PROception proCOM21TS User manual
,1 287
SUR0+'/
G%/2:12,6(
8+)35($03/,),(5
9P$'&6833/<
ce
p
tionPRO
8+)
0+]
)0
0+]
$1',,,'$
0+] &20021
32:(53$66
SUR&20 7
)0%$1',,, 8+)75 ,3/( ;(5
ceptionPRO
INSTALLATION INSTRUCTIONS
These passive products are used for combining or splitting signals with a minimum of insertion loss. The
units are fully-screened and simple to install. The use of F connectors ensure good screening and
allows use with a wide range of cable sizes.
Features
nLow in-band insertion loss.
nigh rejection of unwanted bands.
nIdeal for both digital and analogue applications.
nPower-pass to the higher or highest frequency band input.
nRobust diecast housings, suitable for outdoor (masthead) and indoor use.
Descriptions
proCOM21TS: This unit is a diplexer for combining or splitting signals in the F, V F and U F
terrestrial bands (5 854M z) with satellite IF band signals (950 2300M z). It features
exceptionally high isolation performance between the satellite and common ports in the terrestrial
frequency bands, allowing it to be used to combine a satellite LNB output with low-level terrestrial
aerial signals without degradation of the latter being caused by wideband noise from the LNB. A
power-pass path is provided between the common and satellite ports; this will also pass the
associated 22 k z and/or DiSEqC control signals.
proCOM31T: This unit is a 3-band combiner/splitter (triplexer) handling signals in Band II (FM radio),
Band III (DAB or TV) and Bands IV-V (U F TV). The U F port also passes signals in the return-path
band (5 30M z), and DC power.
The two units can be connected together to form a 4-band combiner or splitter by linking the common
port of the proCOM31T and the terrestrial port of the proCOM21TS (see example, Fig. 2).
Application examples
Figs. 1 6 illustrate a selection of common applications for these products.
Note: SCART and telephone connections have been omitted from some diagrams for clarity.
PD2011-9042-01
Page 4 Page 1
Proception Limited,
177-187 Rutland Road
SHEFFIELD
S3 9PT
United Kingdom
eb: http://www.proception.co.uk/
e-mail: [email protected]
Performance data given are typical unless otherwise stated. Proception Limited reserves the right to
change product designs and specifications without prior notice.
Fig. 1 Combining terrestrial aerial feeds, showing optional use of U F preamplifier.
proCOM31T
proOUT12C
Notes
1. £ 2.8 dB in band edge region 780 .. 854 MHz.
2. £ 5.5 dB in band edge region 950 .. 1100 MHz.
3. Applies o er 5 .. 854 MHz. Typical performance >60 dB.
4. ³ 23 dB in band edge region 950 .. 1100 MHz.
5. £ 0.7 dB in return-path band 5 .. 30 MHz.
Technical data proCOM family
ST12MOCorpT13MOCorp
troplairtserreTtropetilletaStropMFtropIIIdnaBtropFHU
)s(egnarycneuqerfgnitarepOzHM458..5zHM0032..059zHM801..5.78zHM032..471 zHM03..5
zHM28..074
ssolnoitresnI £Bd
5.1
1
£Bd5.2
2
£Bd2.1 £Bd5.1 £Bd5.1
5
dnablairtserretninoitalosI
³Bd05
3
dnabetilletasninoitalosI ³Bd3
4
)MF(IIdnaBninoitalosI³Bd2 ³Bd03
)VTroBAD(IIIdnaBninoitalosI
³Bd02 ³Bd03
dnabFHUninoitalosI
³Bd3 ³Bd33
tr
opnommocmorfssaprewoPoNseYoNoNseY
sgnitarssaprewoP.xamAm052ta.xamV02
epytrotcennoclangiS)42-910CEI(F-epyT
egn
arerutarepmetgnitarepOC°05+..02-
dradnatsCME)BssalC(1002:2-38005NESB
Freeview
U F
Band-Selective Combiner/Splitters
proCOM21TS
proCOM31T PROception
FMDAB
proPSU11C
DAB/FM
Tuner
proM D11L
Note: PSU can be omitted
if 5 V power available from
Freeview box or IDTV.
2-Year Guarantee
This guarantee covers failure of your PROception product resulting from manufacturing defect
within a period of 2 years from the date of supply to the end-user. This guarantee does not cover
damage to the product caused by abuse, tampering, defective installation or natural causes such
as lightning discharge. Repair or attempted repair, other than by the manufacturer, will render
this guarantee void. This guarantee does not affect a consumers statutory rights.
*Sky and Sky+ are registered trademarks of British Sky Broadcasting Group PLC.
