Philips 8000 Series User manual

User manual
Brugervejledning
Benutzerhandbuch
Manual del usuario
Käyttöopas
Mode d’emploi
Manuale utente
Gebruiksaanwijzing
Brukerhåndbok
Användarhandbok
8000 Series
TAE8005
Headphones
Register your product and get support at
www.philips.com/support

English
EN 1
Contents
1 Important safety instructions 2
Hearing Safety 2
General information 2
2 Your wireless stethoscope 3
What's in the box 3
Overview of the stethoscope 4
Overview of the docking station 4
3 Get started 5
Connect 5
Install the supplied batteries 6
Charge the stethoscope 6
4 Use your stethoscope 7
Auto switch on/off 7
Adjust the volume 7
Adjust the left/right balance 7
Amplify the environmental sound 7
Equalizer (EQ) 7
Store and charge the stethoscope 7
5 LED and sound indication 8
LED indication 8
Sound indication 8
6 Care and maintainence 8
Clean the stethoscope and docking
station 8
Clean the ear caps 8
7 Accessories 9
8 Technical data 9
9 Notice 10
Declaration of conformity 10
Compliance with EMF 10
Disposal of your old product and
battery 10
10 Frequently asked questions 11
Contents
Indholdsfortegnelse

2EN
1 Important safety
instructions
Hearing Safety
Danger
•To avoid hearing damage, limit the time you use
headphones at high volume and set the volume to a
safe level.The louder the volume, the shorter the safe
listening time is.
Be sure to observe the following guidelines
when using your headset.
• Listen at reasonable volumes for reasonable
periods of time.
• Be careful not to adjust the volume
continuously upwards as your hearing
adapts.
• Do not turn up the volume so high that
you can’t hear what’s around you.
• You should use caution or temporarily
discontinue use in potentially hazardous
situations.
• Excessive sound pressure from earphones
and headphones can cause hearing loss.
• Using headphones with both ears covered
while driving is not recommended and may
be illegal in some areas while driving.
• For your safety, avoid distractions from
other potentially dangerous environments.
General information
Caution
•
product dry. Do not expose it to excessive heat by
heating equipment or direct sunlight.
•
be placed on the apparatus.
•Do not allow your product to be submerged in water.
•
cloth. Do not use cleansing agents containing alcohol,
spirits, ammonia or abrasives as they may harm the
product.
•Do not disassemble the product.
•Do not operate or store the product in a place where
•This product shall not be exposed to dripping or
splashing.
•The mains plug of AC/DC adapter is used as the
disconnect device, the disconnect device shall be readily
operable.
•Use only the supplied batteries.
•Other types of rechargeable or alkaline batteries cannot
be charged with this system.
•Batteries (battery pack or batteries installed) shall not
the like.
•Risk of explosion! Keep batteries away from heat,

English
EN 3
2 Your wireless
stethoscope
What's in the box
*Philips wireless stethoscope
Docking station
Power adapter
3.5mm audio cable
Optical cable
RCA adapter
*Rechargeable lithium-polymer battery
Spare ear caps
User manual
Quick start guide

4EN
Overview of the stethoscope Overview of the docking
station
1, Ear cap
2, Wireless/ambient mode button
3, Wireless/ambient mode indicator
4, Left/right balance control
5, Volume control button
6, Battery
1, Audio input
2, AUDIO IN/OPTICAL IN switch
3, Optical input
4, ATT (Attenuation of audio input signal switch)
5, POWER (Power the docking station on or off)
6, Power adapter jack
7, Battery charging slot
8, Stethoscope charging slot
9, Equalizer (EQ) button
10, Battery charging indicator
11, Stethoscope charging indicator
12, Equalizer (EQ) indicators
EQ1: voice emphasis
EQ2: treble boost
EQ3: bass boost

