Philips MCD908/12 User manual

3
12
MCD 908
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
2
User Manual
1
Quick Start Guide
Quick start guide
User manual
Remote control with two
AAA batteries
FM and MW antennas
Control Cable Composite Video Cable
MCD908 QUG_12_Eng 2007.1.15, 17:001

Tips
–See the User Manual for other TV
connection options.
–For connecting to a Progressive Scan
TV, refer to the user manual for proper
connections and detailed setup.
1
2
4
3
Setting up the TV
1
2
Press SOURCE (DISC on the remote) to select disc source.
Turn on the TV and set it to the correctVideo In channel.
5
Connect the speaker cables.
Connect the MW and FM antennas.
Connect the control cable.
Connect the composite video cable to a TV.
Connect the power cords of the system and TV.
STOP STOP
Speaker
(right)
Speaker
(left)
FM antenna
AC power
MW antenna
MCD908 QUG_12_Eng 2007.1.15, 17:002

Setting the clock
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, turn VOLUME-/+ on the system or press VOLUME+/- on the
remote to set the hours.
Press CLOCK again and the minute digits flash.Then turn VOLUME-/+ on the system or
press VOLUME+/- on the remote to set the minutes.
Press CLOCK again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support
progressive signals or the cables are not connected accordingly, see the user
manual for proper progressive scan setup or deactivate the progressive scan
feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM on the remote to exit the system menu and then DISC and “1”
to exit progressive scan.
Tip
See chapters "Getting Started" and "System Menu Options" in the
User Manual for detailed descriptions.
MCD908 QUG_12_Eng 2007.1.15, 17:003

Playing a disc
1
2
3
Press OPEN •CLOSEç(çon the remote) to open the disc tray and load in a disc,
then press the same button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Playback will start automatically. If not pressÉÅ.
To stop playback, press STOP9(9on the remote).
Programming and tuning to radio stations
1
2
3
Press SOURCE (TUNER on the remote) to select tuner source.
Press PROG on the remote for more than two seconds to program all available stations in
order of waveband.
Press PRESET+/- (¡/ ™on the remote) until the desired preset station is displayed.
PDCC-JS/JW-0702
Tip
Detailed playback features and
additional functions are described in the
accompany owner's manual.
Notes for remote control:
– First, select the source you wish to control by
pressing one of the source select keys on the
remote control (DISC or TUNER, for example).
–Then select the desired function (
2; , í , ë
for example).
CRoyal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
MCD908 QUG_12_Eng 2007.1.15, 17:004