Philips AZ1852/79 User manual

Register your product and get support at AZ1852
EN User manual
ZH-HK 使用手冊

EN
1 Important
Safety
aRead these instructions.
bKeep these instructions.
cHeed all warnings.
dFollow all instructions.
eDo not use this apparatus near water.
fClean only with dry cloth.
gDo not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
hDo not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including ampliers) that
produce heat.
iProtect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
j Only use attachments/accessories specied by the
manufacturer.
kUnplug this apparatus during lightning storms or when unused
for long periods of time.

l Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate
normally, or has been dropped.
mBattery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to
the unit:
Install all batteries correctly, + and - as marked on the unit.•
Do not mix batteries (old and new or carbon and alkaline,•
etc.).
Remove batteries when the unit is not used for a long time.•
nApparatus shall not be exposed to dripping or splashing.
oDo not place any sources of danger on the apparatus (e.g.
liquid lled objects, lighted candles).
pWhere the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
Warning
Never remove the casing of this apparatus.•
Never lubricate any part of this apparatus.•
Never place this apparatus on other electrical equipment.•
Keepthisapparatusawayfromdirectsunlight,nakedamesorheat.•
Never look into the laser beam inside this apparatus.•
Ensure that you always have easy access to the power cord, plug or•
adaptor to disconnect this apparatus from the power.

Hearing safety
Listen at a moderate volume.
Using headphones at a high volume can impair your hearing. This•
product can produce sounds in decibel ranges that may cause
hearing loss for a normal person, even for exposure less than a
minute. The higher decibel ranges are offered for those that may
have already experienced some hearing loss.
Sound can be deceiving. Over time your hearing ‘comfort level’•
adapts to higher volumes of sound. So after prolonged listening,
what sounds ‘normal’ can actually be loud and harmful to your
hearing. To guard against this, set your volume to a safe level
before your hearing adapts and leave it there.
To establish a safe volume level:
Set your volume control at a low setting.•
Slowly increase the sound until you can hear it comfortably and•
clearly, without distortion.
Listen for reasonable periods of time:
Prolonged exposure to sound, even at normally ‘safe’ levels, can•
also cause hearing loss.
Be sure to use your equipment reasonably and take appropriate•
breaks.
Be sure to observe the following guidelines when using your
headphones.
Listen at reasonable volumes for reasonable periods of time.•
Be careful not to adjust the volume as your hearing adapts.•
Do not turn up the volume so high that you can’t hear what’s•
around you.

You should use caution or temporarily discontinue use in•
potentially hazardous situations. Do not use headphones while
operating a motorized vehicle, cycling, skateboarding, etc.; it may
createatrafchazardandisillegalinmanyareas.
Caution
Use of controls or adjustments or performance of procedures other•
than herein may result in hazardous radiation exposure or other
unsafe operation.
Notice
This product complies with the radio interference requirements of
the European Community.
Anychangesormodicationsmadetothisdevicethatarenot
expressly approved by Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
Disposal of your old product and batteries
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of
electrical and electronic products and batteries. The correct disposal
of these products helps prevent potentially negative consequences
on the environment and human health.

Your product contains batteries, which cannot be disposed of with
normal household waste.
Please inform yourself about the local rules on separate collection of
batteries. The correct disposal of batteries helps prevent potentially
negative consequences on the environment and human health.
Please visit www.recycle.philips.comfor additional information
on a recycling center in your area.
Recording and playback of material might require consent. See Copyright
Act 1956 and The Performer’s Protection Acts 1958 to 1972.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
paper pulp (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Copyright notice
This item incorporates copy protection technology that is protected
by U.S. patents and other intellectual property rights of Rovi
Corporation. Reverse engineering and disassembly are prohibited.
Trademark notice

