POSMicro APG Flip Top User manual

QUESTIONS?
Ask the experts at POSMicro.com.
1.800.241.6264
Live Chat Now
[email protected]
Monday - Friday 6 AM to 5 PM Pacic Time
BULK DISCOUNTS
FREE SHIPPING*
SE HABLA
ESPAñOL
*Free ground shipping to the continental USA on orders over $100.
For Help Call
1.800.241.6264
APG Flip Top User
Manual
More information available at POSMicro.com

M-23G-096-01 Rev. D
Fliptop Cash Drawer
OPERATING & MAINTENANCE INSTRUCTIONS
Figure 1
GETTING STARTED
Prepare a location for the cash drawer. Recommendations for a suitable location include:
• A sturdy, level surface no less than the size of the cash drawer;
• Operating temperature from 20°F to 100°F (-7°C to 37°C);
• Non-condensing relative humidity from 20% to 80%.
LOCK FUNCTIONS (If applicable)
Two keys are included with each cash drawer for the manual lock. The key lock provides two
functions: manual open and electrically on-line. See Figure 2. The key may be removed in the
12 o’clock (Electrically On-Line) position only. To reduce the risk of damaging or breaking
the key, remove the key from the lock during normal operation.
Figure 2
MEDIA STORAGE
A media storage compartment integrated into the bottom of the till, may be accessed by
inserting media into the single slip slot on the front of the drawer.
Figure 3
REMOVING THE LOCKING TILL COVER
Insert the till cover key into the lock and rotate 90 degrees. Lift the lid.
PREVENTATIVE MAINTENANCE
Periodic application of lithium-based bearing grease onto the latch mechanism may
be required.
CAUTION: Breaking coin rolls on the money till may cause the plastic to fracture.
RECOMMENDED CASH DRAWER INSTALLATION
Refer to Figure 4 below. Install the Cash Drawer in an appropriate location. Secure the Cash
Drawer in place with 4 screws installed through the holes on the inside bottom of case. Screw
heads should be on the inside of the case and must not interfere with bottom of Till for the
Cash Drawer to operate properly.
Figure 4
Ø.188 [4.7]
SIZE OF
HOLES IN CASE
Ø.276 [7] SCREW HEAD
.102 [2.60] SCREW HEAD
RECOMMENDED SCREWS IS SELF TAPPING
ST3.5mm PHILLIPS PAN HEAD
.054 [1.38] MAX HEIGHT
OF SCREW HEAD FROM
CASE BOTTOM