Freevie is a registered trademark of DTV Services Ltd.
ceptionPRO
7(55(675,$/
0+] 0+]
6$7
&20021
SUR&2076
7(55(675,$/6$7',3/(;(5
32:(53$66
8+)
0+]
)0
0+]
%$1',,,'$%
0+] &20021
32:(53$66
SUR&207
)0%$1',,, 8+)75 ,3/( ;(5
ceptionPRO
ceptionPRO
7(55(675,$/
0+ ] 0+]
6$7
&20021
SUR&2076
7(5 5( 675 ,$/ 6 $7', 3/ (;(5
32:(53$66
8+)
0+]
)0
0+]
%$1',,,'$%
0+] &20021
32:(53$66
SUR&20 7
)0%$1',,, 8+)75 ,3/( ;(5
ceptionPRO
,1 287
SUR0+'/
G% / 2:12,6 (
8+) 35($0 3/, ),(5
9 P$'&6833/<
ceptionPRO
ceptionPRO
7(55(675,$/
0+ ] 0+]
6$7
&20021
SUR&2076
7(55(675,$/6$7',3/ (;(5
32:(53$66
8+)
0+]
)0
0+]
%$1',,,'$%
0+] &20021
32:(53$66
SUR&20 7
)0%$1',,, 8+)75 ,3/( ;(5
ceptionPRO
ceptionPRO
7(55(675,$/
0+ ] 0 +]
6$7
&20021
SUR&2076
7(55(675,$/6$7',3/ (;(5
32:(53$66
PROception
287 287 28 7 287
,1
32:(5
02 '(
9
P$
ceptionPRO
7(55(675,$/
0+] 0+]
6$7
&20021
SUR&2076
7(55(675,$/6$7',3/(;(5
32:(53$66
SUR 36$
3/8*,132:(581,7
cepti onPRO
,13879+]:
2873879P$
287
287
287
287
287
287
287
287 287 287
8+)
,1 '$%
$17
,1
)
$17
,1
SUR$ 03 ;
PROception
32:(5
2' (
32:(5
9
Page 3Page 2
Fixing
The units may be fixed to a mast using the cable tie supplied or screwed to a wall or other flat surface
through the two fixing holes provided in the rear part of the moulded cover. The cable tie fixing is
intended to support the weight of the combiner/splitter only; cables should be taped to the mast at
intervals of approximately 400 mm to ensure that their weight is adequately supported. or indoor use
the diecast module can be unclipped and mounted directly if desired. Do not leave a unit supported
only by its cabling.
Signal connections
To preserve R screening integrity the signal connections to the unit should be made using good quality
coaxial cable and connectors. This is particularly important with DTT to minimise the ingress of impulsive
electrical interference. The use of cable benchmarked under the CAI scheme is recommended. Crimp
connectors, used in accordance with the manufacturers instructions, will give the best results. The
importance of achieving sound braid connections cannot be over-stressed. ' ' connectors should always
be tightened with a spanner, not left finger-tight.
System equipotential bonding
Bonding (earth) terminals are provided on the castings for use where BS EN 60728-11 compliance is
necessary.
Fig. 4 Satellite and UH TV distribution to main TV and up to four remote rooms with remote control
of Sky box.
Fig. 2 Combining terrestrial and satellite feeds for a triplexed outlet plate.
proCOM21TS
Fig. 3 Application with proAMP multi-way amplifier to combine VH aerials and to add LNB feed(s)
to one or more outputs. A separate LNB output and proCOM21TS is required for each amplifier output
to be satellite-enabled.
proPSU11
Dish & LNB
UHMDAB
proCOM31T
preamplifier
(optional)
proOUT13
Fig. 6 Alternative VH , UH and satellite distribution system with UH return diplexed onto LNB cable.
UH MDAB proCOM31T
proAMP28R Mk 2
proCOM21TS
Dish & LNB
proOUT13
VH output
unused
*Sky Digibox
ANT IN
LNB
R OUT-2
R OUT-1
proSAT1EYE Mk 2
UH
M
DAB
proAMP310X
proCOM21TS Dish & Quad LNB
ANT IN
R OUT-2
R OUT-1
proSAT1EYE Mk 2
proOUT12C DAB/ M
Tuner
LNB 1
LNB 2
proOUT35RT
radio outlet in
main room
(if required)
Fig. 5 VH , UH and satellite distribution to main viewing location and up to ten rooms using
proAMP310X amplifier.
UH
proAMP104X or proMHD14R
proCOM21TS Dish & LNB
ANT IN
R OUT-2
R OUT-1 LNB IN proOUT24RT
(or proOUT35RT for Sky+)
VH output unused
proSAT1EYE Mk 2
proOUT11C
SAT 2 feed for
Sky+ (if required)
DAB/ M
tuner
ANT IN
R OUT-1 LNB IN
*Sky Digibox
*Sky receiver
power suppy for
preamplifier if required
UH MDAB proCOM31T
proAMP28R Mk 2
proCOM21TS Dish & LNB
proOUT13
*Sky Digibox ANT IN
LNB
R OUT-1
DAB/ M
Tuner
SAT 2 feed for
Sky+(if required)
proPSA123
*Sky
receiver
This manual suits for next models
1
Other PROception Cables And Connectors manuals
