PROAIM P-GMBC-01 User manual

1
What’s In The Box
Please inspect the contents of your shipped package to ensure you have received everything that
is listed below.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright
statutes or in wring by the Publisher.
Gimbal Mount for DJI Ronin-S (P-GMBC-01)
Assem b l y M a n u a l
Big Weights: 4
Small Weights: 6
Weight plaorm
Weight Rods
Mounng Adapter
Outer Collar with screws
Inner collar with rubber
Spacer Set
Gimbal handle with
ghten knobs Allen key

2
 Insert Rubber Spacer Set into the inner collar,
then ghten it with the help of provided Allen
key.
Gimbal Mount Setup
 The outer collar comes with already aached
180 degree rotatable shanks.
Aach the outer collar outside the inner collar
as shown in the image.
 For your convenience, hold the collar with
your hand properly, match the holes, ghten
them with the provided Allen bolts using an
Allen key.
 Aach the gimbal handle to the collar via two
holes present on the collar sides and secure it
with the help of knobs.
 Loosen the knobs present on the weight
plaorm, Insert the weight rod into each hole,
and re-ghten the knobs to secure it.
 Insert the threaded weights into the holes
present on the weight rods. Using the same
approach, you can aach the remaining
weights to the already aached ones accord-
ing to your camera balancing.

3
 Insert the weight plaorm nto the Ronin-s
gimbal base/lower side & ghten it with the
help of screw driver.
 converter adaptor is also compactable with
12mm to 16mm vest diameter hole.
 Loosen the knob & mount the converter
adaptor onto the C-Stand.
 You have received 1/4’’ extra Bolt, according
to your Ronin thread compability.
 Insert the assembled collar into the adapter ,
aer that mount your camera.

4
YOUR PROAIM GIMBAL BRACE MOUNT FOR DJI RONIN-S, ZHIYUN CRANE 2 &
STABILIZER ARM VEST
ALL DRESSED UP AND READY TO GO!
Warranty: We oer one year warranty for our products from date of purchase. Within this period
of me, we will repair it without charge for labor or parts. Warranty doesn’t cover transportaon
costs nor does it cover a product subjected to misuse or accidental damage. Warranty repairs are
subjected to inspecon and evaluaon by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishan-
dling in transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than
our company.
Contact Us: In case of any kind of dissasfacon, please Contact us immediately and we promise
our utmost support and care unl you use our product.
(SHOWN WITH OPTIONAL ACCESSORIES)