Motorola MOTO BUDS 105 User manual

MOTO BUDS 105
TRUE WIRELESS EARBUDS
For: MOTO BUDS 105
User Guide

Safety instructions
DANGER
To avoid hearing damage, limit the time you use earbuds at
high volume and set the volume to a safe level. The louder the
volume, the shorter the safe listening time is.
WARNING
This true wireless earbuds are compliant with all relevant standards regarding
electromagnetic fields and is, when handled as described in the User Guide,
safe to use. Therefore, always read the instructions in this User Guide carefully
before using the device.
• Listen at reasonable volumes for reasonable periods of time.
• Be careful not to adjust the volume continuously upwards as your hearing
adapts.
• Do not turn up the volume so high that you can't hear what is around you.
• You should use caution or temporarily discontinue use in potentially
hazardous situations.
• Excessive sound pressure from earbuds can cause hearing loss.
• Using earbuds with both ears covered while driving is not recommended
and may be illegal in some areas while driving.
• For your safety, avoid distractions from music or phone calls while in trac
or other potentially dangerous environments.
CAUTION
• Do not expose earbuds to excessive heat.
• Do not drop your earbuds.
• Earbuds shall not be exposed to dripping, splashing water.
• Do not allow your earbuds to be submerged in water.
• Do not use any cleaning agents containing, alcohol, ammonia, benzene, or
abrasives.
• If cleaning is required use a soft cloth, if necessary dampened with a
minimum amount of water or diluted with a minimum amount of water or
diluted mild soap, to clean the earbuds.
• The integrated battery shall not be exposed to excessive heat such as
sunshine, fire or the like.

• Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding
environment can result in an explosion or the leakage of ammable liquid or
gas.
• A battery subjected to extremely low air pressure that may result in an
explosion or the leakage of ammable liquid or gas.
• Replacement of a battery with an incorrect type that can defeat a
safeguard (for example, in the case of some lithium battery types).
Operating temperature and humidity
• Store in a place where temperature is between -20°C (-4°F) to 50°C
(122°F) (up to 90% relative humidity with no condensation).
• Operate in a place where temperature is between 0°C (32°F) to 45°C
(113°F) (up to 90% relative humidity with no condensation).
• Battery life may be shorter in high or low temperature conditions.

Welcome...
to your new MOTO BUDS 105 true wireless earbuds!
• Wireless charging case.
• Up to 14 hours total playtime with the charging case.
• Built-in ENC (Environmental Noice Cancellation) mics for clear voice talk.
• Support Bluetooth LE (Low Energy) audio.
• Touch control for auto on/o and music play/pause.
• Use either earbud individually for call and music playback.
• Lower power consumption to increase battery life.
• Water resistant buds (IPX5).
• Smart voice assistant (Siri®and Google AssistantTM).
• Bluetooth 5.2
Need help?
If you have any problems setting up or using your MOTO BUDS 105, please
visit us at motorolasound.com/support
Alternatively, you may find the answer in the ‘Help’ section at the back of
this guide.

This User Guide provides you with all the information
you need to get the most from your true wireless
earbuds.
Before you make call or listen to music you will need
to set up your true wireless earbuds. Follow the
simple instructions in ‘Getting started’, on the next
few pages.
Got everything?
• Bluetooth true wireless earbuds (with M size earcaps)
• Charging case
• USB-C charging cable (300 mm in length)
• Extra 2 pairs (S and L sizes) of replaceable silicon earcaps
• Quick start guide

6
1. Getting started ................................................................... 7
2. Getting to know your true wireless earbuds...........9
3. Using the true wireless earbuds ................................ 10
3.1 Select the earcaps .......................................................................................... 10
3.2 Wear the earbuds ........................................................................................... 10
3.3 Reconnect the earbuds to your Bluetooth device............................. 10
3.4 Operation .............................................................................................................11
3.4.1 Turn on/o...........................................................................................11
3.4.2 Call control ..........................................................................................11
3.4.3 Music ......................................................................................................11
3.4.4 Activate voice assistant..................................................................11
3.4.5 Restore factory settings................................................................12
3.5 LED status indicators ........................................................................... 12
4. Help........................................................................................13
5. Technical Specifications................................................ 14
6. General information.........................................................15

7
1. Getting started
Location
Important
The earbuds are resistant to dripping and splashing water, but the charging
case is not waterproof. Make sure you wipe o any moisture on the earbuds
thoroughly before putting them into the charging case.
Range of earbuds and the Bluetooth device
Make sure the earbuds and Bluetooth device are placed within range of each
other.
Charging the battery
Important
Warning! Use only the approved rechargeable Lithium polymer battery
supplied with your MOTO BUDS 105.
Charging case
Connect one side of the supplied USB-C charging cable to the Type-C
charging port, and the other side to the USB AC adaptor.
Fig. 2a
20% 100%
The LED indicator flashes red during charging the battery. It turns solid blue
when charging is complete. For the first time use, charge the battery for at
least 5 hours continuously. After the first time charge, it takes approximately 2
hours for a normal charge.
Battery performance
In ideal conditions, a fully charged battery should give up to 6 hours usage
time or up to 50 hours standby time.
The charge capacity of the rechargeable battery will reduce with time as it
wears out, giving the earbuds less usage / standby time.
Battery low warning
If you hear short beeps every 3 minutes, recharge the battery.
Getting started

8
Earbuds
Put the earbuds into the charging case and close the top lid. Charging
starts automatically. The red LEDs on both earbuds turn on until charging is
complete.
Connecting your earbuds
Pair your earbuds with the Bluetooth device for the first time
1. Open the charging case top lid to turn earbuds on.
• The LEDs on both earbuds will flash blue for a second and you will hear
a musical tone.
• Then the LED on one of the earbuds flashes blue every 5 seconds and
the other earbud flashes red and blue alternately. Earbuds enter pairing
mode and you will hear a musical tone.
2. Make sure the Bluetooth function of your device is activated. Earbuds will
do pairing automatically.
3. Select MOTO BUDS 105 from the Bluetooth menu of your device. You
will hear a musical tone when pairing is successful. The blue LED on both
earbuds will flash slowly.
Note
Make sure your device is compatible with Bluetooth and earbuds.
Your MOTO BUDS 105 are now ready for use.
Fig. 2b
MOTO BUDS 105
Fig. 3b
Fig. 3a
Getting started

9
2. Getting to know your true wireless earbuds
Overview
1 Multi-function button (MFB)
2 Microphones/LED indicators
3 Replaceable earcaps (size M)
4 Charging case
5 USB Type-C charging socket
6 Earbud charging contacts
7 Battery level indicator
1
2
3
Fig. 1a
5
4
Fig. 1b
7
6
Fig. 1c
Getting to know your true wireless earbuds

10
3. Using the true wireless earbuds
3.1 Select the earcaps
1. Select from 3 dierent size of replaceable earcaps which fit your ears the
best. The earbuds come with size M attached as default.
2. Fit the earcaps into the earbuds.
3.2 Wear the earbuds
Insert the earbuds into ears and rotate to fit comfortably.
3.3 Reconnect the earbuds to your Bluetooth device
1. Turn on your Bluetooth device with the Bluetooth feature activated.
2. Open the charging case top lid and remove the earbuds to turn them on.
• The earbuds will auto reconnect to the last connected Bluetooth device.
Note
If the earbuds cannot find and connect to any Bluetooth device with 5 minutes,
they will switch o automatically.
Fig. 4a
Fig. 4b
Fig. 4c
Using the true wireless earbuds