Philips HQC688/60 User manual

ENGLISH 4
DEUTSCH 11
FRANÇAIS 18
NEDERLANDS 25
ESPAÑOL 32
ITALIANO 39
PORTUGUÊS 46
TÜRKÇE 53
 60
HQ C688
3

Important
◗Check if the voltage indicated on the mains
plug corresponds to the mains voltage in your
home before you connect the appliance.
◗Make sure the appliance does not get wet.
◗Charge and store the appliance at a
temperature between 15cand 35cC.
C◗Protect the instruction video from dust,
humidity,too high or too low temperatures
and magnetic fields (i.e.television sets or
loudspeakers).
◗Do not open the protective flap of the video
cassette and do not touch the tape.
◗If the video is stored in a cold environment,
do not use it until it has reached room
temperature.
◗Insert the video cassette with the window
facing upwards.
Charging
Charge the appliance fully before you start using
it for the first time.
Make sure the appliance is switched off while
charging.
C1Insert the appliance plug into the
appliance.
ENGLISH4

2Insert the mains plug into the wall socket.
BThe pilot light will go on to indicate that the
appliance is charging.
It will take approx.12 hours to fully charge the
battery.
Do not charge the appliance for more than 24
hours.
A fully charged appliance has a cordless clipping
time of up to 50 minutes.
Corded clipping
◗To clip with the hair clipper connected to the
mains:
Switch the hair clipper off,connect it to the mains
and wait a few seconds before switching it on.If
the battery is completely empty:wait a few
minutes before switching the appliance on.
Do not run the appliance from the mains when
the battery is fully charged.
Preparing for clipping
◗See also the booklet 'Modelling and styling'
and the instruction video.
Clipping with comb attachment:
Select the small or large comb attachment,
depending on the desired hair length (see table).
C1Slide the comb holder into the guiding
grooves of the appliance until you hear a
click.
ENGLISH 5

C2Turn the Precision Zoom Lock`to the
desired hair length setting (see table).
3Switch the appliance on.
If a lot of hair has accumulated in the comb,
remove the comb attachment and blow and/or
shake the hair from the comb.
Cutting length settings
Small comb Large comb
setting hair length setting hair length
1 4 mm 8 24 mm
2 7 mm 9 27 mm
3 10 mm 10 30 mm
4 13 mm 11 33 mm
5 16 mm 12 35 mm
6 19 mm 13 38 mm
7 21 mm 14 40 mm
Clipping without comb attachment
C1Remove the comb attachment by pulling it
off the appliance.
Clean and recharge the appliance every time you
have used it.
Cleaning
Do not use abrasives,scourers or liquids such as
alcohol,petrol or acetone to clean the appliance.
ENGLISH6
1 •3 •5 •7

1Make sure the appliance is switched off
and disconnected from the mains before
you start cleaning it.
2Remove the comb attachment.
C3Open the cutting unit.
C4Clean the cutting unit and the inside of the
appliance with the brush supplied.
C5Close the cutting unit.Push the cutting unit
until you hear a click.
6
Replacement
A worn or damaged cutting unit should only be
replaced with an original Philips cutting unit.
1Remove the old cutting unit.
C2Place the two lugs of the new cutting unit
into the guiding slots and push the unit
back onto the appliance.
ENGLISH 7

Environment
The built-in rechargeable battery contains
substances which may pollute the environment.
Remove the rechargeable battery when you
discard the appliance.
Do not throw the battery away with the normal
household waste but dispose of it at an official
collection point.
You can also take the appliance to a Philips
service centre,where staff will be happy to help
you remove the battery and dispose of it in an
environmentally safe way.
1Disconnect the appliance from the mains
and let the appliance run until the motor
stops.
C2Open and remove the cutting unit.
C3Remove the metal clip by means of a
screwdriver.
C4Remove the cover plate.
ENGLISH8

C5Remove the Precision Zoom Lock`by
pulling it in the direction of the cutting
unit.
C6Remove the cover.
C7Pull out the printed circuit board.
C8Insert a screwdriver into the small slot in
the printed circuit board marked with an
arrow.Push the screwdriver down until
part of the printed circuit board breaks
off.
C9Open the plastic battery holder and take
out the rechargeable battery.
Dispose of the battery and the other
components in an environmentally safe way.
Do not connect the appliance to the mains again
after it has been opened!
ENGLISH 9
1
2

For telephone numbers of the Philips Helpdesk,
see theWorldwide Guarantee leaflet.
ENGLISH10

Wichtig
◗Prüfen Sie,bevor Sie das Gerät in Betrieb
nehmen,ob die Spannungsangabe auf dem
Netzstecker mit der örtlichen Netzspannung
übereinstimmt.
◗Achten Sie darauf,daß das Gerät nicht naß
wird.
◗Laden und lagern Sie das Gerät bei
Temperaturen zwischen 15 °C und 35 °C.
C◗Halten Sie das Demonstrations-Video von
Staub,Feuchtigkeit,zu hohen oder zu
niedrigenTemperaturen frei,und von
Magnetfeldern,wie sie z.B.von Fernsehgeräten
und Lautsprechern ausgehen.
◗Öffnen Sie nicht die Schutzklappe der
Videokassette,und berühren Sie nicht das
Videoband.
◗Warten Sie bis dasVideoband
Raumtemperatur erreicht hat,wenn Sie die
Videokassette in kalter Umgebung aufbewahrt
hatten.
◗Legen Sie dieVideokassette so ein,daß das
Fenster nach oben zeigt.
DenAkku aufladen
Laden Sie den Akku voll auf,bevor Sie das Gerät
zum ersten Mal benutzen.
DEUTSCH 11

Achten Sie darauf,daß das Gerät während des
Aufladens ausgeschaltet ist.
C1Stecken Sie den Gerätestecker in das
Gerät.
2Stecken Sie dann den Netzstecker in die
Steckdose.
BDie Kontrollampe leuchtet auf und zeigt an,daß
derAkku geladen wird.
Nach ca.12 Stunden ist der Akku voll aufgeladen.
Lassen Sie das Gerät nicht länger als 24 Stunden
am Netz.
Mit voll aufgeladenem Akku können Sie das Gerät
ca.50 Minuten kabelfrei verwenden.
Gerät am Netz betreiben
◗So schneiden Sie die Haare mit dem Kabel am
Netz:
Schalten Sie das Gerät aus,verbinden Sie es durch
das Kabel mit dem Netz.Warten Sie einige
Sekunden,bevor Sie das Gerät einschalten.Sollte
der Akku leer sein,so müssen Sie einige Minuten
warten,bevor Sie das Gerät einschalten.
Betreiben Sie das Gerät nicht am Netz,wenn der
Akku voll aufgeladen ist.
Vor dem Gebrauch
◗Vgl.auch das Heft "Modelling and styling",das
dem Demonstrations-Video beiliegt.
DEUTSCH12