Windows Media and the Windows logo are trademarks, or
registered trademarks of Microsoft Corporation in the United States
and/or other countries.
This apparatus includes this label:
2 Your CD Soundmachine
Introduction
With this unit, you can enjoy audio from audio CDs, radio, tape, external
devices,andMP3/WMAlesthatarestoredonUSBdevices.
The unit offers you multiple sound effect settings that enrich sound with
Dynamic Bass Boost (DBB).
The unit supports the following media formats:

Note
The type plate is located on the bottom of the apparatus.•
What’s in the box
Check and identify the contents of the package:
Main unit•
AC power cord•
Remote control•
User Manual•
Overview of the main unit
b
a
c
e
d
h
g
f
i
j
k
l
s
q
r
o
p
n
m
BATTERY SUPPLY: 6 x 1.5V R14/ UM2/ C CELL
UPPER 2
LOWER 2220~
240V
110~
127V t
u
v

aAntenna
b
USB socket.•
c Source selector:CD, USB, FM, TAPE (OFF).
Select source and turn on/off the unit.•
dLIFT-OPEN
Open/Close the CD compartment.•
eVOLUME
Adjust volume.•
f/
Fast rewind/wind the tape.•
g
Stop the tape or open the tape compartment.•
h
Pause tape Play.•
i
Start or pause CD play.•
j/
Skip to the previous/next track.•
Search within a track.•
k
Stop play or erase a program.•
lUSB REC
RecordfromadisctoaUSBashdrive.•
mMODE
Select a play mode: REPEAT or SHUFFLE.•
nDBB
Turn on/off dynamic bass boost.•

oIR
Remote control sensor.•
pDisplay panel
Display current status.•
q
Start tape Record.•
r
Start tape play.•
sTUNING
Tune to radio stations.•
t Voltage selector (not for Australia and New Zealand)
u
Headphone socket.•
vMP3 LINK
Jack for an external audio device.•

Overview of the remote control
a/
Search within a track.•
b
Stop play.•
Erase a program.•
c
Start or pause play.•
d/
Skip to the previous/next track.•
a
d
e
f
g
c
b
i
h

eAL-/AL+
Skip to the previous/next album.•
fMODE
Select a play mode: REPEAT or SHUFFLE•
gDEL
DeleteaudiolesstoredonaUSBdevice.•
hREC
Record from a disc to a USB device.•
iPROG
Program tracks.•
3 Get started
Caution
Use of controls or adjustments or performance of procedures other•
than herein may result in hazardous radiation exposure or other
unsafe operation.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number
of your apparatus.The model number and serial number are on the
bottom of your apparatus.Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Install batteries
Note
You can use both batteries and AC power as power supply of this•
apparatus.
Batteries are not supplied with the accessories.
•
1Open the battery compartment.
2Insert 6 batteries (type: R14, UM2 or C cells) with correct
polarity (+/-) as indicated.
3Close the battery compartment.
BATTERY SUPPLY: 6 x 1.5V R14/ UM2/ C CELL
UPPER 2
LOWER 2

Prepare the remote control
Caution
Riskofexplosion!Keepbatteriesawayfromheat,sunshineorre.•
Neverdiscardbatteriesinre.
Risk of decreased battery life! Never mix different brands or types
•
of batteries.
Risk of product damage! When the remote control is not used for
•
long periods, remove the batteries.
For rst-time use:
1Remove the protective tab to activate the remote control
battery.
To replace the remote control batteries:
1Open the battery compartment.
2Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
3Close the battery compartment.

Connect power
Warning
Risk of product damage! Ensure that the power supply voltage•
corresponds to the voltage printed on the bottom of the apparatus.
If your product is equipped with a
•Voltage selector, set the Voltage
selector to the local power line voltage.
Risk of electric shock! When you disconnect the AC power, always
•
pull the plug from the socket. Never pull the cord.
Install the apparatus near the power supply socket and where the
•
power plug can be easily reached.
1Connect the AC power cord to the AC input jack on the
apparatus and to the power supply socket.
To switch the apparatus off completely, disconnect the AC•
power cord from the power supply socket.
Note
To save energy: turn off the apparatus after use.•
4 Play
Play CD
1Slide the Source selector to CD.
2Pull LIFT-OPEN to open the disc tray.

