1
Installation guide | PH-T500N/T500N
Warning and caution
• Cut o power before the installation. Risk of electric shock.
• All servicing should be performed by qualied personnel only.
• To avoid electrical overload, total connected lamp load (factory and eld installed) should not exceed output rating
• Shut o AC power to branch circuits to which units will be connected. All wiring should be per N.E.C. Articles 501-4(b) and local codes.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by unauthorized personnel.
• The use of any accessory equipment not provided by the manufacture is not recommended as it may cause unsafe conditions.
• Do not use this equipment for other than intended use.
• Do not let supply cords come in contact with hot surfaces.
• Do not mount near gas or electric heaters.
PH-T300N/T500N
Installation guide
Prior to performing the installation, please carefully read the below information and follow all safety instructions.
This instruction applies to models PH-T300N and PH-T500N
