Philips MCD196/98 User manual

CLOCK
MCD196
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
1
Quick Start Guide
Quick Start Guide
CompositeVideo Cable Remote control with
battery
MW antenna FM antenna
2
User Manual
User Manual
Remove the plastic
protective sheet
MCD196_98 QUG_Eng 31/1/07, 16:041

A
RIGHT LEFT
R LINE OUT L
+
–
SPEAKER 4Ω
RSP-134V
VIDEO OUT
VIDEO
SUB WOOFER
OUT
DIGITAL
OUT
S-VIDEO
3
2
1
4
1
FM
AERIAL
AM
AERIAL
Tip
See the User Manual for otherTV
connection options.
Setting up the TV
1
2
4
3
Connect the speaker cables.
Connect the FM and MW antennas.
Connect the composite video cable to a TV.
Connect the power cords of the system and TV.
1
2
Press SOURCE (DISC on the remote) to select disc source.
Turn on the TV and set it to the correctVideo In channel.
CLOCK
AUDIO OUT
L
R
B
ATo listen to the sound of this DVD Player
through your TV, use the audio cables (white/
red-not supplied) to connect LINE OUT
(L/R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV.
B To listen to the sound of your TV through
this DVD player, use a cinch cable (not
supplied) to connect AUX on the front
panel of the DVD player to the
corresponding AUDIO OUT jacks on the TV.
MCD196_98 QUG_Eng 31/1/07, 16:042

Setting the clock
1
2
3
4
In standby mode, press and hold DISPLAY/CLOCK SET on the system.
When the hour digits flash, pressí/ëon the front panel or on the remote to set the
hours.
Press DISPLAY/CLOCK SET again and the minute digits flash.Then press í/ëon the
front panel or on the remote to set the minutes.
Press DISPLAY/CLOCK SET again to confirm the time setting.
Setting system menu options
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
CLOCK
VOLUME +
-
STANDBY-ON
PULLTO OPEN
MICRO THEATRE MCD196
DVD/WMA-MP3-CD COMPATIBLE
PRESET
SOURCE
TUNING
DBB
DSC
AUX
DISPLAY/CLOCK SET
iR
SET
TUNING
LATIN
DIVX(R) VODDIVX(R) VOD
MCD196_98 QUG_Eng 31/1/07, 16:043

Playing a disc
Programming and tuning to radio stations
1
2
3
Press SOURCE (TUNER on the remote) to select tuner source.
Press PROG/ANGLE for more than two seconds to program all available stations in
order of waveband.
Press PRESETí/ëuntil the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
PDCC-JH/ZC-0705
CRoyal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
1
2
3
Press OPEN•CLOSE 0to open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Playback will start automatically. If not pressÉÅ.
To stop playback, press 9.
MCD196_98 QUG_Eng 31/1/07, 16:044