Pop-A-Shot CLASSIC DUAL User manual

CLASSIC
SKU# PASCLAS19-01 WWW.POP-A-SHOT.NET

Required
Nylon head mallet (Not included) - for tapping corners
9/16” Wrench (Not included) - for installing rim
3/8” Drive ratchet (Not included)
Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list page.
Find a clean, level place to begin assembling your Pop-A-Shot game.
Like most things in life, putting together your Pop-A-Shot is better when done with a friend.
We hope you love your Pop-A-Shot and will let your friends and family (and any review sites)
know how you feel. If you do have a problem (and it happens), please let us know first and give us a chance to fix it.
Email: [email protected]
Read all instructions: All the safety and operating instructions should be read carefully before this
product is operated or played.
Caution: This is not a toy and is intended for use by or under the supervision of adults. Adults should
review safety guidelines with children to avoid possible risk of electric shock or other injuries.
Recommend:The game should be periodicallyexamined for conditions that may result in the risk of fire,
electrical shock or injury to persons. In the event such conditions exist, the game should not be used
until properly repaired.
Storage: This product is made from wood-based components and is sensitive toextreme temperatures
9/16” Deep Well Socket (Not included) - for installing rim
Recommended
Step ladder or stool
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 2/12

ALL FRAME TUBE PARTS ARE LABELED
1
6
T1
T2
T3
T4
F4
F6
F7
F3
F2
F1
F8
F5
B1
B3
B4
B2
R4
R5
R6
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 3/12
POP-A-SHOT CLASSIC
FRAME ASSEMBLY
Backboard
Assembly
S3
S2
S1
S4

Rim and Net Ramp and Netting Set
Backboard Assembly
PARTS LIST
Control Panel
1x
Bolt
4x
Nut
4x
Wing Nut
4x
Washer
4x
AC Adapter
1x
Balls
4x
Bungee Ball Cord
14x
Pump
1x
Leg With
Two-Way Joints
2x
Leg With
Four-Way Joints
4x 1x
1x
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 4/12
Inspect your box to make sure all parts are included

T1
T3
T4
T2
B1
B3
B4
B2
4-WAY JOINT
LEG
LEG
LEG
LEG
LEG
LEG
4-WAY JOINT
4-WAY JOINT
4-WAY JOINT
T-JOINT
T-JOINT
BOTTOM FRAME
STEP 1 TO BUILD BOTTOM FRAME
Connect B1 with B2, and B3 with B4 with Tee Joints.
Attach 4-Way Joints to each end of assembled bottom frames. Add Legs
to bottom frame.
Front
Connect F2 vertically into Four-Way Joint on B1.
Connect F3 vertically into Four-Way Joint on B3.
Connect F1 horizontally into Four-Way Joints on B1 and B3.
Rear
Connect R2 vertically into Four-Way Joint on B2.
Connect R3 vertically into Four-Way Joint on B4.
Connect R1 horizontally into Four-Way Joints on B2 and B4.
TAP CORNERS AS YOU BUILD FRAME
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 5/12
FRONT
REAR
F2
F3
F1
R2
R3
R1
COUPLER
B1
B3
B4
B2
TO BUILD TOP FRAME
Connect T1 with T2 and
connect T3 to T4.

STEP 2 TO BUILD FRONT FRAME
Connect F6 to F2 (Left Side), using Coupler.
Connect F7 to F3 (Right Side), using Coupler.
Slide F4 and F5 into holes in F2 and F3.
Connect 3-Way Elbows to top of F6 and F7.
Finish front frame with F8.
TAP CORNERS AS YOU BUILD FRAME
F4
F6
F7
F3
F2
F1
F8
F5
COUPLER
COUPLER
3-WAY ELBOW
3-WAY ELBOW
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 6/12

STEP 3 TO BUILD REAR FRAME
Connect R3 to R1. Connect R2 to R1. Connect R4 to R3 using Coupler.
Connect R5 to R2 using Coupler. Slide R6 in R4 and R5.
Connect S1, S2, S3 and S4 to the 45 degree elbows on the R4 and R5
of the back frame.
Attach Backboard Assembly.
TAP CORNERS AS YOU BUILD FRAME
ELBOW
ELBOW
Backboard Assembly
Backboard
Tubes
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 7/12
R5
R6
45˚ COUPLER
S3 S2
S1
S4

STEP 4 ADD TOP FRAME
Connect T1, T2, T3 and T4 to frame using 3-Way Elbows on the front and
single elbows on the rear.
3-WAY ELBOW
SINGLE ELBOW
TOP FRAME BARS
T1
T2
T3
T4
Use a step ladder for
safety, where possible.
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 8/12

STEP 5 Install Rim with hardware using the included Nuts and Bolts;
you will need a 9/16” Wrench, a 3/8” Drive Ratchet and a
9/16” Deep Well Socket (not included).
Note: Your sensor and scoreboard are pre-installed.
Please make sure the connections are secure.
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 9/12

STEP 6 Attach Ramp side net sets to frame. Bungee ball cords are included to
hold the ramp to the frame. Snap the Control Panel onto the Horizontal Bar
(F4). Thread the Control Panel wire through the hole in the laminated Game
Operations “Cheat Sheet” until the Cheat Sheet is next to the Control Panel
(See inset).
Take the Control Panel wire and weave it through the side netting towards
the back of the Backboard. Plug the Control Panel wire into the outlet
labeled “Control Panel” in the Scoreboard. Plug AC Adapter to the
Scoreboard and into a wall outlet. (Optional: You may use four- AA batteries
(not included)). Screw Wing Nuts to the Ring Tabs to hold the Ramp Net to
the Backboard.
VELCRO
VELCRO
VELCRO
RING TABS
TIE RING TABS WITH
BUNGEE BALL CORDS
YOU’RE READY TO PLAY!
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 10/12

CLASSIC POP-A-SHOT GAME OPERATION
Control Panel Operation
Audio Options
Now that you’ve put your Pop-A-Shot Classic together, let’s get started playing!
Turning on the game: Press ON/OFF to turn on your game.
Select Game: Press GAME to select one of the six games.
Audio: Press AUDIO to make audio selection.
Volume: Press VOLUME to turn volume up/down (it goes all the way in one direction
before going back to the other).
Note: After the end of each game, the all time high score for that game will be dis-
played. If you unplug your game or take out the batteries and want to preserve the
high score, make sure the other power supply is still working.
There are six dierent audio options. Select the audio option by pushing AUDIO until
you reach your selection (the number will be displayed on the scoreboard).
S1: Play-by-play announcer and Sound FX
S2: Sound FX only
S3: Electronic Music
S4: Rock Music
S5: Hip Hop Music
S6: No Sound
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 11/12

CLASSIC POP-A-SHOT GAME OPERATION
Game Options
Starting a game: Press START to start your game.
1. Standard Play
:30 on clock
Announcer and clock count down to start
Baskets are 2 points for 1st :20, then 3 points for final :10 and all bonus time
Bonus: :15 extra at 30 points; :10 extra at 60 points
2. Skeet Shooting
Announcers says “Shoot,” then you have :03 to make a basket
3. Double Or Nothing:
:30 on clock
First basket counts for 2 points, then each subsequent basket counts for double
If no basket is made within :03, next basket is 2 points
4. Overtime:
1:00 on clock
5. Sudden Death:
:15 on clock
6. Free Play:
All baskets count as 2 points
SKU# PASCLAS19-01
WWW.POP-A-SHOT.NET Pop-A-Shot Classic Page 12/12
© Copyright 2019 Pop-A-Shot