Philips Satinelle Soft HP6407 User manual

Satinelle Soft
HP6407/02

2

3

4

ENGLISH 6
POLSKI 11
ROMÂNĂ 16
РУССКИЙ 21
ČESKY 27
MAGYAR 32
SLOVENSKY 37
УКРАЇНСЬКА 42
HRVATSKI 48
EESTI 53
LATVISKI 58
LIETUVIŠKAI 63
SLOVENŠČINA 68
БЪЛГАРСКИ 73
SRPSKI 79
84
HP6407/02

Introduction
With your new epilator you can remove unwanted hair quickly, easily
and effectively. It is particularly suitable for removing hair from your legs.
The rotating discs catch even the shortest hairs (down to 0.5mm) and
pull them out by the root.The hairs that grow back are soft and thin.
Epilating with this new appliance leaves your skin smooth and hair-free
for several weeks.
General description (fig. 1)
AMassage attachment
BEpilating discs
CEpilating head
DOn/off slide
O = off
I = normal speed
II = high speed
ESocket for appliance plug
FAdapter
GBrush
Important
Read these instructions for use carefully before using the appliance and
save them for future reference.
◗Check if the mains voltage indicated on the appliance
corresponds to the local mains voltage before you connect the
appliance.
◗Only use the appliance in combination with the adapter supplied.
◗Do not use the appliance if the adapter or the appliance itself is
damaged.
◗If the adapter is damaged, always have it replaced by one of the
original type in order to avoid a hazard.
◗The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this will cause a hazardous
situation.
ENGLISH6

◗Keep the appliance and the adapter dry.
◗Do not use the appliance near or over a washbasin or bath filled
with water.
◗Do not use the appliance in the bath or in the shower.
◗If you use the appliance in the bathroom, do not use an extension
cord.
◗Keep the appliance out of the reach of children.
◗To prevent damage and injuries, keep the running appliance away
from your scalp hair, eyebrows, eyelashes, clothes, threads, cords,
brushes etc.
◗Do not use the epilating head on irritated skin or skin with
varicose veins, rashes, spots, moles (with hairs) or wounds
without consulting your doctor first. People with a reduced
immune response, or people who suffer from diabetes mellitus,
haemophilia or immunodeficiency should also consult their
doctor first.
◗Your skin may become a little red and irritated the first few times
you use the epilator.This phenomenon will soon disappear as
your skin becomes used to epilation and the hairs become
thinner and softer. If the irritation does not disappear within
three days, we advise you to consult a doctor.
◗Regular massages with a loofah may help to prevent ingrowing
hairs. Do not use the loofah immediately before or after
epilation.
◗Regular cleaning and proper maintenance ensure optimal results
and a long life for your appliance.
◗Noise level: Lc = 76 dB [A]
Preparing for use
◗Make sure your skin is clean, entirely dry and free from grease.
Do not use any cream before you start epilating.
◗Epilation is easier just after taking a bath or shower. Make sure
your skin is completely dry when you start epilating.
◗When you use the appliance for the first time, we advise you to
try it out on an area with only light hair growth to get
accustomed to the epilation process.
ENGLISH 7

◗As the hairs are removed by the root, epilation may cause some
skin discomfort the first few times you use the epilator.This
effect will gradually diminish when you use the appliance more
often. Regrowth tends to be softer both in appearance and to the
touch.
Using the appliance
◗Do not use the appliance near or over a washbasin or bath filled
with water (fig. 2).
◗Do not use the appliance in the bath or in the shower (fig. 3).
◗If you use the appliance in the bathroom, do not use an extension
cord (fig. 4).
◗Your epilator is equipped with a massage attachment that helps
to minimise the pulling sensation and gives you a more pleasant
feeling during epilation.The massage attachment pivots for
optimal contour following and can be easily detached for better
cleaning.
Connecting the appliance
1Insert the appliance plug into the appliance (fig. 5).
2Insert the adapter into the wall socket.
Epilating the legs
1Switch the appliance on by selecting the desired speed.
◗Select speed I for areas with little hair growth, for hard-to-reach
areas and for areas where bones are located directly beneath the
skin, such as knees and ankles.
◗Select speed II for larger areas with stronger hair growth.
2Stretch the skin with your free hand to make the hairs stand
upright.
3Place the epilator perpendicularly onto the skin with the on/off
ENGLISH8

slide pointing in the direction in which you are going to move the
appliance (fig. 6).
4Move the appliance slowly over the skin, against the direction of
hair growth.
5Press the appliance lightly onto the skin.
Cleaning and maintenance
Do not use any corrosive detergents, scouring pads or cloths, petrol,
acetone etc. to clean the appliance.
◗Never rinse the appliance or the adapter under the tap (fig. 7).
◗Keep the appliance and the adapter dry (fig. 8).
Cleaning the epilating head
1Switch the appliance off, remove the adapter from the wall socket
and pull the appliance plug out of the appliance (fig. 9).
2Remove the epilating head (fig. 10).
3Remove loose hairs with the brush supplied (fig. 11).
4Rinse the epilating head under the tap for 5-10 seconds while
turning it (fig. 12).
5Shake the epilating head firmly and dry it thoroughly with a tea
towel.The epilating head should be completely dry before you
place it back onto the appliance (fig. 13).
Environment
◗Do not throw the appliance away with the normal household
waste at the end of its life, but hand it in at an official collection
point for recycling. By doing this you will help to preserve the
environment (fig. 14).
ENGLISH 9

Solution
Move the appliance against the
direction of hair growth, with the
on/off slide pointing in the direction in
which you are moving the appliance.
Make sure that you place the
appliance perpendicularly onto the
skin (see chapter 'Using the
appliance').
Make sure your skin is clean, entirely
dry and free from grease. Do not use
any cream before you start epilating.
Make sure that the hairs to be
removed have a length of at least
3mm to guarantee proper hair
removal.
Make sure the socket is live. If you
have connected the epilator to the
socket in a bathroom cabinet, you may
need to switch on the bathroom light
to activate the socket.
Cause
The epilator is
being moved in
the wrong
direction.
The epilating head
is placed on the
skin at the wrong
angle.
The skin or hair
was treated with a
(depilatory)
cream prior to
epilation.
The socket to
which the
appliance has
been connected is
not live.
Problem
Poor epilating
results
The appliance
does not work
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
Troubleshooting
If the appliance does not work or does not work properly, first check
the list below. If the problem is not mentioned in this list, the appliance
probably has a defect. In that case we advise you to take the appliance
to your dealer or to an authorised Philips service centre.
ENGLISH10