Produal VVA Install guide

FITTING INSTRUCTION
VVA, VVN
V1.0 (15.1.2013)

1 (2)
Produal Oy Keltakalliontie 18, 48770 Kotka FINLAND Tel: [phone] / Fax: [phone] [email protected]i www.produal.com
By help of this document you can install VVA and VVN water leakage sensors properly.
VVA 1
Place the sensor on the floor as shown in the
picture. Make sure that between the floor
and the lower surface of the sensor remains
about 15 mm gap.
VVA 2
Place the sensor on the floor as shown in the
picture. Make sure that between the floor
and the lower surface of the sensor remains
about 3 mm gap.
VVA 3
Place the sensor on the floor (or correspond-
ing surface) as shown in the picture. Use
glue to attach the sensor. Make sure the
sensing surface is placed upward.

FITTING INSTRUCTION
VVA, VVN
2 (2)
Produal Oy Keltakalliontie 18, 48770 Kotka FINLAND Tel: [phone] / Fax: [phone] [email protected]i www.produal.com
VVN 1 & VVN 2
Attach the sensor on the side of the pipe as
shown in the picture. Use cable tie or tape.
Do not attach the sensor around the pipe,
because water condenses on the bottom
surface of the pipe. Sensor collects dirt
because it does not stay dry.