Pifco PE201 User manual

GAS
HEATER
MODEL PE201
YOUR SAFETY &
INSTRUCTION MANUAL
PLEASE READ CAREFULLY
www.pifco.co
This product is not suitable for primary heating purposes.

2
CUSTOMER SUPPORT TEAM: [phone]
TECHNICAL DATA
Description: Gas Heater
Model: PE201
Gas Heat Input: 4.1kW
Gas Category: Butane I3+ (28-30)
Gas Pressure: 28~30mbar
Pin Code: 0845CP-0098
DOCUMENTATION
We declare that this product conforms to the following product legislation in accordance with the
following directive(s):
2016/426 (GAR) Gas Appliances Regulation (EU)
RK Wholesale LTD Quality Assurance, United Kingdom
WARRANTY
This product is guaranteed for 12 months from the date of original purchase. If any defect arises due
to faulty materials of workmanship, the faulty products must be returned to the place of purchase.
Refund or replacement is at the discretion of the retailer.
The following conditions apply:
• The product must be returned to the retailer with proof of purchase.
• The product must be installed and used in accordance with the instructions contained in this
instruction guide.
• It must be used only for domestic purposes.
• It does not cover wear and tear, damage, misuse or consumable parts.
• RK Wholesale LTD has limited liability for incidental or consequential loss or damage.
• This guarantee is only Valid in the UK and Eire Only.
An extended warranty is available for this appliance.
See back page for details.

3
www.pifco.co
PRODUCT SAFETY
When using any electrical appliance, basic safety precautions should
always be followed including the following:
• Please ensure that the appliance
is used on a stable, level, and
heat resistant surface.
• DO NOT leave the appliance
unattended while it is operating.
• Close supervision is necessary
when any appliance is used by
or near children or pets.
• This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge
if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• Children shall not play with the
appliance.
• Cleaning and user maintenance
shall not be made by children
without supervision.
• The use of accessory
attachments is not
recommended by the appliance
manufacturer, apart from those
supplied with this product.
• DO NOT use this product for
anything other than its intended
use.
• This appliance is for household
use only.
• DO NOT use the appliance
outdoors.
• Always ensure that the heater is
placed on a rm level surface.
Ensure that the heater is not
positioned close to curtains,
furniture or any combustible
materials as this could create a
re hazard.
• The heater must not be located
immediately below a mains
socket outlet.
• DO NOT cover the heater as this
may lead to a re risk.
• DO NOT obstruct any of the
openings of the heater.
• DO NOT insert any object
through any openings on the
heater.
• Check all inlets and outlets from
time to time for accumulated
dust.
• DO NOT use the heater in
areas where ammable liquids
are stored or where ammable
fumes may be present.
• DO NOT leave on overnight.
• Always unplug the heater and
allow it to cool before moving it
from one location to another.

4
CUSTOMER SUPPORT TEAM: [phone]
• DO NOT attempt to dismantle
or repair any part of the heater.
This should only be done by a
qualied service agent.
• Your heater should be checked
manually by a qualied person
for safe operation and to detect
any fault.
• Turn o the gas container valve
after use.
• The appliance is suitable for
a 15kg LPG container. When
changing the gas container
move the appliance to a
ame-free well ventilated area.
• DO NOT move the appliance
when in operation or when
cooling.
• Avoid twisting the gas hose
as this may cause the hose to
stress and fracture.
• Turn o the regulator and
disconnect the regulator from
cylinder.
• Turn heater to control fully o
position before removing and
replace the cylinder
• DO NOT attempt to remove the
regulator while the heater is still
running.
• Always face the heater towards
the centre of the room.
• Use it only in a well-ventilated
room. This is vital for the ecient
performance of this heater and
for safety of the occupants of
the room in which it is being
used.
• Allow plenty of fresh air in,
never seal up the doorways and
windows.
• The normal dress guard only
protects against accidental
clothing contact.
• DO NOT place clothes or other
material on the heater.
• Keep all ammable materials at
least one meter away from the
heater.
• Never use or store solvents
and pressure pack cans near a
gas heater-even if the heater is
turned o.
• Never dispose of rubbish such
as cigarette butts in a gas re-
this can aect combustion and
produce dangerous pollutants
and carbon monoxide
• Always operate the gas control
and cylinder valve from the side
or rear of the heater. Standing in
front of the heater exposes you
to the risk of burns

