
5a. Then place the
black loop around
the front base post
holder.
EASY SETUP & EASY TEARDOWN
INSTRUCTIONS
2. Open up middle hinge bracket of the
base frame until it locks on both sides.
1044/S001/S002/S005/S022 I (6X4-14X7) SOCCER GOAL
SOCCER
CHECK OUT OUR VIDEO INSTRUCTIONS AT:
WWW.POWERNETINC.NETPOWERNET,INC
1. 3.
2.
4.
WARNING:
•
Use adult supervision and follow
instructions when using and
setting up the net.
•
Frequent use and/or abuse will
eventually strain the net and will
cause breakage.
•
Keep fingers away from hinges
and joints.
•
This is not a toy, do not climb or
swing on net.
•
Don’t drag the net! Use two
people to move.
Out Work! Out Play!
4a. Insert one of the
lower fiberglass poles
into the back of the
frame.
5.
TIP: Best used when weighing down net
with PowerNet sandbags (not supplied).
6a. Standing by the front of the net,
on one side, slide sleeve up and hook
the white loop on the net around the
silver notch.
6.
7a. Stand on the outside of the frame by the
back poles.
7.
UPPER POLES
LOWER POLES
NOTE: Step 1c will extend the back base to
make it a rectangle. If you do NOT extend
the back base it will look like this:
IMPORTANT NOTE:
Near the middle hinge bracket, there are two designed bends
used to raise the frame off the ground for stability.
These are NOT damages!
NOTE: The back side of
the frame is where the
hinges meet and there
is no red sleeve.
NOTE: All four hinges should be locked
into place from steps 2 and 3.
6b. Then repeat 6a on the opposite
side with the second white front loop.
7b. While firmly holding the back pole and
net, hook the white loop on the net around
the sliver notch.
7c. Then repeat steps 7a & 7b on the opposite
side with the second white back loop.
PULL UP
1c. Slowly telescope the legs up on
one side of the frame until it locks.
1b. Then set one leg down
on the ground.
1d. Repeat steps 1a-1c on opposite side.
4b. Then insert the upper
fiberglass pole into the
lower fiberglass pole.
4c. Repeat steps 4a-4b
on opposite side’s back
pole.
5c. Slip one net
sleeve over one
fiberglass pole set.
5e. Repeat 5a-5d on
opposite side.
PARTS LIST
(1) NET
(1) BASE FRAME
(4) LOWER POLES
(4) UPPER POLES
(4) GROUND STAKES
(1) BAG
NOTE: Don’t pull post
all the way out of frame.
1a. Unwrap the net and place the
double hinge on the ground with
the net spread out away from you.
3b. Repeat 3a
on the opposite
side of the base
frame.
3a. Lift side frame of net
until the hinge locks and
place on the ground.
NOTE: Per step 1 the center is designed
to be raised & curved off the ground.
Don’t force the middle down!
LOAD
WARNING: In steps 6 & 7 don’t stand in direction of the pole’s load when bending. The
pole may snap back and cause injury.
LOAD
5d. Next insert it into
either side of the front
base.
5b. Insert the upper
pole into the lower
fiberglass pole for the
2 remaining sets.