Pioneer PDP-5060HD User manual

PDP-5060HD 50” HIGH DEFINITION PLASMA TELEVISION
• High Definition XGA Resolution (1,280 x 768p)
• 50” Diagonal / 16:9 Wide-Screen Aspect Ratio
• Brightness: 1,100 Cd/m2
• Contrast: 4000:1
PANEL TECHNOLOGY
•Deep Encased Cell Structure - This energy
efficient design allows each pixel to deliver a
more concentrated beam of light, for truer color
and brighter images.
•Crystal Emissive Layer panel technology for
dynamic color and contrast, deeper black colors
and increased brightness.
•1st Surface Pure Color Filter for enhanced
contrast and accurate color reproduction. The
non-glass filter is bonded directly to the plasma
panel reducing light reflection and refraction for a
more accurate image.
Media Receiver and
Table Top Stand Included
VIDEO PROCESSING TECHNOLOGY
•Pure Drive II Signal Processing – Full Time 10-bit
Digital Video Processing delivers a low noise, high
contrast, natural color image.
–New ACE IV (Advanced Continuous Emission)
for billions of color reproduction and improved
grey-scale rendering in dark picture areas.
–Advanced Pure Cinema with 3:3 pull down,
film-based material on DVD, videotape or even
regular TV will match the smooth and natural
reproduction seen in a movie theater.
–Color Temperature Adjustment - 3 Settings
(high / mid / low)
–Digital Noise Reduction - 4 Settings (off / high /
mid / low)
–MPEG Noise Reduction
–Digital CTI (Color Transient Improver)
–Natural Resize
–Natural Enhancer
–Digital Croma Decoder - 10-bit
CONVENIENCE FEATURES
•Separate Media Receiver for advanced connectivity
and flexible set-up. All source products connect directly
to the media receiver, which connects to the plasma
panel with one proprietary digital interface cable.
•Built-in TV Tuners for receiving over-the-air High
Definition and Standard Definition broadcasts.
- Dual NTSC tuners and ATSC tuner
- Digital Cable Ready (DCR) with CableCARDTM
Interface
•TV Guide On Screen
®
Interactive Program Guide for
easy navigation of TV program services
•Wide Viewing Angle (160 Degree – Horizontal and
Vertical)
•Split Screen / Picture in Picture display modes to view
multiple sources at one time.
•A/V Selection Memory - 5 Settings (Standard /
Dynamic / PURE / Movie / Game / User)
•V-Chip Parental Control (Supporting MPAA & TV
Parental Guidelines)
•Aspect Ratio Control (5 position – Wide / Zoom /
Cinema / Full / 4:3) – “Dot by Dot” for PC
• Full Function Preset and Learning Remote Control

PDP-5060HD 50” HIGH DEFINITION PLASMA TELEVISION
OTHER
• Table Top Stand (supplied)
• 3-Meter Digital Connection Cable (supplied)
• Wall Bracket, Tilt Wall Bracket (optional)
• 10-Meter Digital Connection Cable (optional)
• 30-Meter Fiber Optic Connection Cable (optional)
PRODUCT DIMENSIONS
• Display (W x H x D): 48.2” x 28.2” x 3.6”
• Display weight: 70.1 lbs
• Media receiver (W x H x D): 16 9/16” x 3 9/16” x 11 13/16”
• Media receiver weight: 9.9 lbs
CARTON DIMENSIONS
• W x H x D: 60.56” x 43.56” x 19.94”
• Carton weight: 152 lbs.
UPC
• 012563011959
VERSATILE VIDEO AND AUDO CONNECTIVITY
•Inputs:
– Antenna F Connections x 2 (1-Digital & Analog / 1-Analog)
– HDMI with HDCP x 2
– Component x 3 (2 on rear / 1 on front)
– AV Composite x 3 (2 on rear / 1 on front)
– S-Video x 3 (2 on rear / 1 on front)
– i.Link x 2 (for use with DVHS)
– D-Sub for PC x 1 (front)
– SR In x1
– CableCARDTM Interface (rear)
•Outputs:
– Optical Audio Output x 1
– Subwoofer Output x 1
– Monitor Output x 1 (composite)
– SR+ Output x1
SOUND TECHNOLOGY
• 13 watt stereo amplifier with separate bass and treble controls x 2
• 2-Way Stereo Speakers
• SRS
®
/ FOCUSTM / TruBass Surround Sound Audio Processing
for a virtual sound TV Experience
• Specifications and design subject to modification without notice.
• High-Definition Television (HDTV): HDTV refers to a complete
product/system with the following minimum performance attributes:
- Receiver: Receives ATSC terrestrial digital transmissions and decodes
all ATSCTable 3 video formats.
- Display Scanning Format: Has active vertical scanning lines of 720
progressive (720p), 1,080 interlaced (1,080i) or higher.
- Aspect Ratio: Capable of displaying a 16:9 image.
- Audio: Receives and reproduces, and/or outputs Dolby Digital audio
(Consumer Electronics Association, August 2000).
• Displaying the same still images for long periods should be avoided as image
shadowing or burn-in may occur.
• Plasma Display Systems display images consisting of hundreds of thousands
of minute pixels (light emitting cells), and there is a possibility that some
pixels may be inactive, flashing or continually illuminated.
• Plasma Display Systems are made of glass; be sure to secure it from damage
from impact.
• Plasma Display Systems, while in use, may generate some functional sounds,
for example: fan motor noise, and electrical circuit humming/glass panel
buzzing. The Plasma Display System Media Receiver uses an on-board
cooling fan. If the ambient temperature of the Media Receiver becomes high,
the speed of the cooling fan increases and it may sound louder than normal
during the cooling period.
• Plasma Display Systems emit slight amounts of IR (Infrared Emission) through
luminous discharge technology. This IR is not harmful to living organisms, but may
interfere with the operation of remote controls for other equipment, or cause static in
equipment using IR (such as cordless headphones or cordless microphones).
• PIONEER, the Pioneer Logo, and PureVision are registered trademarks of Pioneer
Corporation.
• CableCARD™ is a trademark of Cable Television Laboratories, Inc.
• *Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.
• HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or
registered trademarks of HDMI Licensing LLC.
• i.LINK and the i.LINK logo are trademarks of Sony Corporation.
• SRS WOW, SRS and the symbol are trademarks of SRS Labs, Inc.
• SRS, TruBass and FOCUS are trademarks of SRS Labs, Inc.
• In the United States, TV Guide and other related marks are registered marks of
Gemstar-TV Guide International, Inc. and/or one of its affiliates.
• All phosphor-based display systems (CRT Television Systems - both direct
view and projection televisions - as well as plasma display systems) may
possibly have image retention, also known as burn-in. Recommended
guidelines are as follows:
- Do not display still images for long periods (such as fixed images from
PC or TV game equipment, and/or time of day indicator or channel
logo display).
- Do not display content in the 4:3 aspect ratio (black or gray bars on left
and right side of content) or letter-box content (black bars above and
below of content) for extended periods of time, or use either of these
viewing modes repeatedly within a short period of time. This Plasma
Display System is equipped with multiple wide-screen viewing modes;
use one of these screen modes to fill the entire screen with content.
- Displaying dark images after displaying still images for a period of
time may cause image retention. In most cases, the image retention can
be corrected by displaying bright images for a similar period of time.
However, if your Plasma Display System displays still images for
additional long periods of time, image retention may be irreparable.
• Plasma Display Systems may have a negative effect on sound or images
coming from AM radios, PCs or video-related products.