Polestar 10800001P User manual

Wireless Remote Control Instructions
ITEM #10800001P
Polestar wireless remote works lets you operate your winch from up to 75 ft. without cables or switches. Just
press the remote transmitter and you're ready to operate your winch Start, stop, in or out.
◆Remote range up to 75 ft.
◆Transmitter equipped with long life.
◆Battery and power saver circuit.
◆Transmitter & receiver.
◆Visual indicator light shows remote operation.
◆Additional transmitters available to operate receiver.
◆Installs in minutes.
◆Transmitter replacement battery readily available.
WARNING: The Wireless Remote is designed for use on front mount self-recovery winches only. The remote is
not designed for and should not be used on winches or hoists in industrial applications (commercial car
haulers/carriers, wreckers, cranes, etc.) or for any other remote controlled applications.
Part List:
1. one transmitter.
2. one receiver with connector.
Installation and operating instructions:
female connector
solenoid control box
Transmitter Receiver
We suggest operate your winch as follows:
1. Disengage the clutch of your winch.
2. Pull out the winch wire rope about 1.5 meters.
3. Reengage the clutch of your winch.
4. Insert the plug of the receiver into the winches control box female connector
5. Put your receiver at a certain place.
6. Keep the antenna of receiver out and straight.
7. Pull out the antenna of transmitter, and move down the cover of your transmitter, bare out the
control button.
8. Press the button, you can operate your winch start, stop, in and out.
Trouble Solving:
SYMPTOM
POSSIBLE CAUSE
SUGGESTED ACTION
Motor turns,
but Winch
does not work,
Defective winch.
Check the winch Operating instructions.
Motor does not turn,
but you can hear
“Click” sound in the
receiver
Receiver Loose connections to the
winch.
Reinsert the wire.
Defective winch.
Check the winch Operating instructions.
Motor runs in one
direction only
Receiver Loose connections to the
winch.
Reinsert the wire.
Defective winch.
Check the winch Operating instructions.
No actions
Receiver and transmitter does not
matching.
return to the manufacture to rematch.

Battery replacement for transmitter:
Battery parameters: 12V23A battery capacity: 50mAh
Battery quantity：2 battery type：MN21
Battery sizes as below：
Way to replace battery：
A、Remove the screw from remote as below image;
B、Take out old batteries inside；
C install the new batteries inside；
Remark：
Please be aware the positive and negative of the battery