PLANET BEYOND EVR01 User manual

colour. Once it is fully charged,
it will stop blinking.
EVR01/02/03 True Wireless Earbuds
Quick Start Guide (EN)
What’s in the box
Connecting Your Device Controls
Multi-functional Button
Earbuds (L/R)
Charging Case
Eartips (S/M/L/S+/M+/L+)
USB Type C Cable (5V/2A)
Quick Start Guide
1) Enable bluetooth on your device.
2) Opening the case turns the
earbuds on and enter pairing mode.
3) Select “Planet Beyond EVR” on
your phone to pair.
Powers down after 3 minutes of inactivity. Press and
hold to power on.Music Playback Control
Left:
Press 1X: Play / Pause
Press 2X: Previous Track
Long Press: Volume Down
Right:
Press 1X: Play / Pause
Press 2X: Next Track
Long Press: Volume Up
Calls and Smart Assistant Control
Press 1X: Answer / Hang Up Call
Press 2X: Reject Call
Press 3X: Siri / Google Assistant
Charging Case Light Indicators Earbuds Battery Level Indication
Charging case battery level:
More than 70%: Green
Between 31% -70%: Orange
Between 11% - 30%: Red
Less than 10%: Flashing Red
While the case is being charged,
the light will blink in its respective
Earbuds battery level:
A low battery tone will sound
when the battery level low.
Status in charging case:
Charging: Breathing white light
Fully charged: Light o
Charging the case Storing the accessories
1) Connect the USB-C cable to the port
at the back of the charging case.
2) The casing and earbuds can be
charged simultaneously.
Works with Qi-certied wireless charger.
The casing is able to slide in both
directions. To store your
accessories, slide the casing
downwards and slot the
accessories into the compartment.
Ensure that the accessories sit
nicely inside the case. If it sticks out,
it will aect the closing of the case.
Scan here from instructional videos
and warranty registration.
31 Hudson Yards New York, NY 10001
Main Oce: Planet Beyond LLC
31 Hudson Yards New York, NY 10001

EVR01/02/03 True Wireless Earbuds
Quick Start Guide (EN)
FCC ID: 2A3P7-PBEVRFCC ID: 2A3P7-PBEVR
FCC Caution (FCC ID: 2AX2J-PBEVR)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Technical Specications
Driver diameter: 8.0mm
Frequency response: 20-20kHz
Sensitivity: 103 dB (at 1kHz)
Impedance: 32 ohms
Battery (Earbud L/R): 3.7V, 60mAh
Battery (Charging Case): 3.7V, 750mAh
Battery life (Earbud): up to 8 hours
Battery life (with Charging Case): up to 48 hours
Weight of Earbud: about 8.5g (L), about 8.5g (R)
Weight of Charging case: about 60g
Operating temperature: 0-70 degrees
Microphone Sensitivity: -42dB
Microphone Frequency Response: 100Hz - 10kHz
Operating Frequency: 2402 - 2480MHz
RF Output Power: <3.25dBm
Bluetooth Version: 5.2
Operating Range: up to 10 meters
USB cable for charging: USB Type A – USB Type C
Eartips: S, M, L, S+, M+, L+
This manual suits for next models
2