Polywood J147 User manual

Model: J147
Qty. Description
__(1) Hardware pack
__(2) Sideframes
__(2) Rocker bottoms
__(1) Back insert
__(1) Seat insert
__(1) Seat frame
__(2) Long braces
__(1) Short brace
__(1) Head piece
HARDWAREISCOATEDSTAINLESSSTEELUNLESSOTHERWISESPECIFIED
TOOLS NEEDED
Step 2
Attach long braces, short brace, seat frame and back frame
to one of the sideframes using (7) .27x3 wafer screws.
Note: front of seat is wider
Step 3
Insert head piece into top of post
Repeat step 2 on other side
Step 1
Attach rocker bottoms to sideframes
using (4) .27x3 wafer screws.
9/12/2012
ASSEMBLY INSTRUCTIONS
2Finial w/dowel screw
NOTE: Partialy thread both screws
into post before tightening.
Rocker bottoms may require some
flexing for proper fit.
Long braces
Short Brace
Step 4
Attach finials to top of post
4mm Hex key for drill:
INCLUDED
4mm Hex Key, Allen, T-handle
(INCLUDED)
.27 X 3 SOCKET WAFER A
18

9/17/2012
ASSEMBLY INSTRUCTIONS
Step 1
Model: TWST, BST
Description
without pilot holes
Qty.
A screw gun is required
Phillips head screwdriver
__(1) Hardware pack
Uses (4) 8x3 screws
__(2) Leg assembly
by resting tray on the leg assemblies
8
TOOLS NEEDED
__(2) Trays
Attach a tray to the middle of the leg assemblies
Note:
Trays do not have pilot holes.
Screws go directly into Polywood
ALL HARDWARE IS COATED STAINLESS STEEL
A - 8 X 3 PHIL FLAT SCREW
Step 2
Attach other tray to the top of the leg
assemblies.
Uses (4) 8x3 screws