Philips MCM726/12 User manual

1
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
2
User Manual
FM antenna MW antenna Remote Control
Quick Start Guide
Quick Start Guide
User manual
MCM726
Pull out the plastic
protective sheet
before use.
MCM726 QUG_Eng 3/20/07, 5:36 AM1

Connect the speaker cables.
Connect the MW and FM antennas.
Connect the power cable of the system.
1
2
3
Tip
See the User Manual for how to connect other
equipment to this system.
Speaker
(right)
Speaker
(left)
AC power cord
FM wire antenna
MW loop
antenna
B
D
C
A
MCM726 QUG_Eng 3/20/07, 5:36 AM2

Enjoy
C
Playing a disc
1
2
3
Press OPEN/CLOSEçto open the disc tray and load in a disc, then press the same
button again to close the disc tray.
➜Make sure the label side of the disc is facing up.
Press ÉÅ to start playback.
To stop playback, press 9.
Setting the clock
1
2
3
4
In standby mode, press and hold RDS/CLOCK SET on the system.
When the hour digits flash, turn the VOLUME control on the front panel to
set the hours.
Press RDS/CLOCK SET again and the minute digits flash.Then turn the
VOLUME control on the front panel to set the minutes.
Press RDS/CLOCK SET again to confirm the time setting.
IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO
POWER
22
22
2 on the set for 3 seconds or more to switch to normal standby
mode first before proceeding with the procedures below.
D
o
n
o
t
p
u
t
i
n
d
i
r
e
c
t
s
u
n
l
i
g
h
t
o
r
a
p
r
o
l
o
n
g
e
d
p
e
r
i
o
d
MCM726 QUG_Eng 3/20/07, 5:36 AM3

Enjoy
C
1
2
3
Insert the USB device’s USB plug into the socket on the set.
Press SOURCE once or more to select USB (or USB on the remote control).
Play the USB’s audio files as you do with the albums/tracks on a CD.
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this Hi-Fi system).
Tip
Detailed playback features and additional functions are described in the
accompany owner's manual.
CRoyal Philips Electronics N.V. 2007
All rights reserved.
http://www.philips.com PDCC-JS/JW-0608 GB
Programming and tuning to
radio stations
1
2
3
Press SOURCE repeatedly to select the tuner source.
Press PROGRAM for more than two seconds to program all
available stations in order of waveband.
Press 4or 3until the desired preset station is displayed.
MCM726 QUG_Eng 3/20/07, 5:36 AM4