Premium PFV886MSS User manual

This product is for domestic use only
Use & care manual
Important safeguards
UPRIGHT FREEZER
PFV885MW
PFV886MSS
PFV887MB

T
I
250
115
60
Kg
R134a
46
595*661.5*1197.5
654*780*1309.5
MM
MM
PFV885MW/PFV886MSS/PFV887MB
2

3
INSTALLING YOUR FREEZER
User should take out the door handle in the plastic bag, and
install it into the door. Then take out the two handle stopples
and cover the installed screws with them. The handle stopple
and screw stopple in the plastic bag can be used when the user
wants the door to be opened from left.
UNPACKING YOUR FREEZER
WARNING: Use two or more people to move freezer.
Failure to do so can result in back or other injury.
·Remove tape and any labels from your freezer before
using(except the rating label).
To remove any remaining tape or glue, rub the area briskly
with your thumb.
Tape or glue residue can also be easily removed by rubbing
a small amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
·Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your freezer.
·When moving the freezer, do not tilt the freezer beyond 45°
from upright position.
CLEANING BEFORE USE：
After you remove all of the packaging materials, （especially
the foam between outside condenser and cabinet should be
removed）clean the inside of your freezer before using it.

4
SPACE REQUIREMENTS
WARNING: Keep flammable materials and vapors, such as
gasoline, away form freezer.
Failure to do so can result in death, explosion, fine or burns.
·To ensure proper ventilation for your freezer, allow for
200mm space on each side between walls, 100mm space
between back of your freezer and the wall, and 300mm space
between counter top and the roof or ceiling.
·If you are installing your freezer next to a fixed wall, leave
sufficient space on the hinge side to allow for the door to
swing open.
·Never install your freezer near heat source and direct sun
shins.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock.
Before you move your freezer into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Earthing Method
A 115 Volt /60 Hz AC only 10 ampere fused and properly
earthed electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided. Use a

5
receptacle which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
NOTE: Before performing any type of installation, disconnect
the freezer from the electrical source. When you are finished,
connect the freezer to the electrical source and reset the control
to the desired setting.
LEVELING
If the freezer is not leveled during installation. The doors may
not close or seal properly, causing cooling, frost, or moisture
problems. It is very important of the freezer to be level in
order to function properly.
To level your freezer you may either turn the level leg
clockwise to raise that side to the freezer or turn counter –
clockwise to lower that side.
NOTE: Having someone push against the top of the freezer take
some weight off the leveling leg. This makes it easier to adjust
the leveling leg.
USE OF THE APPLIANCE
To obtain the best possible results form your freezer, it is
important that you operate it properly.
Temperature Control
The temperature in the freezer is controlled by the thermostat
control knob.The thermostat control box is loaded in
compressor compartment.Turn the thermostat control knob up
or down to regulate the temperature inside the freezer. The
markings on control knob indicated the “MIN, MAX” for the

6
different temperature grades. The temperature decreases with
position MIN being the warmest and position MAX being the
coldest.
Set the control to position between “MIN” and “MAX” for
normal use, the exact postion is beyond the temperature in the
freezer, generally, it is in the middle.
Store Frozen Food
When using the freezer for the first time or after defrosting,
turn the temperature control to set MAX for at least two hours
before introducing the food to be stored.
All frozen food products you purchase should be placed in the
freezer as soon as possible to avoid the frozen food from
defrosting.
Storage recommendation printed on the packaging of frozen
food by the manufacturers should be always be followed.
Be careful that the drawer mustn’t mangle the freezer pipeline.
Freezing Fresh Food
Ensure that your freezing operations are carried out under the
most hygienic conditions as freezing alone does not sterilize
the food. It is advisable to freeze the food by packing it into
separate meal portions and not in bulk form. Never put hot or
even warm foodstuffs into the freezer. Prior to storing the
frozen food, pack it in plastic bags, aluminum sheets or
freezing containers and place into the freezer. See the data
sheet at the rear of this booklet for the maximum permissible
amount in kilograms of fresh food that can be frozen in any 24
hour period with a room temperature of 25℃. Never freeze
more than the maximum permissible.
Note: Never put bottled food or drinks in the freezer

7
compartment.
.For best performance, leave enough space in the freezer
compartment for air to circulate around the packages.
Defrosting
Remove the mains plug from the wall socket, open the door
and remove all the food to a cool place. Defrost using a plastic
scraper, or let the temperature rise naturally until the frost
melts. Then wipe away the remaining ice and water, after this
plug the freezer back into the mains supply.
Note: To avoid damaging the freezing compartment wall, do
not use any sharp objects to remove the frost or separate
the frozen food.
Cleaning your freezer
Before you start to clean your freezer remove the mains plug
from the power supply.
Use a clean sponge or soft and a mild detergent in warm water.
Do not use abrasive or harsh cleaners.
Hand wash, rinse and dry all surfaces thoroughly.
Do not use cleaning waxes, concentrated detergents, bleaches
or cleaners containing petroleum on plastics and rubber parts.
Never use paper towels, window sprays, scouring cleansers or
flammable fluids on plastic parts as these can scratch or
damage material.
Clean with a cloth soaked in this solution and then dry with a
soft cloth.
PROLONGED OFF PERIODS
If the freezer is not in use for a long period of time, proceed as

8
follows:
Disconnect the freezer from the main supply by removing the
plug from the wall socket.
Clean and dry the inside as instructed under the heading of
cleaning the freezer.
Leave the door open to prevent any unpleasant smells from
uilding up while the freezer is not in use.b
TROUBLESHOOTING
In case of malfunction, you can solve many common problems
easily.
Your freezer will not operate…Check if
-- The power supply cord is unplugged.
The doors will not close completely…Check if
-- The drawers are out of position.
-- The gaskets are dirty.
-
- The freezer is not level.
The freezer is noisy when running…Check if
-- Check the freezer is level and it is not in contact with
another appliance or kitchen furniture.
The freezer does not cool sufficiently…Check if
-- If the door has been opened too often, or it has been left
open for a while it will take time for the freezer to reach
its set temperature.
-- Check the airflow the rear of the freezer has not been
reduced due to insufficient clearance.
The following characteristics should not be looked upon as a
problem.

9
A gentle tricking sound caused by coolant flowing the pipe.
Compressor operating at high temperature.
WARNNING
--the appliance is not intended for use by young children or
infirm
persons without supervision.
-- young children should be supervised to ensure that they do
not play with the appliance
--This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
-- Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
-- Do not damage the refrigerant circuit.
-- Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommended by the
manufacturer.
-- The instructions shall state that the appliance has to be
unplugged after use and before carrying out user maintenance
on the appliance.
-- If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
REQUESTINGASSISTANCE OR SERVICE
If the problem is not due to one of the items listed in
Troubleshooting, Contact the dealer or authorized Service
Company.

10