Planet Lighting HLS SNAP User manual

HLS SNAP
Wiring Installation Guide
+ve
+ve
+ve
-ve
-ve
-ve
Take care that the wire
insulation is not damaged
on sharp internal burrs
Wire hook
1
2
3-4
TE Coolsplice
connector
• Always use pliers
• Do not strip the
wires
• Ensure wire is
pushed all the way
into the connector
Black
tail
wire
minipuck
HLS | Wiring Installation Guide
1. Run the cable
1. Run red and black wire along rail
for designated circuit, as per wiring
specifications.
• Check that your cable matches or
exceeds the cable specified.
2. Pull the wires out through the hole furthest
from the cable entry point (this is the end of
the circuit).
2. Pull red wire loops
1. At the next hole back from the end of circuit,
pull the red wire 100mm out of the hole,
using a wire hook.
2. Repeat this at every hole.
• Extra red wire will be required.
• Every hole will have a 100mm loop of red
wire pulled through it.
Tip: Use a hook made from stiff wire to pull the
red loops through the holes.
Step 3: Connect end puck
1. Connect the end puck using the UY2
connectors provided.
• Red wire on puck connects to the red
feed wire.
• Black wire on puck connects to the black
feed wire.
Step 4: Connect remaining pucks
On the next hole back:
1. Cut red loop wire protruding from hole.
2. Connect black puck wire to red wire
connected to the previous puck installed
• Check that you have the right wire by
pulling on the wire to trace the direction of
the cable.
3. Connect red puck wire to red wire leading to
the next hole where a puck is to be installed.
4. Repeat steps 1-3 for all remaining holes.

5 - 6
7 - 8
HLS | Wiring Installation Guide
Step 5: Temporarily connect LED driver
1. Connect the drivers positive output to the red puck wire.
2. Connect the drivers negative output to the black return wire
from the end puck.
Step 7: Insert Pucks
1. Push the led puck into the tube
2. Using the alignment tool, ensure the long reflector axis is
parallel to the rail.
Step 8: Confirm system is working
1. Apply power to the driver.
2. Check that ALL pucks are illuminated.
• With pucks installed into the handrail, the system is
ready for extended operation.
Step 6: Confirm system is working
1. Apply power to the driver.
2. Check that ALL pucks are illuminated.
• Only run pucks long enough to confirm
illumination.