Porcher CALLA DEMI-APOTHECARY User manual

Recommended Tools & Materials
Roughing-in Dimensions | Demi-Apothecary
89871-00
Roughing-in Dimensions | Apothecary 89870-00
Phillips Screwdriver Regular Screwdriver
Drill
10'
Tape Measure
Level Hammer
FRONT SIDE FRONT SIDE
DOOR DOOR
DRAWER(S)
ADJUSTABLE
GLASS SHELF
MEND
PLATE
CALLA HUTCH
89872-00
DOOR
DRAWER(S)
DEMI
APOTHECARY
HUTCH
Units : Inches (mm)
- 1 -
SAVE THESE INSTRUCTIONS
770018-100 Rev.A
Product names listed herein are trademarks of Porcher
© Porcher 2010
INSTALLATION INSTRUCTIONS
CALLA DEMI-APOTHECARY
Model #89871-00
CALLA APOTHECARY
Model #89870-00
(Calla Apothecary consists of Calla Hutch 89872-00
and Demi-Apothecary 89871-00)
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
INTRODUCTION
Thank you for selecting our Porcher product. To ensure that your installation proceeds smoothly, read these instructions carefully before
you begin. Also, review the recommended tools and materials section. Carefully unpack and examine your new plumbing fixture.
To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing
furniture directly under windows.
ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE LOCAL PLUMBING
AND BUILDING CODES
37-7/8"
(962mm)
3-1/2"
(89mm)
22-1/8"
(562mm)
20-1/2"
(521mm)
5-1/4"
(133mm)
5-1/4"
(133mm)
5-1/4"
(133mm)
13-7/16"
(341mm)
1-1/2"
(38mm)
16-1/16"
(408mm)
13-5/8"
(347mm)
21-5/8"
(549mm) 21-5/8"
(549mm)
42-5/8"
(1083mm)
16-1/16"
(408mm)
22-1/8"
(562mm)
22-5/8"
(575mm)
16-5/16"
(415mm)
22-5/8"
(575mm)
16-5/16"
(415mm)
1-1/2"
(38mm)
3-1/2"
(89mm)
65-1/8"
(1654mm)
20-1/2"
(521mm) 15-1/8"
(384mm)
2-1/2"
(64mm)
21-5/8"
(549mm)
13-5/8"
(347mm)
5-1/4"
(133mm)
42-5/8"
(1083mm)
22-1/2"
(572mm)

(1) MENDING
PLATE ATTACHES
TO HUTCH
CALLA
HUTCH
89872-00
CALLA
DEMI-APOTHECARY
89871-00
(1) MENDING
PLATE ATTACHES
TO DEMI-APOTHECARY
POSITION CALLA HUTCH
ON TOP OF CALLA
DEMI-APOTHECARY AND
CENTER SIDE-TO-SIDE
FIGURE 1.0
Units : Inches (mm)
Care and Cleaning
Clean the product by using a soft, slightly damp cloth. Buff the product by using a soft dry cloth. When cleaning the mirror, spray the mirror with a
glass cleaner and wipe clean. Avoid using silicone cleaners and waxes.
Clean up excess water and spills immediately. Use a blotting rather than a wiping action. Water left over a long period of time will cause white spots in
the finish.
NOTE: Please note that some chemicals may damage the finish. Take care to avoid the following: iodine, hair dye, shaving cream,after shave lotion,
alcohol, perfume, Lestoil®, Lysol Tub and Tile Cleaner®, Lysol Spray Disinfectant®, Dow Disinfectant®, acetone, paint remover, Formula 409®, Tile-X®,
and Nair®.
770018-100 Rev.A
- 2 -
In the United States:
Porcher Inc.
P.O. Box 6820
Piscataway, New Jersey 08855
Attention: Customer Care
For residents of the United States,
warranty information may also be
obtained by calling the following
toll free number: [phone]
www.porcher-us.com
In Canada:
Porcher
5900 Avebury Rd.
Mississauga, Ontario
Canadá L5R 3M3
Toll Free: [phone]
In Mexico:
Porcher
Planta Santa Clara
Via Morelos #330
Santa Clara Coatitla
de Morelos 55540
Estado de Mexico, Mexico
PORCHER WOOD FURNITURE WARRANTY
If inspection of this Porcher plumbing product, within one year after its initial purchase, confirms that it is defective in materials or workmanship,
Porcher will repair or, at its option, exchange the product for a similar model. Variations in actual wood color and finishes which may result from
natural characteristics of the wood, such as grain patterns, mineral streaks and the like, are not defects and are not covered by this warranty.
This limited warranty applies only to the original purchaser and installation of these products. In the event of a claim, proof of purchase will be
required; save your receipt.
This limited warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of this product
should check with a local building or plumbing contractor to insure local code compliance before installation.
This limited warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance,
abuse, misuse, accident or other damages; if it was not installed in accordance with Porcher’s instructions; or if it has been modified in a manner
inconsistent with the product as shipped by Porcher.
Porcher’s option to repair or exchange the product under this limited warranty does not cover any labor or other costs of removal or installation, nor
shall Porcher be responsible for any other incidental or consequential damages attributable to a product defect or to the repair or exchange of a
defective product, all of which are expressly excluded from this limited warranty. This limited warranty does not cover any liability for consequential
or incidental damages, all of which are hereby expressly disclaimed, or the extension beyond the duration of this limited warranty of any implied
limited warranties, including those of merchantability or fitness for an intended purpose. (Some states or provinces do not allow the exclusion or
limitation of implied limited warranties, so this exclusion may not apply to you).
This limited warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or province to province, in
which case this limited warranty does not affect such statutory rights.
Installation Calla Demi-Apothecary 89871-00
Unpack the Calla Demi-Apothecary carefully, taking care that the bottom of the legs do not drop and cause damage.
Move the Demi-Apothecary into the desired location and level with the adjustable levellers located on the bottom of the base.
The levellers can be adjusted outward up to 3/4" but it is recommended not to exceed 1/2" if possible.
Installation Calla Apothecary 89870-00
Unpack the Calla Apothecary carefully, taking care that the bottom of the legs do not drop and cause damage.
Unpack the Calla Hutch carefully, taking care that bottom of unit does not drop and cause damage to the unit and glass. Keep the adjustable shelf removed
from the unit for now. NOTE: Metal Bracket provided will be required for this application. The Drilling Template will not be required ( used only when
Hutch is used in Wall Hung application).
Secure (1) Mending Plates to the back of the Calla Hutch as shown in FIGURE 1.0. Place the Calla Hutch onto the top of the Demi-Apothecary and center
the Calla Hutch side-to-side. Secure the Calla Hutch with screws provided through the mending plate into the back of the Demi-Apothecary.
Move the Apothecary assembly into the desired location and level with the adjustable levellers located on the bottom of the base.
The levellers can be adjusted outward up to 3/4" but it is recommended not to exceed 1/2" if possible. Insert glass in Hutch onto shelf clips.