Pro-Ject Audio Systems Pro-Ject Tube Box S User manual

INSTRUCTIONS FOR USE
Pro-Ject Tube Box S

© Audio Trade GmbH · Pro-Ject Tube Box S · Revision 2013.1.15
2
Dear music lover,
thank you for purchasing a PRO-JECT AUDIO phono amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
!
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
!
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply.
The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily
accessible at all times. Never handle the device, the power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.
Settings
Use the dip switches at the bottom of the unit to set input gain, input capacitance and input impedance.
Please set both channels equally.
To find out which type your cartridge is please consult the literature accompanying your cartridge.
The literature for cartridges should also specify the correct input impedance (low-output MC cartridges) and
the correct input capacitance (high-output MC and MM cartridges), into which the cartridge is designed to
work. If in doubt please consult your dealer.
!
To alter settings the unit must be disconnected from the power supply and the amplifier.
Examples of typical settings
Ortofon 2M Red (MM)
input gain 41dB, input capacitance 150pF, input impedance 47kohms
ON
12345678
41dB
2000R
100pF
200pF
1000R
100R
10R
51dB
Ortofon X5-MC (High-Output MC)
input gain 41dB, input capacitance 370pF, input impedance 47kohms
ON
12345678
41dB
2000R
100pF
200pF
1000R
100R
10R
51dB
Ortofon Rondo Red (Low-Output MC)
input gain 61dB, input capacitance *, input impedance 10ohms.
* Input capacitance is irrelevant for low-output MC cartridges
ON
12345678
41dB
2000R
100pF
200pF
1000R
100R
10R
51dB

© Audio Trade GmbH · Pro-Ject Tube Box S · Revision 2013.1.15
3
Input impedance / input capacitance – high-output MC and MM cartridges
ON
56
ON
56
50pF 150pF
ON
56
ON
56
270pF 370pF
ON
1
47k
234
+
ON
12345678
100pF
200pF
Input impedance – low-output MC cartridges
* Input capacitance is irrelevant for low-output MC cartridges
ON
100
ON ON
2k
ON
1
10
234
1k
1 2 341 2 341 2 34
ON
12345678
2000R
1000R
100R
10R
Input gain
ON
78
61dB
ON
78
ON
78
51dB 41dB
ON
12345678
41dB
51dB

© Audio Trade GmbH · Pro-Ject Tube Box S · Revision 2013.1.15
4
Connectors
Pro-Ject Audio Systems, Vienna, Austria
18V
!
Make all connections whilst the phono amplifier is disconnected from the power supply.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the
left channel black or white.
Do not connect the phono amplifiers output to a phono input (sometimes labelled gram, disc or RIAA)
on the amplifier.
Never use any other power supply than the one supplied with the unit.
Connecting the record player
Connect the tonearm signal lead to the In of the phono amplifier. The earthing wire may be connected to the
screw terminal if you encounter hum problems when using the record player.
Connection to the amplifier
Connect the Out of the phono amplifier to a line input (such as AUX, CD, Tuner, Tape or Video) on your
amplifier.
Mains power connection
Connect the low voltage plug from the power supply to the Power 18V "socket of the phono amplifier before
connecting the power supply to the mains.
Stand-By
The button on the front panel of the unit alternately turns the power on or returns it to standby mode. The blue
LED above the stand-by push button shows that the unit is switched on.

© Audio Trade GmbH · Pro-Ject Tube Box S · Revision 2013.1.15
5
Technical specifications Pro-Ject Tube Box S
ATypical for low output MC cartridges, Btypical for MM or high output MC cartridges
* Input capacitance is irrelevant for low-output MC cartridges
Tubes: 2 x ECC83 (12AX 7A)
Input impedance: 10ohms, 100ohms, 1kohm, 2kohms A
Input capacitance/impedance: 50pF, 150pF, 270pF and 370pF */47kohms B
Together with other input impedance settings without any influence!
Input gain: 41dB B / 51dB and 61dB A
Noise floor: 94dB (A weighted) at 41dB input gain
75dB (A weighted) at 51dB and 61dB input gain
THD: <0,01% at 41dB input gain
<0,05% at 51dB and 61dB input gain
RIAA-equalisation curve accuracy: 20Hz - 20kHz / max. 0,4dB
Subsonic filter: at 20Hz with 12dB/octave
Input: 1 pair RCA/phono sockets
Line-level output: 1 pair RCA/phono sockets
Outboard power supply: 18V/1.000mA DC, suitable for your country's mains supply
Power consumption: 470mA DC, <1W in standby
Dimensions W x H x D (D with sockets): 103 x 74 x 125 (137)mm
Weight: 810g without power supply
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between player and phono amplifier or amplifier. This could be due to a faulty plug,
broken wire or solder joint or simply loose plug/socket connection.
Strong hum:
No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop.
Output too quiet or too loud, or distorted:
Input gain incorrectly set - input overloading or insufficiently amplified.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only when the problem cannot be resolved there should the
unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright ©2012. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.