Pignology Piglet User manual

Piglet
Quick Start
Version 1.0A
© 2013 Nicholas Garner, N3WG, Pignology, LLC
Table of Contents
Document Overview
Copyright Notice
Terms of Use and Liability Waiver
Community Support
Quick Start

Connect Wifi
Rig Control
Revision History
Document Overview
This document serves to walk Piglet owners through a quick start of using the device in pictorial
format. The perspective of this guide is from the point of view of a user who has just
unpackaged the Piglet. While this guide is from the perspective of Apple iOS on iPad, the
concepts are the same for iOS and similar for Android/Mac OSX using HamLog.
Copyright Notice
Copyright © 2013 by Pignology, LLC.. All rights reserved.
Community Support
A Yahoo Group has been created for Pigtail/Piglet. Please consider joining the group to receive
information about updates, ask questions or report problems. If you know the answer to a
question posed by another user, please feel free to help out.
Pigtail Yahoo Group
Documentation
The full documentation for Piglet can be found here:
http://pignology.net/wiki
Quick Start

Power
Power for the Piglet is supplied via Anderson PowerPoles. The voltage input range is 7-15
volts. There is no on/off switch on Piglet. If power is applied, the device is on.
Connect Wifi
●Open the settings apps on your device.

●Select Wi-Fi on the left.
●You should see a network named “Pigtail”.

●Click on “Pigtail”
●After a few seconds you should see a checkmark show up next to Pigtail.
●If you click the “>” icon on the right, you’ll be taken to the network properties as
shown in the following picture.

●Leave DHCP selected.
●You should see an IP address similar to 10.1.1.11 as shown above.
Rig Control

●Press the Home button on your device and open HamLog

●Click Tools

●Scroll down and select Pigtail

●Select your manufacturer.
●Select the radio model.
●If it’s a KX3 or K3, select/deselect “Use Full Interface”
●Feel free to try it both ways, there are two different views for these two radios.
●After a few seconds the IP address of the Piglet should show up in the table at
the bottom of the screen.
●Click on the IP address of the Piglet.