English
EN 5
3 Get started
Caution
•Make sure that you have read the safety instructions in
the 'Important safety instructions' section before you
connect and install your stethoscope.
Connect
1. Connect the audio device
Note
•
station automatically turns off.
•The energizing docking station does not transmit audio
signal when charging.
•You can charge one stethoscope each time.
See the following instructions to connect the
audio device and adjust ATT.
ForTV or other devices with 3.5mm audio
• connect one side of the supplied 3.5mm
audio cable to the 3.5mm audio input of
the docking station and another side to the
3.5mm audio output.
• switch to AUDIO IN.
• switch ATT to 0dB (switch to -8dB if the
sound volume is too high).
• connect one side of the supplied RCA
adapter to RCA output of the audio device,
and another side to the supplied 3.5mm
audio cable. Connect the remaining side of
the 3.5mm audio cable to the 3.5mm audio
input of the docking station.
• switch to AUDIO IN and ATT to -8dB.
• connect one side of the supplied optical
cable to optical output of the device, and
another side to the optical input of the
docking station.
• switch to OPTICAL IN.
• make sure that the audio device is set to
PCM (check the manual of your audio
device for information).
L
R
PCM

6EN
2. Connect the power adapter
3. Adjust the volume
Adjust the volume of the audio device to get
the best sound quality (check the manual of
your audio device for information).
Install the supplied batteries
Your stethoscope comes with a high quality
rechargeable lithium-polymer battery to
maximize battery lifetime. Insert/remove the
Note
•Over time the capacity of the battery will decrease.
You can order replacement batteries through
the Philips service centers or online stores at
www.shop.philips.com
The spare battery
The spare battery extends the operating time
Charge the stethoscope
Note
•
the supplied battery for 5 hours for optimum battery
capacity and lifetime.
•You can charge one stethoscope per each time.
•Normally, a full charge takes 2.5 hours.
1Power on the docking station.
2Place the stethoscope on the docking
station.
»
spare battery is inside the charging slot,
the orange charging LED of the spare

English
EN 7
4 Use your
stethoscope
Auto switch on/off
• The stethoscope is on automatically when
you wear it on your ears.
»The LED on the stethoscope will turn
white.
• The stethoscope is off automatically when
you take it off from your ears.This saves the
battery life.
Adjust the volume
If you turn the volume control button of the
stethoscope to the maximum level and the
sound volume is still low, you can adjust the
volume of yourTV to improve the quality of
wireless sound transmission (check the manual
of your audio device for information).
Adjust the left/right balance
You can adjust the left/right balance to make
your both ears hear well (see 'Overview of the
stethoscope' on page 4).
Amplify the environmental
sound
You can press the microphone button to
turn off the sound of the TV and amplify the
environmental sound and conversations (see
'Overview of the stethoscope' on page 4).
Equalizer (EQ)
You can press the EQ button to select among
voice emphasis EQ 1, treble boost EQ 2, bass
boost EQ 3 or off to suit your personal sound
preference and give you the best sound quality
(see 'Overview of the stethoscope' on page 4).
Store and charge the
stethoscope
Place the stethoscope to the docking station
after use.This can prevent the earbuds from
pulling apart, which will keep the stethoscope
switching on.

8EN
5 LED and sound
indication
LED indication
Description Status LED
Battery No charging Off
Charging Orange LED
Charged White
Docking
station
On White LED
Off Off
Charging Orange LED
Charged White
Connected to
the stethoscope
White
Searching White LED
Equalizer
(EQ)
On White
Off Off
Stethoscope Off Off
Wireless mode White
Ambient mode Orange
Connection lost White LED
Low battery level Orange LED
Sound indication
Status Sound signal
Low battery level 1 beep per minute
(for 4 minutes)
Battery goes out soon. 2 beeps
Reach max./min. volume
level.
1 beep
6 Care and
maintainence
Clean the stethoscope and
docking station
1Make sure that the docking station is
disconnected from the power source.
2Use a slightly wet cloth to clean the
product gently.
Clean the ear caps
1Remove the ear caps carefully from the
stethoscope.
2Clean the ear caps with warm soap water.
3Dry the ear caps thoroughly.
Note
•The ear caps need to be replaced for a regular
period of time.You can order replacement ear caps
through the Philips service centers or online stores at
www.shop.philips.com