2. PACKING AND PARTS LIST
Parts List (for A-605R/HY/EW)
Mark No. Description Parts No.
NSP 1BATTERY (R6P, AA) AEX-010
2OPERATING INSTRUCTIONS
(English/German/French/Italian/
Swedish/Spanish/Dutch/Portuguese)
ARE7077
3REMOTE CONTROL UNIT
(CU-A0I3) AXD7053
4SIDE PROTECTOR LAHA7127
5SIDE PROTECTOR RAHA7128
6PACKING CASE AHD7308
NSP 7LITERATURE BAG AHG- 117
8PACKING SHEET AHG10I6
9BATTERY COVER AZN2249
A10 AC POWER CORD ADG1I54
5
3. SCHEMATIC AND PCB CONNECTION DIAGRAMS
NOTE FOR SCHEMATIC DIAGRAMS (Type ia)
1. When ordering service parts, be sure to refer to
"PARTS LIST of EXPLODED VIEWS" or "PCB
PARTS LIST".
2. Since these are basic circuits, some parts of them or the
values of some components may be changed for improve-
ment.
3. RESISTORS:
Unit: k;kQ, M:MQ, or Qunless otherwise noted.
Rated power: 1/4W, 1/6W. 1/8W, 1/lOW unless otherwise
noted.
Tolerance: (F): ±1%, (G): ±2%, (K); ±10%, (M): ±20% or ±5% un-
less otherwise noted.
4. CAPACITORS:
Unit: p:pF or pF unless otherwise noted.
Ratings: capacitor (pF)/voltage(V) unless othrewise noted.
Rated voltage: 50V except for electrolytic capacitors.
5. COILS:
Unit: m:mH or pH unless otherwise noted.
6. VOLTAGE AND CURRENT:
IVi :Signal voltage at rated output.
^Ior V:
DC voltage (V) at no input signal unless otherwise noted.
Value in {)is DC voltage at rated power.
mA or i—mA:
DC current at no input signal unless otherwise noted.
7. OTHERS:
or© :Adjusting point.
•:Measurement point.
•The Arnark found on some component parts indicates the im-
portance of the safety factor of the parts. Therefore, when re-
placing, be sure to use parts of identical designation.
8. SCH-D ON THE SCHEMATIC DIAGRAM:
•SCH-D indicates the drawing number of the schematic dia
gram. (SCH stands for schematic diagram.)
9. SWITCHES (Underline indicates switch position):
FRONT LASSY
5701 :POWER STANDBY/ON
5702 :LOUDNESS
5703 :SPEAKER A
5704 :SPEAKER B
FRONT RASSY
5601 :INPUT SELECTOR
5602 :REC SELECTORfSOURCE/OFF/CPyTUNER)
5603 :TAPE2 MONITOR
5604 :DIRECT
5605 :MUTING
NOTE FOR PCB DIAGRAMS
1.Part numbers in PCB diagrams match those in the schematic
diagrams.
2. Acomparison between the main parts of PCB and schematic
diagrams is shown below.
6
