Power Fist 8887424 User manual

V4.0 8887424
Please read and understand all instructions before use. Retain this manual for
future reference.
User Manual
29 in. Fire Pit with
Cooking Grill

8887424 29 in. Fire Pit with Cooking Grill V4.0
2 For technical questions call 1-800-665-8685
NOTE: Before beginning assembly of product, make sure all parts are
present. Compare parts with package content list and hardware contents. If
any part is missing or damaged, do not attempt to assemble the unit.
Contact customer service for replacement parts.
WARNINGS
1. DO NOT use this fire pit without reading this entire document and all
WARNINGS, cautions and instructions.
2. This item is for outdoor use only, and shall NOT be used in a building,
garage or any other enclosed area
3. DO NOT use this fire pit for indoor heating. TOXIC carbon monoxide fumes
can accumulate and cause asphyxiation or death
4. This fire pit is NOT for commercial use.
5. This fire pit is NOT to be operated by children.
6. This fire pit is NOT to be used in or on boats or recreational vehicles.
7. Always use in accordance with all applicable local, state and national codes.
Contact your local fire department for details on outdoor burning.
8. When using this fire pit, exercise the same precautions you would with any
open fire.
9. The use of alcohol, prescription or non-prescription drugs may impair the
consumer’s ability to properly assemble or safely operate this fire pit.
10. This fire pit is for use with dry, seasoned hardwood. It will burn hotter,
more completely and create less smoke.
11. DO NOT burn lump charcoal, manufactured logs, driftwood, trash, leaves,
papers, cardboard, plywood, painted or stained or pressure treated wood.
Avoid using softwoods such as pine or cedar that can throw sparks.
12. DO NOT alter this fire pit in any manner.
13. DO NOT use this fire pit until it is COMPLETELY assembled and all parts are
securely fastened and tightened.
29 in. Fire Pit with
Cooking Grill

V4.0 29 in. Fire Pit with Cooking Grill 8887424
Visit www.princessauto.com for more information 3
14. DO NOT store or use gasoline or other flammable vapors or liquids in the
vicinity of this or any other appliance.
15. DO NOT store or use an LP gas cylinder within 10 feet (3.05 m) of this fire
pit while it is in operation. The fire pit should be placed no closer than 24
inch from walls during use.
16. DO NOT use this fire pit near automobiles, trucks, vans or recreational
vehicles.
17. DO NOT use in an explosive atmosphere. Keep outdoor area clean and free
from combustible materials, gasoline and other flammable liquids.
18. DO NOT use this fire pit under an overhead or near any unprotected
combustible constructions. Avoid using near or under overhanging trees
and shrubs.
19. Always use this fire pit on a hard level non-combustible surface such as
concrete, rock or stone. An asphalt or blacktop surface may not be
acceptable for this purpose. DO NOT use on wooden decks.
20. Always empty this fire pit before each use.
21. DO NOT wear flammable or loose clothing when operating this fire pit.
22. DO NOT use in windy conditions.
23. DO NOT use gasoline, kerosene, diesel fuel, lighter fluid to start or relight
fires.
24. Keep all electrical cords away from a hot fire pit.
25. All surfaces of this fire pit are hot when in operation. To avoid burns, do
NOT touch fire pit until it has completely cooled unless you are wearing
protective gear (potholders, gloves, BBQ mittens, hot pads, etc.). Never
touch ashes to start or coals to see if they are hot.
26. DO NOT leave a lit fire pit unattended, especially around children and pets.
27. DO NOT attempt to move or store this fire pit until ashes and coals are
completely extinguished.
28. DO NOT remove ashes or coals until they are completely and extinguished.
29. Use heat-resistant gloves or hot pads when contacting handles.
30. Use long, sturdy fire pit tools when adding or moving logs.
31. DO NOT place wood directly into bottom of the fire pit. Place wood only on
the center of the fire bowl.
32. DO NOT overload the fire pit. DO NOT add additional firewood until the fire
burns down.

8887424 29 in. Fire Pit with Cooking Grill V4.0
4 For technical questions call 1-800-665-8685
NOTICE: If any portion of the bowl of this fire pit are glowing red, it is
overloaded.
33. DO NOT lean over this fire pit when lighting or when in use.
34. DO NOT place hot pit tools onto combustible surface such as grass,
wooden deck or furniture.
35. Avoid breathing smoke from the fire and avoid getting it into your eyes.
36. This fire pit should be thoroughly inspected and cleaned on a regular basis.
37. After a period of storage and/or non-use, check for signs of damage and
creosote build-up.DO NOT operate until necessary repairs and/or cleanup is
executed.
38. Death, serious injury or damage to property may occur if the above is not
followed exactly.
EXPLODED VIEW
Please check the contents of the packing to ensure all the parts are included.
PARTS LIST
A Swing Handle
B Lift Handle
C Cooking Grate
D L-Pin
E Table Panel
E1 Table Panel with Hole
F Fire Bowl
G Support Ring Section
H Leg
HARDWARE
I M6 x 14 Bolt
J M6 x 20 Bolt
K M6 Nut
L Wing Bolt

V4.0 29 in. Fire Pit with Cooking Grill 8887424
Visit www.princessauto.com for more information 5
ASSEMBLY INSTRUCTIONS
Tools Required
•Phillips Head Screwdriver
•Adjustable Open-end Wrench
1. Attach (4) legs (H) to fire bowl (F) with (12) M6 x 14 bolts (J)
2. Insert one support ring section (G) into another and attach the support ring
assembly to leg (H) with (4) M6 x 14 bolts (J) as illustrated. Repeat the
same procedure to install the other support ring sections (G).
NOTE: Keep all bolts loose during the assembly of this step until all parts
are installed into the correct position.
3. Secure (4) support ring sections (G) with (4) M6 x 14 bolts (J).
4. Insert (2) the pins on table panels (E) into the fixed brackets on the fire
bowl (F) as illustrated. Connect table panels (E) with (8) M6 x 20 bolts (L)
and (8) M6 nuts (M). Attach (4) wing nuts (N) to the fixed brackets on the
fire bowl (F) as illustrated.
NOTE: The hole on the table panel (E) should be placed right upon the pole
on the fire bowl (F).
5. Attach the lift handle (B) to cooking grid(C) with (2) M6*14bolts (J) as
illustrated. Attach the swing handle (A) to cooking grid (C) with (2) M6 x 14
(J) and (2) M6 nuts (M) as illustrated.
6. Insert the cooking grid (C) post into the table opening.
Insert L-pin (D) into the hole on the cooking grid securing the pole.
CARE & MAINTENANCE
LIGHTING
1. Make sure there is only a small amount of ash in the bottom of the bowl.
2. Place a layer of dry kindling or a natural fire-starter onto the center of the
fire bowl.
3. Place above that a layer of dry seasoned hardwood that is no more than 3/4
the length of the bowl diameter.
4. Use a match to light kindling or fire-starter.