Pico Macom TSMS-5/8RK User manual

TSMS-5/8RK
Rack-Mounted 14V/18V Satellite Multiswitch
www.picomacom.com
Headend & Electronics
355 Parkside Drive San Fernando, CA 91340
Ph: 818-493-4300 Toll Free: 800-421-6511 Fax: [phone]
FAB
Rev.07/05
Pico Macom’sTSMS-5/8RK rack-mounted satellite multiswitche can be used in
every SMATV application requiring satellite 950-2150MHz IF distribution. The easy
mount enclosure and all rear panel connections provide for rack mounting or quick
and easy wall mounting by simply turning the unit face to the wall. The TSMS-5/8RK
is compatible with DIRECTV phase three dish reception systems by allowing 4 LNB
inputs and 1 antenna and providing 8 outputs. A constant 22 kHz tone is provided on 2
of the input ports and 14 or 18 dc volts are provided to power the LNB and conduct
internal switching. The advanced circuit design incorporates a pin diode matrix to route
any of the inputs to any of the outputs by utilizing the 13-14V Right-Circular/Vertical or
17-18V Left-Circular/Horizontal switching control supplied by the satellite receivers,
thus eliminating digital artifacts that result from mechanical relay switching. To com-
pensate for insertion loss, the TSMS-5/8RK uses separate built-in amplifiers for
satellite and/or VHF/UHF signals. The TSMS-5/8RK will supply power to the LNBs
reducing heat build up within the multiswitch and prolong the life of the unit.
Rack-Mounted 14V/18V Satellite Multiswitch
TSMS-5/8RK
Wide frequency range, 40-2150MHz
Compatible with All DIRECTV
satellite dish reception systems
including those with incorporated
switching
Simple interface design provides 2
or 4 satellite polarity inputs and 8
or 16 outputs, for quick installation
All rear panel connection access
allows rack or wall mount flexibility
PIN diode matrix reduces polarity
transfer time and digital artifacts
providing consistent picture quality
Polarity is selected by receiver
supplied voltage (14V/18VDC)
compatible with most DTH
satellite services
Antenna signal combines with
satellite on output eliminating
external combining, reducing
cost and clutter
Built in DC power insertion
reduces cost by providing for LNB
power from the multiswitch
Built-in amplifier compensates for
insertion losses reducing need of
external amplification
External UL Approved power
supply reduces heat buildup thus
increasing unit life

Product Specifications
Rack-Mounted 14V/18V Satellite Multiswitch
TSMS-5/8RK
www.picomacom.com
FAB
Rev.07/05
355 Parkside Drive San Fernando, CA 91340
Ph: 818-493-4300 Toll Free: 800-421-6511 Fax: [phone]
Specifications Subject to Change © Copyright 2005 Pico Macom, Inc.
Specifications
Frequency Range 54-2150 MHz
Antenna In 54-806 MHz
Satellite In 950-2150MHz
Insertion Loss
(Antenna In) -3.0 dB max. 54-806 MHz
(Satellite In) -3.0 dB max. 950-1750 MHz
-5.0 dB max. 1751-2150 MHz
Isolation
Cross Polarization -35 dB min. 950-1450 MHz
-30 dB min. 1451-2150 MHz
Out to Out -40 dB min. 950-2150 MHz
Sat In to Sat In -45 dB min. 950-2150 MHz
Stop Band Attenuation 15 dB min. Ant port @ 950 MHz
15 dB min. Sat port @ 806 MHz
ReturnLoss
Input / Output -7 dB min. 40-806 MHz
-12 dB min. 950-2150 MHz
Input Capability
1dB Compression
Antenna In 106 dBµV min. at 67.25 MHz Input
Satellite In 108 dBµV at 950 MHz Input
LHCP/RHCP
Switching Point 14.0 – 15.0 Vdc
22kHz
Switching Point 150 – 300mVp-p Square Wave Test Signal
Output 22kHz Signal 22 ±4 kHz
Characteristic
Frequency Amplitude 650 ± 250 mV p-p
Impedance 75 ohms All Ports
Adaptor Power
Power Input 115 Vac ±10%, 60 Hz
Power Output 24 Vdc, 1 A
Dimensions 19˝(L) x 3.0˝(D) x 1.75˝(H)
Weight 4.8 lbs.
Ordering Information
TSMS-5/8RK DIRECTV Phase 3 ODU Compatible 5 Input 8 Output
Front View
Rear View