POOLEX Nano Instructions for use

Easy start
MANUAL
for your heat pump
Model Poolex Nano

Dear Customer,
Thank you for your purchase and for your condence in our products.
These are the result of many years of research in the eld of design and production
of heat pumps for swimming pools. Our aim is to provide you with an exceptional high
performance quality product.
We have produced this manual with the utmost care so that you get maximum benet
from your Poolex heat pump.
Thank you
PLEASE READ CAREFULLY
These installation instructions are an integral part of the product.
They must be given to the installer and retained by the user.
If the manual is lost, please consult the website:
www.poolex.fr
The instructions and recommendations contained in this manual should be read carefully and understood
since they provide valuable information concerning the heat pump’s safe handling and operation. Keep this
manual in an accessible place for easy future reference.
! !
Any contractual or non-contractual liability of the manufacturer/distributor shall be deemed null and
void for
damage caused by installation or operational errors, or due to non-compliance with the instructions
provided in this manual or with current installation norms applicable to the equipment covered by
this document.

1
3
4
2
When opening the package, please check that all elements are present with your heat pump :
1 Package contents
Heat pump Poolex Nano 2 hydraulic inlet/outlet
connectors 32/38mm
diameter
This installation and user manual Electrical socket with 10
mA di󰀨erential protection

Contents
Poolex Nano can be connected with direct connection.
For an above ground pool, your Nano must be connected after your ltration pump.
3 Hydrolic connection
Once your product has been unpacked, please check the
gas value of the manometer.
Value have to be between 100 - 300 psi.
If the value is Zero, stop the installation and contact
your dealer.
2 Gas pressure

WARNING :
Your ltration pump must deliver between
1300 up to 4000 L/h
for the heat pump to operate.
Below this ow, the heat pump will display an error
code E3.
TOWARDS THE POOL
FROM THE POOL
STEP 1 : Screw the connectors
to the heat pump
STEP 2 : Connect the water
outlet pipe and the water intake
pipe

6
Your heat pomp is equipped with a di󰀨erential protection. It is obligatory to check its operation
beafore each use.
The heat pump should not be used if the di󰀨erential protection test fails.
Connect socket to the electrical outlet Push the button “Reset”.
The indicator lights up
Push the Button “TEST”
The indicator lights o󰀨.
Press the reset button again. The indicator
lights up.
Di󰀨erential protection is working properly.
4 Electrical connection
2
3 4
1

7
Once connected electrically and hydraulically, you can switch on the heat pump by pressing
Select the desired temperature with or . It will be validated automatically after a few seconds and the
screen will return to the initial display.
5 commissioning
Current temperature Current temperature
Requested temperature
To verify that compressor is running, the compressor
needle must go up, this means that the compressor works,
and that the heat pump heats up.
6 commissioning
Under normal conditions, a suitable heat pump can heat the water in a swimming pool by 1°C to 2°C per
day. It is therefore quite normal to not feel any temperature di󰀨erence in the system when the heat pump is
working.
A heated pool must be covered to avoid any loss of heat.
7 Heating time

Technical SupporT
www.poolex.fr
Issued 01-2018
Poolex is a Poolstar Group trademark
www.poolstar.fr