pottery barn kids Elliott Twin Captain Quick setup guide

Date: 2016-MAR-22 Page 1 of 7
Rev:
pottery barn kids
Elliott Twin Captain Bed
www.potterybarnkids.com

Date: 2016-MAR-22 Page 2 of 7
Rev:
Important Safety Instructions:
•Please read all instructions carefully before assembling.
•For your safety, assembly by two or more adults is strongly recommended.
•Keep instructions for future use.
•Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
Pre-assembly:
•Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as
this will avoid damaging parts during assembly. The shipping box provides an ideal work surface.
•Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
•Use the parts and hardware lists below to identify and separate each of the pieces included.
•The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
•The use of power tools to aid in assembly is not recommended. Power tools can damage hardware and split
wood.
•Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the
bolts to misalign during assembly.
Parts Included:
(A) Headboard (1x)
(B) Footboard (1x)
(C) Guardrail (2x)
(D) Side Rail (2x)
(E) Storage Unit (1x)
(F) Back Panel (1x)
(G) Slat Roll (1x)
(H) Ladder (1x)
Hardware Included:
(I) Allen Key – 1x (J) Bolt M6x60mm – 4x
(K) Bolt M6x55mm – 12x
(L) Bolt M6 x 30mm – 15x
(M) Spring Washer – 31x
(N) Flat Washer – 31x
(O) Half-Moon Metal Block– 12x
(P) Wood Screw 4x30mm – 28x
Tools Required: Philips Screwdriver (Not included)

Date: 2016-MAR-22 Page 3 of 7
Rev:
Assembly Instruction Steps:
1. Remove the 3 drawers and set aside as shown below.
- Open the Drawers to its maximum opening
- Each drawer is equipped with 2 rubber stopper that prevents the drawer from being removed during normal
operation
- During assembly, the drawer can be removed with minor force as the rubber stoppers will bend to allow the
drawer to be removed
- When removing the drawer, it MUST be removed at a straight angle.
2. Detach the knob that is pre-installed inside the drawer box and attach it to the drawer front using the original
machine screws as shown below.
2x

Date: 2016-MAR-22 Page 4 of 7
Rev:
3. Assemble (A) and (B) to (D) by aligning pre-drill holes with wooden dowels as shown below.
*Note: Do not fully tighten bolts (K) at this time to leave flexibility.
4. Attach (C) to (A) and (B) by aligning pre-drill holes with wooden dowels as shown below.
*Note: Do not fully tighten bolts (K) at this time to leave flexibility.
(K) Bolt 8x
(M) Spring Washer 8x
(N) Flat Washer 8x
(O) Half-Moon Metal
Block 8x
(K) Bolt 4x
(M) Spring Washer 4x
(N) Flat Washer 4x
(O) Half-Moon Metal
Block 4x
4x
4x

Date: 2016-MAR-22 Page 5 of 7
Rev:
5. Attach (E) and (F) to (A) and (B) as shown below.
*Note: Do not fully tighten bolts before BOTH (E) and (F) are assembled. Check alignments before
tightening.
6. Insert (L), (M) and (N) to connect (D) & (F). Attach (H) to footboard as shown below.
(L) Bolt 12x
(M) Spring Washer 12x
(N) Flat Washer 12x
(J) Bolt 4x
(L) Bolt 3x
(M) Spring Washer 7x
(N) Flat Washer 7x
A
B
6x
4x
D
F

Date: 2016-MAR-22 Page 6 of 7
Rev:
7. Assemble (G) to bedframe as shown below.
8. Put the 3 drawers back.
- Insert the drawer by aligning the female runner and male runner as shown below.(See Fig. A)
- Bend the plastic stopper a bit before push drawer all the way in (See Fig.B)
*Note: It will require some force to get the drawer back into the Pedestal.
(P) Wood 28x
6x
28x
Fig. A
Fig. B

Date: 2016-MAR-22 Page 7 of 7
Rev:
9. Place the assembled trundle (assembly following AI and hardware shipped with the trundle) under the storage
bed.
Care Instructions:
•Dust often using a clean, soft, dry and lint-free cloth.
•Blot spills immediately and wipe with a clean, damp, cloth.
•We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
•Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
Thank you for your purchase
Stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181