Pro-Elec PELL0013 User manual

36 LED SOLAR MOTION SENSOR LIGHT
PELL0013
Please read these instructions carefully before use and retain for future reference.
• Avoid locations of high temperature or humidity.
• If the light output becomes less bright or ashes, recharge the batteries.
• Always remove the batteries if the light is not to be used for long periods.
• Only use the recommended specication rechargeable batteries.
IMPORTANT SAFETY INFORMATION
INSTALLATION
• Drill two holes the wall 150mm apart horizontally in the required location with regard
to any concealed wiring or pipework, use wall plugs if required and screw in two dome
head screws leaving the heads 4mm proud of the surface.
• It is recommended to install the light at about 2.5M or higher above ground.
• Set the function switch to either LOW/HIGH/AUTO mode.
• Locate the keyhole slots in the back of the light unit over the screw heads and ensure
the light is securely xed.

OPERATION
MAINTENANCE
SPECIFICATION
• When set to LOW and the ambient light is low it will light continuously at approx 60
lumen. No motion detection is active.
• When set to HIGH and the ambient light is low it will light continuously at approx 60
lumen, but when the sensor detects movement, it will switch to high brightness of
approx 320 lumen.
• If the sensor doesn’t detect movement after 12 seconds the light will return to low
brightness of approx 60 lumen.
• In AUTO mode the light will only illuminate when motion is detected at high brightness
of approx 320 lumen.
• When no further motion is detected, the light will
extinguish after 12 seconds.
NOTE: please allow up to 7 hours charging time on
initial operation.
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Power supply: 2×18650Li-ion (2400mAh) internally sealed
Solar Panel: Monocrystal silicon, 2W (5.5V, 370mA)
Time Delay: 12 sec (auto delay function)
Working time: 3-16hrs continuous light (7hrs charging time)
Material: PC, ABS
Light Source: 36×SMD2835 LEDs
Output power high/low modes: 320/60 lumen
Ambient light: <10LUX
Sensor distance: 0-10m
Sensor angle: 120°
Time delay: 12±2 sec (Auto-delay function)
Product weight: 550g
Product size H x W x D: 272×125×75mm
IP rating IP65
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China. PR2 9PP
Man Rev 1.0
10m