SAFETY PRECAUTIONS
• Do not use these walkie-talkies if they are damaged in any way
• Do not use near gas pumps or fuel storage areas
• Do not turn on or use on aircraft or in hospitals
• Operating these devices near a radio may cause interference
• Remove the batteries if devices will not be used for a long period of time
• Never mix new and used batteries
• For best results, direct the antenna upward when in use
• Clean with a damp cloth; do not use solvents or cleaning agents
• Do not modify these devices in any way
• Do not rely on these devices to contact emergency services
WALKIE-TALKIE OPERATING INSTRUCTIONS
ON/OFF BUTTON
Press and hold down the power button (right of LCD screen) for 3 seconds to power
the device on or off - a beep will indicate operation.
VOLUME ADJUSTMENT
Press the up and down arrows (below LCD screen) to adjust volume
up or down. Volume level is displayed on the screen.
BATTERY LEVEL
Look for the battery icon on the LCD screen to check your battery level.
The icon will flash and the device will beep when the batteries need to be
replaced or recharged.
GETTING STARTED & OPERATING INSTRUCTIONS
BELT CLIP REMOVAL/ATTACHMENT
To remove the belt clip, press the tab at the
top of clip and slide upward. To reattach,
slide clip piece down with the clip facing
inward until you hear a click.
BATTERY INSTALLATION
Press down on the back of panel of the unit
and slide the battery cover off (you may
need to remove the belt clip for easier ac-
cess). Insert 4 AAA batteries (not included)
as indicated below. Replace the cover.
