Positron BRX-VDSL2-8 User manual

BRX-VDSL2-8
8-pair Sealed Enclosure
Quick Start Guide
WWW.POSITRONACCESS.COM
5101 Buchan Street, Suite 220, Montreal, QC H4P 2R9 Canada
USA Toll-free: 1-888-258-4669 Tel: [phone]
[email protected]
© Positron Access Solutions
Document 180-0172-001 R02

BRX-VDSL2-8 (8 pairs)
Summary Diagram of Typical Installation
DSLAM BRX-VDSL2-8
2-4 kft / 0.6-1.27 km from DSLAM (for 24 AWG / 0.51 mm equivalent gauge copper)
L1
Distance from DSLAM
L2
Distance to furthest CPE
Connecting the BRX-VDSL2-8
8 pairs from the CO
8 pairs to the
subscriber (CPE)
Shielded gel-lled
24 AWG / 0.51mm cable
IMPORTANT NOTE: The BRX-VDSL2-8 unit is powered from the Sealing Current found on a standard POTS pair.
The BRX-VDSL2-8 will not work on a dry pair (line with no sealing current). Each pair of the BRX-VDSL2-8 is powered
independently with each pair requiring the presence of the sealing DC Voltage for proper operation.
You can also use the BRX Power Injector when deploying the BRX-VDSL2-8 on dry pairs (no POTS service).
Grounding Lug
Step 1: Select the location where the BRX-VDSL2-8 will be
inserted using the BRX-VDSL2 Calculator for the longest loop.
Step 2: Connect the grounding lug of the unit to a proper ground
(usually available near the splice point).
Step 3: Insert a BRX-BYPASS-TEST module in slot 1 and ensure
that both switches are in BYPASS mode.
Step 4: Connect the rst two (2) pairs to be amplied to the
rst two (2) pairs of the BRX-VDSL2-8. Make sure to match the
DSLAM pair number to the CPE pair number.
Step 5: Test for continuity between the DSLAM pair and CPE
pair at the splice point. If the circuits are active, the LEDs on the
BRX-BYPASS-TEST module will be ON to conrm that the sealing
current is present on both lines. If either circuit is not active, the
continuity testing will conrm that the connections are reliable.
Step 6: Replace the BRX-BYPASS-TEST module with a
BRX-VDSL2-M module.
Step 7: The DSLAM and CPE will now retrain the circuit and bring
up the ADSL2+ / ADSL link with the amplied bandwidth. Note
that the performance may be limited (or capped) by a setting in
the DSLAM conguration.
Step 8: Repeat steps 3 to 7 for the other three (3) slots of the
BRX-VDSL2-8 enclosure.
Document 180-0172-001 R02
Slot
#
Channel
#
Line
#
Cable Pair
Colors
11 1 White / Blue
2 2 White / Orange
21 3 White / Green
2 4 White / Brown
31 5 Red / Blue
2 6 Red / Orange
41 7 Red / Green
2 8 Red / Brown
Mounting ange on both ends
of the sealed unit