Plum MacR6 N User manual

installaon manual
MacR6 N
1
• 2 - Necessary accessories
• 4 - Watermeter assembly• 3 - SIM card assembly and slot sealing
• Torx T10 screwdriver
• 1 - Set of package
• Watermeter adapter kit
• MacR6 N
• 6 Torx T10 M12 screws
• 2 plasc tack rivets
• H-type silicone gel in syringe
• Smartphone or tablet with NFC support
• Data Loggers Congurator NFC applicaon
– QR code redirects to Google Play store
1. Dismantle the front cover (g. 3.1).
2. Dismantle the SIM card cap, take o the SIM holder (g. 3.2).
3. Install the SIM card according to g. 3.3. Insert the SIM holder inside
the socket.
4. Using the syringe seal the surface of the SIM holder and the cap inside
– g. 3.4 & 3.5.
5. Put the cap on the socket. Tighten the front cover using included Torx
screws (g. 3.6.).
Using the syringe put the gel on the front of the head of coils and spread
it carefully on the whole surface using nger or so tool – g. 3.7 & 3.8.
1. Choose the adapter dedicated to the watermeter.
2. Install the adapter using included screws.
3. Instal the MacR6 N on the adapter using tack rivets (g. 4.3.).
ITRON adapter is also designed as the pipe holder using cable es –
g. 4.1 or wall holder using pegs – g. 4.2.
• MicroSIM card
• ITRON
• MADDALENA
• SENSUS
Fig. 4.1. Fig. 4.2.
Fig. 3.1.
Fig. 3.3. Fig. 3.4.
Fig. 3.2.
SIM
• ZENNER
Fig. 3.5. Fig. 3.6.
6.
Fig. 3.7 Fig. 3.8.
6.33

2
• 7 - eWebtel.com
installaon manual
MacR6 N
• 5 - Connecon with MacR6 N
• 6 - Conguraon parameters
1. Turn on the NFC on smartphone or tablet.
2. Close the smartphone to the MacR6 N, applicaon should start
automacally.
1. Take o the smartphone from MacR6 N aer nished readout.
2. Put in the watermeter data – pulse factor, counter value and serial
number. Addionally put the PIN to the SIM card. By clicking „More
parameters” you are able to set advanced values such as registraon
period, data server address, installaon phone number ( g. 6.1. & 6.2.).
1. Choose the GSM TEST opon, and then choose DP and ZD sending.
2. Close the smartphone to the MacR6 N and wait for conrmaon.
DEVICE IS CONFIGURED AND READY TO USE
There is no specic posion for phone placement. It depends on locaon
of NFC antenna inside the smartphone.
Fig. 6.1.
Fig. 7.1.
Fig. 6.2.
3. Save the conguraon using Save data buon as presented below.
4. Successful saving will be signed by the message below.
Now the callibraon process will begin. It is needed to have the water
ow during this process.
When callibraon is successful, MacR6 N will send a SMS with installaon
summary on the phone number set in 6.2 if it was programmed.
If the callibraon is unsuccessful, please repeat steps from 6 -
Conguraon parameters
Fig. 4.3.
x2
INSTALLATION
• DIEHL