expose the appliance to temperatures lower than 5°C or
higher than 35°C.
To prevent damage and injuries, keep the running appliance away
from scalp hair, eyebrows, eyelashes, clothes, threads, cords, brushes
etc.
Do not use the appliance on irritated skin or skin with varicose veins,
rashes, spots, moles (with hairs) or wounds without consulting your
doctor rst. People with a reduced immune response, or people who
suffer from diabetes mellitus, haemophilia or immunodeciency
should also consult their doctor rst.
Your skin may become a little red and irritated the rst few times you
use the epilator.This phenomenon is normal and quickly disappears.
As you use the appliance more often, your skin gets used to epilation,
skin irritation decreases and regrowth becomes thinner and softer. If
the irritation has not disappeared within three days, we advise you to
consult a doctor.
-
-
-
-
-
-
-
-
-
-
-
ENGLISH 7

Always check the shaving head before you use the appliance. Do not
use the shaving head if the foil or the trimmers are damaged, as this
may cause injury.
Electromagnetic elds
This Philips appliance complies with all standards regarding
electromagnetic elds (EMF). If handled properly and according to the
instructions in this user manual, the appliance is safe to use based on
scientic evidence available today.
Preparing for use
Freezing the ice gel pad
Read these instructions carefully before you use the cooling
glove (Fig. 2).
Keep the ice gel pad out of the reach of children (Fig. 3).
Do not use a damaged ice gel pad (Fig. 4).
Do not use the ice gel pad if you are hypersensitive to cold.
1 Put the ice gel pad without the cooling glove in the freezer or
freezing compartment (***) at least 2 hours before you start to
epilate. (Fig. 5)
Make sure the outside of the ice gel pad is completely dry before you
freeze it.
Tip:You can store the ice gel pad in the freezer permanently.
Using the appliance
General information about epilation
Epilation is easier just after a bath or shower. Make sure your skin is
completely dry when you start to epilate.
When you use the appliance for the rst time, we advise you to try it
out on an area with only light hair growth.This helps you get
accustomed to the epilation process.
-
-
-
-
ENGLISH8

For optimal epilation results, the hairs should not be longer than
10mm. Use one of the following methods if the hairs are longer than
10mm:
1 Shorten the hairs to a maximum length of 10mm with a trimmer.
Afterwards you can immediately start with epilation.
2 Shave the hairs completely. Then you can start to epilate after a few
days (minimum hair length 0.5mm necessary).
Your skin may become a little red and irritated the rst few times you
use the epilator.This phenomenon is absolutely normal and quickly
disappears.As you use the appliance more often, your skin gets used
to epilation, skin irritation decreases and regrowth becomes thinner
and softer. If the irritation has not disappeared within three days, we
advise you to consult a doctor.
We advise you to epilate before you go to bed at night, as this allows
any skin irritation that may develop to diminish overnight.
Epilating with the cooling glove
Make sure your skin is clean, entirely dry and free from grease. Do not
use any cream before you start to epilate.
1 Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
2 Put the ice gel pad in the compartment of the cooling glove with
the transparent cover (Fig. 6).
Only use the ice gel pad in combination with the cooling glove.
3 Push your hand into the cooling glove and start cooling the area
you want to epilate (Fig. 7).
Do not leave the cooling glove on the same area for more than 2
minutes.
4 Select the desired speed to switch on the appliance (Fig. 8).
Select speed 1 for areas with little hair growth and for areas where
bones are located directly beneath the skin, such as knees and ankles.
Select speed 2 for larger areas with stronger hair growth.
-
-
-
-
-
ENGLISH 9

5 Stretch your skin with your free hand to make the hairs stand
upright.
6 For optimal results, place the appliance perpendicularly onto the
skin with the on/off slide pointing forward. Move the
appliance against the direction of hair growth at a moderate
speed (Fig. 9).
Make sure both the epilating discs and the massaging element are in
proper contact with the skin.
Make sure your skin is completely dry when you start to epilate.
7 Press the appliance lightly onto the skin.
If you are not completely satised with the epilation result, try moving the
epilator more slowly over your skin.
Epilating without cooling glove
If you do not want to use the cooling glove, for instance because you
have grown accustomed to the sensation of epilation, you can also use
the appliance without the cooling glove.
1 For optimal results, place the appliance perpendicularly onto the
skin with the on/off slide pointing forward.Then move the appliance
against the direction of hair growth at a moderate speed (Fig. 9).
Using the peeling glove
Use the peeling glove in the shower.
Regular massages with the peeling glove may help to prevent ingrown
hairs. Do not use the body puff immediately before or after epilation.
Cleaning and maintenance
Never rinse the adapter or the appliance itself with water.
Do not use any corrosive detergents, scouring pads or cloths, petrol,
acetone etc. to clean the appliance.
Cleaning the cooling glove
1 Make sure the appliance is switched off and unplugged.
ENGLISH10