Pipe Decor 365 ET30 User manual

Parts List:
H- SCREWS (16 PCS)
E- 4 X FEET
PREPPING THE PIPE
VERY IMPORTANT: These are all authentic malleable iron
and require necessary cleaning and prepping; do not skip
this step.
1. Clean and dry all the parts with gentle soap.
2. Use a lint-free rag to apply metal polish to the parts.
3. Use metal polish or clear coat paint to seal the dry pipe.
RECOMMENDED
DRILL WITH 1/4” BIT
FOR WALL ANCHOR
RECOMMENDED TOOLS
FOLLOW DIRECTIONS IN ORDER. LEGS WILL BE MORE DIFFICULT TO BUILD IF
NOT DONE IN THE CORRECT ORDER
This is industrial grade authentic pipe. It comes covered in anti-rust oil. They are dirty to the touch but
can be cleaned and sealed to prevent rust and be clean to the touch. See Clean and Seal sheet for
ways to clean and seal the pipe.
1. Connect Street elbows (B) to the ends of each 8” pipe (C) and 10” pipe(D).
2. Connect the feet (E) to the 10” bottom section.
ONLY USE THREAD LOCKER FOR STEP 2 BETWEEN THE ELBOWS AND THE 5-WAY
3. Connect the 10” sections to the 5-way (A) using threadlocker. Tighten as much as you can
by hand. Then un-tighten until they are pointing down and level with each other. Wait 1 hour
for the threadlocker to set. The legs will now be sturdy and in the correct position.
4. Connect the flanges (F) to the 8” upper section.
5. DO NOT USE THREAD LOCKER ON THIS SECTION. Connect the 8” pipe sections to the
5-way(A). Tighten as much as you can. Then un-tighten until they are in pointing up. It is okay
if they are loose. They will be connected to the table top and be secure.
6. Connect both sections with the 1.5” (G) Connector.
7. Screw the flanged side to a table while flipped upside down.
Feet may scratch a hardwood floor and pads are recommended.
C- 4 X 8” PIPE
8” PIPE
A- 2 X FIVE WAY B- 16 X STREET ELBOWS
D- 4 X 10” PIPE
G- 1 X 1.5” CONNECTOR
F- 4 X FLANGES (3” OD)
10” PIPE
D
1.5” CONNECTOR
G
F
C
A
B
E
365 ET30
THANK YOU SO MUCH FOR PURCHASING A PIPE DECOR PRODUCT. IF YOU HAVE ANY TROUBLE PUTTING YOUR KIT
TOGETHER OR MISSING PIECES PLEASE CONTACT [e-mail] FOR ANY HELP AND RETURNS.

STEPS 3
STEPS 1
STEPS 3 USE THREAD LOCKER TO SECURE
LEGS IN STRAIGHT DOWN POSITION.
REPEAT FOR EACH LEG.
X4
8” PIPE
X4
10” PIPE
STEPS 2 & 4
365 ET30
THANK YOU SO MUCH FOR PURCHASING A PIPE DECOR PRODUCT. IF YOU HAVE ANY TROUBLE PUTTING YOUR KIT
TOGETHER OR MISSING PIECES PLEASE CONTACT [e-mail] FOR ANY HELP AND RETURNS.