3Insert a disc with the printed side facing up, then close the disc
tray.
Play starts automatically.»
To pause/resume play, press• .
To stop play, press• .
For an MP3/WMA disc, press• AL-/AL+ to select an album.
To skip to a track, press• / .
To search within a track, press and hold• / . Release the
button to resume normal play.
Play tape
1Slide the Source selector to TAPE .
2Press on the main unit to open the tape compartment.
3Load a tape with the open side upward.
4Press on the main unit to start playing.
To pause/resume play, press• on the main unit .
To search fast-backward or fast-forward, press• / on
the main unit .
To stop play, press• .
Play from USB devices
Note
Ensure that the USB device contains playable audio contents.•
1Connect the USB device to the socket.
2Slide the Source selector to USB.
3Press AL-/AL+ to select a folder.

4Press / toselectale.
5Press to start playing.
To stop play, press• .
To pause or resume play, press• .
Delete from USB device
1During play, press / to select a track.
To delete an album, press• to stop play, and then press
AL-/AL+ to select an album.
2Press DEL .
Aconrmationmessageisdisplayed.»
3Press DELagaintoconrm.
To cancel, press• .
Listen to an external device
You can use this unit to play audio from an external device.
1Connect the MP3 link cable (not supplied) to
the• MP3-LINK jack (3.5 mm) on the back of this unit
the audio output jack of the external device.•
This unit stops the current playback and starts to play the»
audio input from the external device.

5 Listen to the radio
Tune to a radio station
Note
For optimal reception, fully extend and adjust the position of the FM•
antenna.
1Switch the Source selector to FM.
2Turn TUNING to tune to a desired radio station.
6 Play options
Adjust volume level
1During play, turn VOLUME to increase/decrease the volume
level.
Enhance bass
1During play, press DBB to turn on or off dynamic bass
enhancement.
If DBB is activated,»[DBB] is displayed.
Select play modes
1Press MODE repeatedly:
• []- repeat a track
• [ALL] - repeat all tracks

• [ ] - play tracks randomly
• [ALB] and [](only for MP3 tracks) - repeat the current
album
2To return to normal play mode, press MODE repeatedly until
the play mode icons mentioned above disappear.
Tip
During the playback of programmed tracks, only•[ ] and [ALL]
can be selected.
Program tracks
You can program a maximum of 20 tracks.
1In CD/USB mode, press to stop the play.
For MP3/WMA tracks, press• AL-/AL+ to select an album
after the stop.
2Press PROG to activate the program mode.
»[PROG] (program) starts to blinks.
3Press / to select a track number.
4Press PROGtoconrm.
5Repeat steps 3 to 4 to program more tracks.
6Press on the main unit to play the programmed tracks.
During play,»[PROG] is displayed.
To erase the program, press• twice.
To review the program, press• to stop the play, and then
press and hold PROG for more than 2 seconds.

7 Record form different sources
You can record from different sources.
Record from CD/USB to tape
1Slide the Source selector to CD/USB.
2Insert a disc/USB device.
Torecordtracksinaspecicsequence,programthetracks•
(see “Play options” > “Program tracks”).
3Press to open the tape compartment.
4Insert a blank tape and close the tape compartment.
5Press to start recording.
Thecurrenttrack(orthetrackprogrammedastherst)»
starts from the beginning.
To pause/resume recording, press• .
To stop recording, press• .
Record from radio to tape
1Tune to the desired radio station.
2Press to open the tape compartment.
3Insert a blank tape and close the tape compartment.
4Press to start recording.
To pause/resume recording, press• .
To stop recording, press• .
CD Ripping
You can record music from an audio CD to a USB mass storage device.