INSTRUCTIONS
SWITCH
WIRELESS
CONTROLLER
Cancel M Button Functions:
Turn the Mode Switch at the back of the console to the middle to turn off M Button
function.
Normal Mode:
Shift the Mode Switch to the left (towards M2).
M1 for X, M2 for Y, M3 for B, M4 for A. ese functions cannot be adjusted.
Programming Mode:
Shift the Mode Switch to the right (towards M3).
M1 for ZR, M2 for R, M3 for L, and M4 for ZL. ese functions can be adjusted following
the below step:
Setting Method:
Press and hold the M button you would like to adjust and hold the + button, the LED
indicating light will flash quickly. en, release and press any one or several buttons to
be set (!/"/#/$/ A / B / X / Y / L / R / ZL / ZR / L3 / R3) the LED indicating light will
flash once for each input registered. Press the M button again to save the setting.
For example; press and hold the M1 and + buttons to begin programming (the indicator
flashes once). Press the A button and then press the M1 button again. Now the M1
button corresponds to A button function.
Clear M button function by holding the M1, M4 and - buttons simultaneously for 4
seconds. e LED indicator light will flash once to indicate setting have been restored to
default values.
10.Reset Controller Hardware
To reset the controller hardware, hold down the power button for 20 seconds.
e controller will first turn off, then the LED indicator lights will start to flash, then
begin to flash quickly. Once the LED indicator lights are flashing quickly the controller
has entered Bluetooth pairing mode and is ready to connect to a device.
