Pro-Ject Audio Systems power box ds User manual

INSTRUCTIONS FOR USE
Pro-Ject Power Box DS Amp

© Pro-Ject Audio Systems · Pro-Ject Power Box DS Amp · Revision 2015.7.21
2
Dear music lover,
Thank you for purchasing a Pro-Ject Audio Systems Power Box DS Amp.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit or possible misuse
Important notice
Safety instructions
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the device.
Never handle the device while your hands are wet or damp. Avoid letting liquids enter the device.
Never place any item containing liquid, such as a flower vase on or near the device. Never spill any
liquid on the device. Never place any naked flame sources, such as lighted candles on or near the device.
The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool or any
other similar conditions.
Using the product
Power Box DS Amp is designed to power Pro-Ject amplifiers which require a 2x48V DC power supply.
Make all connections whilst the Power Box DS Amp is switched off or disconnected from the mains.
Power Box DS Amp is designed for Amp Box DS, Amp Box DS mono (RS line power amplifiers also
will work). Interconnection cables are included in the packaging. Original power supply of the
amplifier is not needed.
Pro-Ject Power Box DS Amp can power one stereo amplifier or two mono amplifiers.
Connection of two stereo amplifiers can overload and damage the unit.
!
!
!
!

© Pro-Ject Audio Systems · Pro-Ject Power Box DS Amp · Revision 2015.7.21
3
Trigger connection
Power Box DS Amp is equipped with 12V trigger-out socket (jack 2.5mm) to turn on/off a Pro-Ject product with
trigger input socket.
Do not use the trigger output for any other connections for which it is not designed.
Main power switch
The toggle switch turns the unit on or off. The blue LED above the switch shows that the unit is switched on.
Technical specifications Pro-Ject Power Box DS Amp
Output voltage / current: 2x (2x48V) / 2,5A
Dimensions W x H x D: 203 x 72 x 207 mm
Weight: 4200 g
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons, release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright ©2015. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
!