5
www.pifco.co
• In the event of a gas leak open
all doors and windows and DO
NOT use electrical equipment
as these may produce a spark
which could ignite the LPG
vapours. Keep the power cord
and heater away from heated
surfaces.
• If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualied persons in
order to avoid a hazard.
• The heater must not be located
immediately below a socket-
outlet.
• The heater should not be used
in a room of which the oor area
is less than 5m2.
TESTING GAS FOR LEAKS:
• If you suspect that the heater is
leaking, turn o the gas supply
and have the unit inspected by a
qualied technician.
• DO NOT attempt to locate the
source of leak with a naked
ame. Locate a leak by sound,
smell or by applying soapy
water, bubbles will form and
indicate the site of the leak.
• Always change the LPG cylinder
in well ventilated area, and away
from any source of ignition such
as a lighted candle or cigarette.
• DO NOT use electrical items
such as kettles, lights cookers
they may produce electrical
sparks.
• Please be advised the regulator
provided is the UK standard
regulator and may require
changing in dierent countries
as the connection on the gas
bottle may be dierent to that
of the UK If you have any doubt
please contact your local gas
bottle retailer for advice.
• In the unlikely event the
appliance develops a fault,
stop using it immediately and
seek advice from the Customer
Support Team.
HIGH VOLTAGE HOT SURFACE DO NOT COVER

6
CUSTOMER SUPPORT TEAM: [phone]
WHAT’S IN THE BOX
Instruction Manual
Gas Heater
Regulator Valve
1. Ceramic Heating Plates
2. Piezo Quartz Ignition Button
3. Temperature Controls
4. Moving Handle (one on each side)
BEFORE YOUR FIRST USE:
1. Remove your appliance from the packaging.
2. Connect an approved gas bottle to the appliance as per the user instructions.
3. Your appliance is now ready for normal use.
Dispose of the packaging in a responsible manner.
4
1
2 3
Typical U.K. Regulators Other Types of Regulators which can be used
in countries such as Ireland and Spain

7
www.pifco.co
USING YOUR APPLIANCE
Installing the gas bottle:
1. Put the
cylinder
into the gas
heater then
install the
protection
bae to
make sure
the cylinder
is not
displaced
when it is moved from room to room.
2. Connect the pipe to the gas valve with the
cap (make sure there is no leakage).
3. Connect another side of the pipe to the
regulator with the cap (make sure there is
no leakage).
4. Before using the heater, open the gas
valve, and close it after you are nished.
Press the “SWING” BUTTON to distribute
heat evenly around the room.
Lighting the heater:
1. Open the gas cylinder by turning the gas
cylinder valve anticlockwise.
2. Turn the gas control knob on the heater to
setting 1.
3. Press the control knob down and hold in
the pressed condition.
This will allow gas to ow to the pilot and
centre burner.
4. While holding the control knob in the
pressed position push the piezoelectric
ignition button 2 or 3 times. Each time
you strike this piezoelectric ignition you
will hear a clicking sound as well as see a
spark on the pilot burner.
5. Once the pilot has lit, continue holding the
gas control knob in the pressed position
for a further 10 to 15 seconds thus
activating the ame failure safety device.
6. The pilot and centre burner should remain
alight.
7. You may now adjust the heater setting to
Low/Med/High as required.
Turning o the heater:
1. To turn o the heater,
turn the control knob
to position 1 and
close the gas cylinder
valve by turning the
knob on the cylinder clockwise.
2. Ensure that the pilot ame in the centre
burner is extinguished.
Fitting the Irish Regulator:
1. Ensure that the ame marked on the
switch is not showing when connecting
and disconnecting.
2. Use one hand to pull up the black safety
release around the base of the regulator,
and push the regulator on to the top of
the gas bottle with your other hand.
3. Release the safety and ip the switch on
top of the regulator, so the ame symbol is
showing. When this is done correctly you
will hear it pressurise.
Regulators:
1. The type of regulator that is used is
dependant on the connection on the
gas bottle used. This may be dependant
on gas supplier and your geographical
location.
2. If you are unsure which type of regulator
you will need seek advice from your gas
supplier. Please see opposite.
Removing the Regulator:
1. Check that the temperature control is set
to ‘0’.
Piezo Quartz Ignition Button
And Temperature settings

