ProGlove Mark 2 User manual

30 -150 cm
10 - 80 cm
mid range
standard range
PAIR
04
- for a smarter workforce
MARK 2 BLE HID
CHECK INSERT
TURN ON
REMOVE
SCAN
CHARGE
01 02
03
07
06
08
In case there is no Pairing Barcode label on end device:
scan this Pairing Barcode
Press and hold the trigger, scan Pairing Barcode label on end
device. Wait until MARK 2 blinks blue twice to indicate
successful pairing.
QUICKSTART GUIDE
PAIRING BARCODE
05
BLE
TIP: HANG IT UP
Hang up the Quickstart Guide to make it
available for quick information access.
MAKE SURE TO PAIR THE CORRECT DEVICES.

INTEGRATION GUIDE
BLE HID TIPPS
WEARABLES
Trigger located on the index
finger. Clip left or right.
Trigger located in the palm of the
hand. Clip left or right.
Trigger located on the index
finger. Clip left or right.
STANDARD PALM TRIGGER INDEX TRIGGER
S,M,LS,M,LIndustrie Größe
7-10
CONFIGURATION:
To congure the Barcode Settings,
Data Formatting and Device
Settings visit
cong.proglove.de
DEFAULT SETTINGS:
Barcode Sux: Enter (CR)
SECURITY AND CERTIFICATION:
EMC according to EN301489-1/-3
ETSI according to EN300220-2
Security according to IEC60950-1
BLE
NEED HELP?
 [email protected] (EU)
 [email protected] (US)
 0800 776 22 55 (inside germany)
[phone] (outside germany)
NOTE: THESE OPERATING SYSTEMS ARE COMPATIBLE
Pair MARK 2 via BLE HID with end devices running Windows 10, Google Android 4.4+ or
Apple iOS 11+.
TIP 1: ATTACH PAIRING BARCODE LABEL TO END DEVICE
Make sure the Pairing Barcode is easily accessible.
TIP 2: LABEL YOUR DEVICES
Attach labels to each pair of devices to make sure you can easily recognize the
corresponding devices.
TIP 3: DEACTIVATE THE BATTERY SAVING MODE ON YOUR END DEVICE
The end device will stay unlocked so the connection between MARK 2 and end device can
not be interrupted.
INFO: INTEGRATION GUIDE
Find more detailed initial setup instructions for MARK 2 BLE HID pairing (with an end
device) in the Integration Guide: support.proglove.com
FAQ: CONNECTION ISSUES
If you are unable to successfully pair MARK 2 with your end device try scanning the
Pairing Barcode again.
- for a smarter workforce