ProFlow PFEOS-OB2000 User manual

1
INSTALLATION MANUAL
Universal Oil Filter Bypass Adaptor
PFEOS-OB2000
WARNING: PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING. PROFLOW WILL NOT BE
RESPONSIBLE FOR ANY DAMAGE AS A RESULT OF THE INCORRECT INSTALLATION OF THIS
PRODUCT. IT IS RECOMMENDED THAT A QUALIFIED AUTOMOTIVE TECHNICIAN PERFORMS THIS
INSTALLATION.
This product is designed to sit where the standard oil filter was on the vehicle engine
block. This means that a separate remote oil filter head must be purchased to relocate
the oil filter. Both inlet/outlets are plumbed for AN8 ORB connections and there are 2x
1/8” NPT ports for accessories for reading oil pressure, etc. This is a universal product
with a variety of inserts provided to fit both imperial and metric oil filters.
TYPICAL INSTALLATION
1. Drain engine oil from vehicle following the factory service manual of the vehicle.
2. Clean out the billet remote oil block for any debris from the machining process.
3. Remove the vehicles factory oil filter.
4. Place the block off plate into the adaptor and screw in the coloured thread insert
of your choice (vehicle dependant). Do not screw this adaptor into the engine block
itself.
5. Take the assembled block adaptor (with or without the larger landing plate
depending on vehicle) and start screwing fit onto the engine block nipple.
6. Rotate the sandwich plate while fastening so the inlet/outlet is facing the correct
way for your plumbing. Torque the block-off cap to approximately 25 Nm.
7. Begin plumbing the block adaptor using the appropriate hose and fittings to the
engine side. The block adaptor is marked with inlet/outlet for your convenience.
Included Items
QTY
Oil Filter Sandwich Adaptor
1
Large Adaptor Landing Plate
1
Sandwich Plate Block Off
1
3/4”-16 Thread Insert (Gold)
1
13/16”-16 Thread Insert (Blue)
1
M18x1.5mm Thread Insert (Silver)
1
M20x1.5mm Thread Insert (Black)
1
M22x1.5mm Thread Insert (Green)
1

2
PROFLOW LIMITED WARRANTY
This product is warranted to be free from defects in materials and
workmanship for a period of one year from the original date of purchase.
EMAIL: [e-mail] PHONE: [phone]
8. Install a remote filter head with a new oil filter which is plumbed to the block
adaptor. A filter can be plumbed to this if the block off cap is removed and a
threaded insert is purchased separately.
9. Add new engine oil to the vehicle and start the engine to check for correct oil
pressure via a gauge.
WARNING: If no oil pressure is built-up within 5 seconds, turn the engine off
completely to avoid any internal component damage.
10.Let the engine idle for 5-10 minutes once oil pressure is established and check all
connections and components for oil leaks.
11.Turn the engine off and check the oil level dipstick. The dipstick may read low as
the new hose connections are filled up with oil. Add aditional fluid to the vehicle
as required.