8
CUSTOMER SUPPORT TEAM: [phone]
2. Push the supply lever on the valve down
so it is horizontal and the gas ow is
stopped.
3. Beneath the level is the release button.
Press this rmly and lift away the valve.
4. If the cylinder has a dust-cap secure it
now.
Removing Irish Regulator Fittings:
1. Make sure that the regulator switch is
ame side down (ame not visible).
2. Place your ngers around the bottom
of the valve and rmly pull up. This will
release the valve.
3. If the cylinder has a dust-cap secure it
now.
CLEANING AND CARE
• Ensure that the unit is cool enough to
work on.
• To remove the dust, wipe the appliance
with a dry cloth
• Never use abrasive powders or solvents.
• If the heater shows any signs of wear or
damage disconnect immediately from
the gas supply, do NOT use it – have it
checked by a suitably qualied person.
WARNING:
DO NOT IMMERSE THE UNIT IN WATER

9
www.pifco.co
Information requirements for Gaseous/ Liquid Fuel Local Space Heaters
Model identier(s): PE201
Indirect heating functionality: [NO]
Direct heat output: 4.1(kW)
Indirect heat output: N/A (kW)
Fuel Space Heating Emissions (*)
NOx
Select fuel type [gaseous] [specify] 33 [mg/ kWh input] (GCV)
Item Symbol Value Unit Item Symbol Value Unit
Heat Output Useful Eciency (NCV)
Nominal heat
output Pnom 4.1 kW
Useful eciency
at nominal heat
output
ηth,nom 100 %
Minimum heat
output (indicative) Pmin N/A kW
Useful eciency
at minimum heat
output (indicative)
ηth,min N/A %
Auxiliary Electricity Consumption Type of Heat Output/Room Temperature Control
(select one)
At nominal heat
output elmax N/A kW
Single stage heat output, no room temperature
control [NO]
At minimum heat
output elmin N/A kW Two or more manual stages, no room temperature control [YES]
In standby mode elSB N/A kW With mechanic thermostat room temperature
control [NO]
With electronic room temperature control [NO]
With electronic room temperature control plus
day timer [NO]
With electronic room temperature control plus
week timer [NO]
Other Control Options (multiple selections possible)
Room temperature control with presence
detection [NO]
Room temperature control with open window
detection [NO]
With distance control option [NO]
With adaptive start control [NO]
With working time limitation [NO]
With black bulb sensor [NO]
Permanent pilot ame power requirement
Pilot ame power
requirement
(if applicable)
Ppilot 0.2 kW
Contact Details RK Wholesale LTD., Sutton House, Berry Hill Road, Stoke-on-Trent, ST4 2NL
www.rkwltd.com; [email protected]

10
CUSTOMER SUPPORT TEAM: [phone]
NOTES

11
www.pifco.co
NOTES

1112.V8
We hope you enjoy your appliance for many years.
As a thank you for purchasing one of our fantastic products,
we are oering you an extra 2 year peace of mind.
*To receive your extra guarantee period, register your appliance online
within 28 days of purchase by visiting:
www.pifco.co
Make sure to retain your original receipt.
Should you have a problem
with your appliance or need any spare parts please call our
Customer Support Team on:
[phone]
Distributed throughout the UK by RK Wholesale LTD