12.
13.
14.
15.
16.
17.
18.
If you are using the appliance for the first time, you should:
a. Charge it fully before the first use. Then unplug the appliance from the USB cable.
b. Clean the exterior & interior of the appliance with water & detergent with a
non-abrasive sponge.
DO NOT use metal scouring pads.
DO NOT clean any part of the product in the dishwasher.
c. Assemble the rotor according to the instructions listed in the section below.
d. Before adding ingredients, make sure the blades are in place and are running
smoothly.
Make sure to remove any label or protective sheet which may prevent its proper
functioning.
DO NOT:
• overload the Blender jar;
• place the appliance in the microwave oven or refrigerator for freezing, so as to
avoid breaking or damaging it. The maximum temperature resistance of the
blender jar is 100 °C, and therefore the jar can be sterilised with boiling water;
• insert objects or body parts inside the protection cover of the appliance;
• use the appliance to process very hard ingredients such as coffee beans, soybeans,
rice, ice cubes or other frozen food;
• touch any detachable accessories such as the blades or the motor with your
fingers while the chopper is running, to avoid personal injury or damage to the
appliance;
• touch the blades, for they are VERY SHARP! Hold the cutter bar on the blades while
installing, removing or cleaning;
• use the appliance for more than 30 seconds without interruption. Let the
appliance rest for 2 minutes between processing cycles. After 3 processing cycles,
let the appliance cool down before the next use, so as to prolong it’s service life;
• leave the appliance unsupervised during operation.
Plug and unplug the USB cable with dry hands and hold it firmly. Always unplug
the USB cable to avoid overheating and avoid stretching it (DO NOT pull it, tug it or
use it to drag the appliance to which is connected). Before unplugging the
appliance, switch it off.
During operation, DO NOT touch the appliance with wet body parts.
DO NOT soak the main engine of the appliance in water or other liquids, wash it
under the tap, or let any liquid flow into the internal casing of the appliance to
prevent electric shock. In case of accidental fall in water, DO NOT try to take it out,
but first of all unplug immediately the USB cable from the socket.
Avoid placing the appliance or USB cable on abrasive or sharp surfaces or in
positions where it can be damaged easily.
Always remember to unplug the USB cable of the appliance after charging, before
storing, cleaning or performing any maintenance operation.
Avoid carrying out operations which are NOT specified in this manual (such as
disassembling and/or altering).
3
