poly-planar IP-100 User manual

IP-100 IPod™Connection Kit
Installation Instructions
IMPORTANT! Before installing these components disconnect the Poly Planar MRD60 / MRD70 Power connection. This is the
white plastic 12 pin plug on the back of the radio. Reconnect when all work has been completed
IMPORTANT! These components are not waterproof. The control module must be mounted in a dry location.
GETTING STARTED:
Find a dry flat location within 12 inches of the radio to
attach the IP100 Module. This may be on the top of the
radio or panel.
Peel the adhesive back off the Velcro™ and attach to the
Module first then to the panel
Press firmly to adhere the Velcro™
Find the CD Changer plug on the back of the MRD60 /MRD70
Remove the rubber plug from the Radio connector and insert the DIN
connector on cable A as shown. Be sure to fully insert this plug. Connect
the 24pin connector to the Module
Insert the Round end of cable B into the Module. Connect the opposite
end to your IPod.
Operation:
With the radio on, use the source button to toggle to CD Changer.
If Display shows “No Disc Loaded” check connections
Following normal IPod protocol select a Playlist or Category
The IP100 will play up to 99 tracks from a Playlist or Category.
Use the Tune ^ (Up) or TUNE v (Down) to change tracks.
The IP100 charges the IPod battery whenever the unit is attached to the
system. Even when not using it as the source.
Scan, Random, Repeat and Pause functions are usable in this mode.
Check your radio Manual for more information on these functions.
A
A
B
Works with all IPods with
bottom multi pin connector
520 McCormick Drive, Suite F, Glen Burnie, MD 21061 Phone: [phone] Fax: [phone] www.polyplanar.com
iPod is a registered trademark of
Changer Plug
Rubber Cap
(Discard)
System Expansion Port
(MRD60 only)
Power and Speaker
Connection