Philips MCM394/12 User manual

1
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
2
User Manual
FM antenna MW antenna Remote Control
Quick Start Guide
Quick Start Guide
User manual
MCM394
Pull out the plastic
protective sheet
before use.
MCM394 QUG_Eng 2007.12.20, 2:20 PM1

Connect the speaker cables.
Connect the MW and FM antennas.
1
2
Tip
See the User Manual for how to connect other equipment
to this system.
FM wire antenna
AC power cord
MW loop
antenna
Speaker
(left)
Speaker
(right)
2
1
MCM394 QUG_Eng 2007.12.20, 2:20 PM2

Enjoy
C
Playing a disc
1
2
3
Press OPEN/CLOSEçto open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Press ÉÅ to start playback.
To stop playback, press 9.
Setting the clock
1
2
3
4
IMPORTANT!
– To set clock in the Eco Power mode, press and hold ECO POWER/
STANDBY-ON
2 on the set for 3 seconds or more to switch to normal
standby mode first before proceeding with the procedures below.
D
o
n
o
t
p
u
t
i
n
d
i
r
e
c
t
s
u
n
l
i
g
h
t
o
r
a
p
r
o
l
o
n
g
e
d
p
e
r
i
o
d
5
6
In standby mode, press and hold CLOCK on the remote control.
➜ SET CLOCK is displayed briefly.Then, the clock digits for the hours flash.
Press 9on the remote control to select clock mode.
➜"12 TO 24 HOUR" or "24 TO 12 HOUR" scrolls once.Then, the clock
digits for the hours continue to flash.
Adjust VOLUME -/+ (or press VOL +/- on the remote control) to set the
hours.
Press CLOCK again.
➜The clock digits for the minutes flash.
Adjust VOLUME -/+ (or press VOL +/- on the remote control) to set the
minutes.
Press CLOCK to confirm the time.
MCM394 QUG_Eng 2007.12.20, 2:21 PM3

Enjoy
C
1
2
3
Insert the USB device’s USB plug into the socket on the set.
Press SOURCE once or more (or USB on the remote control) to select USB.
Play the USB’s audio files as you do with the albums/tracks on a CD.
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this Hi-Fi system).
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
CRoyal Philips Electronics N.V. 2007
All rights reserved.
PDCC-0751 Eng
Programming and tuning to
radio stations
1
2
3
Press SOURCE on the front panel repeatedly (or TUNER on the
remote control) to select the tuner source.
Press PROG for more than two seconds to program all available
stations in order of waveband.
Press ALBUM/PRESET 4or 3until the desired preset station is
displayed.
MCM394 QUG_Eng 2007.12.20, 2:21 PM4