process-informatik CONNECT Series User manual

Operation Quick Start Guide V1.3 (from FW-version V1.03) for
ONNE T
Remote access/machine access
without configuration/IT-knowledge
Voltage connection :
Voltage: 24 V DC ± 20%
Power: 9 54-CONNECT 2W (also with USB-powerbank/-powercord/PC)
9 54-CONNECT-HS 1,2W
9 54-CONNECT-LTE 12W
9 54-CONNECT-II 9W
9 54-CONNECT-II-LTE 19W
Anschlüsse:
Power supply 24V DC
Power ON
flashing: synchronisation with partner
permanently ON: connected with partner
to network (LAN A)
to PC (LAN B)
on: WIFI active
flashing: WIFI-communication running
Power supply via USB interface (only 9 54-CONNECT)

Antenna connection:
WIFI
LTE
First commissioning :
–CONNECT-device creates WLAN network with SSID "CONNECT WIFI"
–with active DHCP aster (laptop is auto atically assigned an IP address)
–Connect laptop to this WiFi network and open with
browser the webserver with IP: http://192.168.1.1:
or
LAN-cable in LAN_A-port and open browser webserver with IP: http://192.168.2.1:
internet configuration:
–CONNECT (uses the internet connection of the connected PC)

–Gateway (uses own ip-address for internet connection)
–LTE (Only with CONNECT-LTE/CONNECT-II-LTE, uses LTE for the internet connection)
eculiarity: The A N "internet" is standard for most providers, but can be changed
if necessary.
Insert the SIM card on the right side of the device as shown until there is a
slight click, then release the card (it is locked in place)
[Reverse to trigger, click until noise and let go => Card extends]
LTE-LED: flashing slowly : Searching network
permanent ON: Network found
flashing rapidly : communication

peripheral configuration:
–CONNECT + GATEWAY
–LTE (only for CONNECT-LTE/CONNECT- -LTE)
partner configuration:
Explanation of parameters:
device name: Device name (max. 15 characters)
device number: Device number (1-65535) for assigning the connection
(no double device numbers allowed, please note !)
router interface: nterface of the CONNECT to the nternet router
(depending on the nternet configuration, only sensible possible interfaces are
displayed )
PC interface: nterface of the CONNECT to the internet-compatible PC

Web interface (after first configuration):
Open the CONNECT web interface by clicking "http://192.168.1.1" in y ur br wser with an active WIFI-
c nnecti n. Or c nnect y ur PC t the in the first-c nfigurati n specified PC-interface using a LAN-cable and
enter "CONNECT" in the address-line f the br wser.
Click n the 3 stripes in the t p left t pen the device menu :
–Overview
–State
–C nfigurati n
–Firmware update
Menu verview ( verview f the device) :
The menu is divided int status and device list. Clicking n the respective area pens a c rresp nding wind w.
All ther menus are sh wn in this menu frame .
The status display sh ws parameters f the c nnecti n, err r messages and inf rmati n ab ut the c nnected
devices :
The Device list menu sh ws all devices available in y ur cl ud. Y u can als establish and end c nnecti ns t
the ther devices.

The status menu shows information about the IP / MAC addresses of the connection and information about the
device:
(menu item LTE-interface onl for CONNECT-LTE/CONNECT-II-LTE)
In the Configuration menu, the expert configuration will be carried out differentl from the quick commissioning
of the device. For example, ou can set the DHCP mode, set IP addresses, and carr out the basic configuration
of the device again.

LTE settings only with CONNECT-LTE/CONNECT-II-LTE
In the Firmware Update menu, the firmware of the CONNECT-de ice is updated.
To do this, download the current firmware file to your PC from the product page. With Browse you select this
file and accept it. The file name is displayed in the user interface for checking. By clicking Update firmware, the
firmware file is loaded into the de ice and burned to the flash memory after a positi e check. The de ice then
restarts.
You can find more about the product and the current de ice manual on the product page of the CONNECT-
de ice.

Under the web-address https://www.process-informatik.de are product specific
documentations or software-driver/-tools available to download.
If you have questions or suggestions about the product, please don’t hesitate to contact us.
Process-Informatik Entwicklungsgesellschaft mbH
Im Gewerbegebiet 1
DE-73116 Wäschenbeuren
[phone]
[email protected]
https://www.process-informatik.de
Copyright by PI 2020
9354-CONNECT
QR-Code Website:Menutree Website:
+ Products / docu / downloads
+ Hardware
+ Remote maintenance
+ S5
+ Internet
+ CONNECT
Please make sure to update your drivers before using our products.