Pioneer AVIC-EVO1-DT2-C-GR User manual

INSTALLATION MANUAL
1 2
34
6
4
Cut as shown in the pictures 2-3-4.
BEFORE
5
AFTER
ATTENTION!
If necessary cut (20mm) as shown in the
picture 6.
If the dashboard does not have plastic flaps,
then no cutting is needed.
BEFORE
AFTER
20mm

78
910
Insert the brackets as shown in the pictures 7-8-9.
Before tightening the screws, put the
installation jig in place, as shown.
Insert the jig in the indicated square holes.
Fix the two screws for each bracket as shown
in the pictures 12A and 12B.
11
12 A
12 B

13 14
Connect the connectors of picture 13 to the
facia plate and insert it.
16
Attention! If you want remove to the facia plate:
1) remove the bottom (17A);
2) remove the top (17B);
Please note: to avoid damaging the facia plate, it is
preferable to use teflon tools as shown in this
manual. It also possible to use other tools but it is
safer to cover them with a rag.
15
17 B
Before inserting the radio unit in the
dashboard put the keys connectors in the
position as shown.
Insert the radio unit in the dashboard tunnel
and fit it with the two screws for each side as
shown in the pictures 14-15.
17 A
17 A
17 B

Find the two indicated connectors in the fuse box near the steering wheel column.
Open the green connector as shown; the supplied Violet/White wire must be connected to PIN n°4.
If other wires are already occupying this PIN, they must be spliced with the supplied Violet/White
wire.
Open the Black connector as shown; the supplied Pink wire must be connected to the PIN n°56.
Attention! To install the vehicle adapter, please follow the shown steps: