Philips MCD296 User manual

MCD296
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
1
Quick Start Guide
Quick Start Guide
CompositeVideo Cable Remote control with
battery
MW antenna FM antenna
2
User Manual
User Manual
Remove the plastic
protective sheet
MCD296 QUG_Eng 2007.1.21, 16:321

SPEAKER 4Ω
R L
FM aerial
75 Ω
LINE OUT
VIDEO OUT
VIDEO S-VIDEO
COAXIAL
SUB WOOFER
OUT
R L
MW aerial
+
–
AC power cord
FM wire
antenna
MW loop
antenna
Speaker
(right)
Speaker
(left)
Tip
See the User Manual for otherTV
connection options.
Setting up the TV
1
2
4
3
Connect the speaker cables.
Connect the FM and MW antennas.
Connect the composite video cable to a TV.
Connect the power cords of the system and TV.
1
2
Press SOURCE (DISC on the remote) to select disc source.
Turn on the TV and set it to the correctVideo In channel.
FM aerial
75 Ω
LINE OUT
VIDEO OUT
VIDEO S-VIDEO
COAXIAL
SUB WOOFER
OUT
R L
AM aerial
A
AUDIO OUT
L
R
B
ATo listen to the sound of this DVD Player
through your TV, use the audio cables (white/
red-not supplied) to connect LINE OUT
(L/R) jacks of the DVD Player to the
corresponding AUDIO IN jacks on the TV.
B To listen to the sound of your TV through
this DVD player, use a cinch cable (not
supplied) to connect AUX on the front
panel of the DVD player to the
corresponding AUDIO OUT jacks on the TV.
MCD296 QUG_Eng 2007.1.21, 16:322

Setting the clock
1
2
3
4
In standby mode, press and hold DISPLAY/CLOCK SET on the system.
When the hour digits flash, turn the VOLUME -/+ control on the front panel or press
VOL +/- on the remote to set the hours.
Press DISPLAY/CLOCK SET again and the minute digits flash.Then turn the VOLUME
-/+ control on the front panel or press VOL +/- on the remote to set the minutes.
Press DISPLAY/CLOCK SET again to confirm the time setting.
Setting system menu options
Tip
See chapters "Preparations" and "System Menu Options" in the User
Manual for detailed descriptions.
LATIN
DIVX(R) VODDIVX(R) VOD
MCD296 QUG_Eng 2007.1.21, 16:333

Playing a disc
Programming and tuning to radio stations
1
2
3
Press SOURCE (TUNER on the remote) to select tuner source.
Press PROG/ANGLE for more than two seconds to program all available stations in
order of waveband.
Press PRESETí/ëuntil the desired preset station is displayed.
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
PDCC-JS/JW-0704
CRoyal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com
1
2
3
Press OPEN•CLOSE 0to open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Playback will start automatically. If not press ÉÅ.
To stop playback, press 9.
MCD296 QUG_Eng 2007.1.21, 16:334