USING THE APPLIANCE
When you use Lumea regularly, please avoid
sunbathing. If you have sunbathed, make sure
you wait at least 2 weeks before you use Lumea
Essential.
You need to prepare your skin by shaving the
desired treatment area before using Lumea.
Once the hairs stop growing back, which usually
happens after 4-5 treatments, you no longer have
to shave before you use the appliance.
Check if the attachment and light exit window are
clean. If there is dirt, hair or bre on the window,
clean it with the cloth supplied before use.
Make sure you place back the body attachment
properly.
Before you use Philips Lumea Essential, perform a skin test (see user
manual). After the skin test, wait for 24 hours and check your skin for any
reactions. If you notice any skin reactions, choose the highest setting that
did not result in any skin reactions, for subsequent use.
Put the plug in the socket and switch on the device.
Then select the light intensity level that matches
your skin tone.To choose the appropriate setting,
simply consult the suitability chart on the back of
this quick start guide.
To adjust the light intensity setting, press the on/off
button one or more times until you have reached
the required setting.
Place Lumea at a 90-degree angle on your skin and
ensure full skin contact.When you have full skin
contact, the ‘ready to ash’ light turns green.
Press the ash button to release a ash. Lift the
appliance off your skin and place it on the next area
to be treated, making sure there is some overlap.
Then press the ash button again.
With Lumea Essential Plus, you can choose the
mode you’d like to use. Slide and ash is the main
application mode. You just keep the ash button
pressed down and ash will continue to go off as
you glide.
After each ash, it takes up to 3.5 seconds until the
appliance is ready to ash again. During this charging
time, the ‘ready to ash’ light blinks when the
appliance is in full contact with your skin.
1
2
3
4
5
6
7
8
9
4222_100_0504_1_QSG_A6_v1.indd 3 5/7/13 9:17 AM
