Philips MCM770 User manual

MCM770
What’s in the Box?
You should Þnd these items upon opening the box.
FM antenna
Quick Start Guide
Remote Control
Pull out the plastic pro-
tective sheet before use.
Quick Start Guide AC adaptorUser Manual
MCM770_QSG_Eng.indd 1MCM770_QSG_Eng.indd 1 2008-9-22 10:33:052008-9-22 10:33:05

1
2
3
4
In standby mode, press and hold CLOCK on the remote control.
When the hour digits ßash, turn VOL on the system or press VOL+/- on the remote control
to set the hours.
Press CLOCK again and the minute digits ßash.Then turn VOL on the system or press
VOL+/- on the remote control to set the minutes.
Press CLOCK again to conÞrm the time setting.
1
2
3
Connect the speaker cables.
Connect the FM antenna.
Connect the AC adaptor of the system.
Speaker
(right)
Speaker
(left)
FM antenna
AC adaptor
Setting the clock
IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON 2on the set for 3 seconds or more to switch to normal
standby mode Þrst before proceeding with the procedures below.
Tip
See the User Manual for how to connect
other equipment to this system.
MCM770_QSG_Eng.indd 2MCM770_QSG_Eng.indd 2 2008-9-22 10:33:062008-9-22 10:33:06

4
3
2
1
Playing a disc
Press SOURCE on the front panel to select DISC or press CD on the
remote control.
Press çto open the CD compartment.
Insert a disc with the printed side facing up. Press çagain to close the
compartment.
Playback will start automatically. If not, press ÉÅ.
To stop playback, press 9.
CD
5
1
2
3
Insert the USB device’s USB plug into the socket on the set.
Press SOURCE once or more (or USB on the remote control) to select USB.
Play the USB’s audio Þles as you do with the albums/tracks on a CD.
Playing a USB mass storage device
With the Hi-Fi system, you can use USB ßash memory (USB 2.0 or USB1.1),
USB ßash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this Hi-Fi system).
MCM770_QSG_Eng.indd 3MCM770_QSG_Eng.indd 3 2008-9-22 10:33:072008-9-22 10:33:07

1
2
3
Press SOURCE (FM on the remote control) to select tuner source.
Press PROG on the remote control for more than two seconds to program all available sta-
tions in order of waveband.
Press ¡/ ™until the desired preset station is displayed.
Programming and tuning to radio stations
PDCC-JS-WP-0829
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
CRoyal Philips Electronics N.V. 2008
All rights reserved.
http://www.philips.com
MCM770_QSG_Eng.indd 4MCM770_QSG_Eng.indd 4 2008-9-22 10:33:072008-9-22 10:33:07